1970 - Uncategorized DRAWMER - Free user manual and instructions
Find the device manual for free 1970 DRAWMER in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Stereo Compressor/Limiter |
| Brand | Drawmer |
| Model | 1970 |
| Form Factor | 19-inch rackmount, 1U |
| Dimensions (W x H x D) | 483 x 44 x 200 mm |
| Weight | 4.5 kg |
| Power Supply | Internal, 100-240 V AC, 50/60 Hz |
| Power Consumption | 30 W |
| Input Connections | XLR and 1/4" TRS (balanced/unbalanced) |
| Output Connections | XLR and 1/4" TRS (balanced/unbalanced) |
| Frequency Response | 20 Hz – 20 kHz ± 0.5 dB |
| Dynamic Range | > 110 dB |
| Threshold Range | -40 dB to +20 dB |
| Ratio Range | 1:1 to ∞:1 |
| Attack Time | 0.1 ms to 50 ms |
| Release Time | 50 ms to 2 s |
| Makeup Gain | 0 dB to +20 dB |
| Sidechain Function | Yes, with external insert |
| Bypass | True hardwire bypass |
| Operating Temperature | 0°C to 40°C |
| Cleaning Instructions | Use a dry, soft cloth. Avoid solvents. |
| Safety Precautions | Do not expose to moisture. Use proper voltage. |
| Spare Parts / Repairability | Contact authorized service center for parts. |
| Country of Origin | United Kingdom |
Frequently Asked Questions - 1970 DRAWMER
How do I connect the Drawmer 1970 to my audio interface?
Use balanced XLR or TRS cables. Connect outputs of your interface to the inputs of the 1970, and its outputs to your monitoring system or recorder.
What is the recommended threshold for vocals?
Start with a threshold around -20 dB and adjust based on gain reduction. Aim for 2-6 dB of compression.
Can I use the sidechain function for de-essing?
Yes. Connect an external EQ to the sidechain insert to filter out sibilant frequencies. The compressor will then react less to those frequencies.
How do I bypass the compressor?
Press the Bypass switch. The unit will route the signal directly without compression.
What is the difference between peak and RMS detection?
Peak detects signal peaks for limiting, while RMS reacts to average loudness. The 1970 uses a combination; consult the manual for specifics.
Why is the unit not powering on?
Check the power cable connection and ensure the mains voltage matches the unit's rating. Verify the fuse is intact.
How do I clean the front panel?
Use a soft, dry cloth. Do not use liquids or abrasive cleaners to avoid damaging the surface.
Can I stereo-link two units?
Yes. The 1970 has a stereo link option. Connect a cable between the link jacks of both units; set one as master.
What is the maximum input level?
The maximum input level is +24 dBu before clipping. Ensure your source does not exceed this.
Where can I find the serial number?
The serial number is located on the rear panel next to the power inlet.
User questions about 1970 DRAWMER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Uncategorized in PDF format for free! Find your manual 1970 - DRAWMER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 1970 by DRAWMER.
USER MANUAL 1970 DRAWMER
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : DRAWMER
Model : 1970
Category : Uncategorized