Telios Plus TTE2407 019 - Vacuum Cleaner HOOVER - Free user manual and instructions
Find the device manual for free Telios Plus TTE2407 019 HOOVER in PDF.
| Product Type | Upright Vacuum Cleaner |
| Model | Telios Plus TTE2407 019 |
| Brand | Hoover |
| Dimensions (L x W x H) | 30 x 28 x 45 cm |
| Weight | 5.2 kg |
| Power Consumption | 800 W |
| Dust Capacity | 2.5 L |
| Bagless | Yes, cyclone technology |
| Filter Type | HEPA washable |
| Cord Length | 6 m |
| Noise Level | 78 dB |
| Suction Control | Electronic, 3 settings |
| Floor Type | Hard floors and carpets |
| Accessories Included | Crevice tool, dusting brush, upholstery nozzle |
| Handheld Mode | Yes, detachable canister |
| Washable Dust Cup | Yes |
| Maintenance | Clean filter every 3 months, empty dust cup after each use |
| Safety Features | Thermal protection, automatic shut-off when overheating |
| Spare Parts Availability | Filters and accessories available online |
| Warranty | 2 years |
Frequently Asked Questions - Telios Plus TTE2407 019 HOOVER
User questions about Telios Plus TTE2407 019 HOOVER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Vacuum Cleaner in PDF format for free! Find your manual Telios Plus TTE2407 019 - HOOVER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. Telios Plus TTE2407 019 by HOOVER.
USER MANUAL Telios Plus TTE2407 019 HOOVER
This cleaner should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance. Use only attachments recommended or supplied by Hoover.
WARNING: Electricity can be extremely dangerous. This appliance is double insulated and must not be earthed. This plug is fitted with a 13 amp fuse (UK only).
IMPORTANT: The wires in the mains power lead are coloured in accordance with the following code: Blue - Neutral, Brown - Live.
STATIC ELECTRICITY: Some carpets can cause a small build up of static electricity. Any static discharge is not hazardous to health.
AFTER USE: Switch the cleaner off and remove the plug from the electricity supply. Always switch off and remove the plug before cleaning the appliance or attempting any maintenance task.
SAFETY WITH CHILDREN, ELDERLY OR THE INFIRM: Do not let children play with the appliance or its controls. Please supervise the use of the appliance by older children, the elderly or the infirm.
HOOVER SERVICE: To ensure the continued safe and efficient operation of this appliance we recommend that any servicing or repairs are only carried out by an authorised Hoover service engineer.
IT IS IMPORTANT THAT YOU DO NOT:
Position the cleaner above you when cleaning the stairs.
Use your cleaner out of doors or on any wet surface or for wet pick up.
Pick up hard or sharp objects, matches, hot ashes, cigarette ends or other similar items.
Spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours as this may cause risk of fire / explosion.
Run over the power cord when using your cleaner or remove the plug by pulling on the power cord.
Stand on or wrap the power cord around arms or legs when using the cleaner. Use the appliance to clean people or animals.
Continue to use your cleaner if it appears to be faulty. If the power cord is damaged stop using the cleaner IMMEDIATELY. To avoid a safety hazard, an authorised Hoover service engineer must replace the power cord.
GETTING TO KNOW YOUR CLEANER
A. Cleaner main body B. On/Off Button C. Cord Rewind Button D. Variable Power Control* E. Bag Check Indicator F. Bag Door Release Latch G. Bag Door H. Pre-motor Filter I. Exhaust Filter J. Exhaust Filter Cover K. Accessories door L. Hose Handle M. Suction Regulator® N. Hose O. Telescopic Tube* P. Telescopic Tube Adjuster* Q. Carpet and Floor nozzle** R. Floor type selector S. Crevice Tool T. Furniture Nozzle U. Dusting Brush V. Pet Hair Remover Mini Turbo Nozzle® W. Allergy Remover Mini Turbo Nozzle* X. Grand Turbo Nozzle* Y. Hard Floor Caresse Nozzle*

ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
Connect the hose to the cleaner main body, ensuring it clips and locks into position. To release the hose: simply press the two latches on the hose end and pull. [2] Connect the handle to the upper tube end.
- Connect the tube lower end to the carpet and floor nozzle**. [4]
*Certain Models Only **Nozzles may vary according to model
1




GB
USING YOUR CLEANER
Extract Power Cord and plug it into the power supply. Do not pull the cord beyond the red marker. [5]
- Adjust the Telescopic Tube® to the desired height by moving the Telescopic Tube Adjusters® up and raise or lower the handle to the most comfortable cleaning position. [6]
- Carpet and Floor Nozzle**: Press the floor type selector pedal on the nozzle [7] to select the ideal cleaning mode for the floor type. Hard Floor – Brushes are lowered to protect the floor. Carpet – Brushes are raised for the deepest clean.
- Switch the cleaner on by pressing the On/Off button on the cleaner main body. [8]
- Slide the Variable Power Control* to increase or decrease the suction. [9]
- Adjust the suction regulator* to the desired level. [10]
- Switch off at the end of use by pressing the On/Off button. Unplug and press the Cord Rewind Button to wind the power cord back into the cleaner. [11]
- Parking and Storage - The tube can be parked for temporary storage [12] while in use, or in the storage position when not in use. [13]

CLEANER MAINTENANCE
Replacing the Dust Bag
If the Bag Check Indicator is red please check and if necessary, replace the dust bag.
- Lift the bag door release latch [14] to open the bag door, close the bag to avoid dust escaping by pulling the tongue and remove the bag. [15]. The full dust bag should be disposed of correctly and carefully.
Fold a new bag as shown on the bag and fit by inserting the collar into the bag holder 2. [16].
Close the bag door.3. Remember: The bag check indicator may be red if an obstruction has occurred. In this case, refer to 'Removing a Blockage From the System'.
*Certain Models Only
**Nozzles may vary according to model

Cleaning the Filter
To maintain optimum performance of your cleaner, please wash the pre-motor filter and exhaust filter after each 5 bag changes.
Cleaning the pre-motor filter:
- Lift the Bag Door Release latch [14] to open the bag door and remove the bag. [15] To remove the pre-motor filter, slide the pre-motor filter frame from the cleaner. 2. [17] Remove the filter from the holder. 3. [18]
- Wash it in hand warm water, [19] and allow it to dry thoroughly before replacing it in the cleaner.
Cleaning the exhaust filter:
- To remove the exhaust filter, unclip the exhaust filter cover [20] and remove the exhaust filter pack. [21]
- Wash the filter in hand warm water [19] and allow it to dry thoroughly before replacing in the cleaner.
Remember: Do not use hot water or detergents. In the unlikely event of the filters becoming damaged, fit a genuine Hoover replacement. Do not try and use the product without a dust bag or filter fitted.
Cleaning the permanent cloth dust bag*:
To maintain optimum performance we recommend that you wash the permanent cloth dust bag under hand warm water after every 5 full bags. Remove excess water and leave to dry fully before replacing.
Removing a Blockage From The System
If the Bag Check Indicator is red:
- Check if the bag is full. If so refer to 'Replacing The Dust Bag'.
- If it is not full, then;
A. Do the filters need cleaning? If so, refer to 'Cleaning the Filter'. B. Check if there is any other blockage in the system - Use a rod or a pole to remove any blockage from the Telescopic Tube or flexible hose.
Warning*: The bag check indicator will remain red if the cleaner is used when the bag is full, if there is a blockage, or if the filters are dirty. If used for a period over ten minutes with the bag check indicator red, an electronic cut out will switch the cleaner off to prevent any risk of overheating. If this should happen, switch the cleaner off, unplug it, and correct the fault (see 'Removing a blockage'). The cut out will automatically reset upon switching the cleaner back on.




ACCESSORIES AND NOZZLES
The Crevice tool, Furniture nozzle, and Dusting brush are stored on board under the accessories door. [22]
All accessories can be fitted to the end of the handle or the end of the Telescopic Tube.
Crevice Tool – For corners and hard-to-reach areas. [23]
Furniture Nozzle - For soft furniture and fabrics. [24]
Dusting Brush – For bookshelves, frames, keyboards, etc. [25]
Pet Hair Remover Turbo Nozzle - Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard-to-clean areas. Particularly suitable for pet hair removal. [1V]
Allergen Remover Mini Turbo Nozzle - Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard-to-clean areas. Particularly suitable for allergen removal. [1W]
Grand Turbo Nozzle - Use the Grand Turbo Nozzle for deep cleaning on carpets. [1X] Hard Floor Caresse Nozzle - For parquet floors and other delicate floors. [1Y]
IMPORTANT: Do not use the Grand Turbo Nozzle on rugs with long fringes, animal hides, or carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.

USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service.
- Is there a working electricity supply to the cleaner? Please check with another electrical appliance.
Is the dust bag over-filled? Please refer to 'Cleaner Maintenance'.
Is the filter blocked? Please refer to 'Cleaner Maintenance'.
Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system'.
Has the cleaner overheated? If so, it will take approximately 45 minutes for the cut out to automatically reset.
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
Consumables:
Paper Bag: H30S - 09178278
Hepa Bag: H60 - 35600392.
Pre-Motor Filter:
Hepa Exhaust Filter:
S114 - 35601288
T108 - 35601289
Spares:
Carpet and Floor Nozzle:
- Caresse Nozzle:
- Mini Turbo Nozzle:
- Flexible Hose:
G85 - 35600545.
G89PC - 35600659
J51-35601163
D136 - 35601290
Quality
Hoover's factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001.
The Environment:
This appliance is marked according to the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the appliance collection point for recycling of electrical and electronic equipment. Disposal must be carried out in accordance with the local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee. Subject to change without notice.
*Certain Models Only
**Nozzles may vary according to model
3



