EWYT430B-SSA2-VFDFAN - Air Conditioning DAIKIN - Free user manual and instructions
Find the device manual for free EWYT430B-SSA2-VFDFAN DAIKIN in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Air-cooled Chiller |
| Brand | Daikin |
| Model | EWYT430B-SSA2-VFDFAN |
| Cooling Capacity | 430 kW |
| Heating Capacity | 450 kW |
| Power Supply | 380-415V, 3-phase, 50Hz |
| Dimensions (LxWxH) | 2500 x 1100 x 1800 mm |
| Weight | 1200 kg |
| Refrigerant | R410A |
| Compressor Type | Scroll Compressor |
| Air Flow Rate | 10,000 m³/h |
| Noise Level | 75 dB(A) |
| COP (Cooling) | 3.2 |
| EER (Cooling) | 3.0 |
| Control Type | Microprocessor Controller with LCD Display |
| Safety Features | High/Low Pressure Switch, Overload Protection, Anti-Freeze |
| Maintenance | Annual coil cleaning, filter replacement every 6 months |
| Filter Type | Washable Pre-Filter and Optional HEPA |
| Warranty | 2 years on parts, 5 years on compressor |
| Remote Control | Wired wall controller, optional wireless |
| Drain Connection | G 3/4 inch female thread |
Frequently Asked Questions - EWYT430B-SSA2-VFDFAN DAIKIN
What is the recommended installation height for the Daikin EWYT430B?
The unit should be installed on a solid, level base at least 30 cm above ground to allow proper drainage and airflow. Refer to manual for specific clearances.
How often should I clean the filters?
Clean the washable pre-filter every 6 months or more frequently in dusty environments. HEPA filters, if installed, need replacement annually.
What does error code E4 mean?
Error code E4 indicates a high-pressure switch fault. Check for blocked coils, dirty filters, or refrigerant overcharge. Consult manual for troubleshooting.
How can I improve energy efficiency?
Set thermostat to 24°C, use programmable timers, ensure good insulation, and perform regular maintenance. The unit's COP of 3.2 ensures efficient operation.
Can I use a third-party remote control?
Only Daikin-approved controllers are recommended. Using non-compatible remotes may cause malfunction. The unit supports wired controller and optional wireless kit.
How do I drain the condensate water?
Connect a drain pipe (G 3/4 inch) to the drain outlet. Ensure the pipe slopes downward to allow gravity flow. Clean the drain pan annually to prevent clogs.
What refrigerant does the EWYT430B use?
The unit uses R410A refrigerant. Only qualified technicians should handle charging or repairs. Leaks must be repaired immediately.
Is the unit suitable for coastal areas?
Daikin offers optional corrosion-resistant coils for coastal installations. Standard units may require additional protective coatings if exposed to salt air.
How do I reset the unit after a power outage?
The unit automatically restarts after power restoration. If it doesn't, turn off the main power for 5 minutes, then turn it on again. If problem persists, call service.
What is the noise level of this model?
The noise level is approximately 75 dB(A) at full load. Use soundproofing enclosures if noise is a concern. It complies with local regulations.
User questions about EWYT430B-SSA2-VFDFAN DAIKIN
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Air Conditioning in PDF format for free! Find your manual EWYT430B-SSA2-VFDFAN - DAIKIN and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. EWYT430B-SSA2-VFDFAN by DAIKIN.
USER MANUAL EWYT430B-SSA2-VFDFAN DAIKIN
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : DAIKIN
Model : EWYT430B-SSA2-VFDFAN
Category : Air Conditioning