MS 192 TC - Saw STIHL - Free user manual and instructions
Find the device manual for free MS 192 TC STIHL in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Chainsaw |
| Brand | STIHL |
| Model | MS 192 TC |
| Engine Displacement | 30.1 cc |
| Power Output | 1.4 kW (1.9 hp) |
| Weight (without bar and chain) | 3.5 kg |
| Recommended Bar Length | 12 to 14 inches (30-35 cm) |
| Fuel Tank Capacity | 0.25 L |
| Oil Tank Capacity | 0.22 L |
| Chain Pitch | 3/8 inch (9.3 mm) |
| Chain Gauge | 0.043 inch (1.1 mm) |
| Idle Speed | 2800 rpm |
| Maximum Engine Speed | 13,500 rpm |
| Carburetor Type | Zama C1Q-S |
| Ignition System | Electronic |
| Spark Plug | NGK BPMR7A |
| Chain Brake | Yes, inertia-activated |
| Side Chain Tensioner | Yes |
| Fuel Mix Ratio | 50:1 (STIHL HP Ultra or equivalent) |
| Vibration Level (front/rear handle) | 4.7 m/s² / 5.8 m/s² |
| Sound Pressure Level | 95 dB(A) |
| Sound Power Level | 108 dB(A) |
Frequently Asked Questions - MS 192 TC STIHL
What is the fuel mixture for the STIHL MS 192 TC?
Use a 50:1 ratio of STIHL HP Ultra two-stroke oil or a high-quality synthetic oil with unleaded gasoline (min. 89 octane). Never use old or dirty fuel.
How do I adjust the chain tension on the MS 192 TC?
Loosen the bar nuts slightly, turn the side chain tensioner screw clockwise to tighten the chain until it snugly contacts the bar bottom, then retighten the nuts. The chain should still pull freely.
What is the correct starting procedure?
Set the master control lever to the cold start position, pull the starter rope gently until resistance is felt, then give a strong pull. After starting, set the lever to run and allow the engine to warm up.
Why does my chainsaw stall when idling?
Check the air filter for dirt, ensure the spark plug is clean and gapped correctly, and adjust the idle speed screw if needed. Also verify the fuel mix is fresh.
How often should I clean or replace the air filter?
Clean the air filter after every 10 hours of use or more frequently in dusty conditions. Replace it after 100 hours or if damaged.
What type of chain oil should I use?
Use a high-quality biodegradable chain oil (STIHL BioPlus or equivalent). Never use waste oil or heavy gear oil.
How do I sharpen the chain?
Use a round file (4.0 mm for 3/8 pitch) at a 30° top plate angle and 10° side plate angle. File each cutter evenly; both cutters and depth gauges must be maintained.
What is the recommended bar length?
The MS 192 TC is designed for bars of 12 to 14 inches (30–35 cm). Using longer bars may reduce cutting efficiency and increase wear.
Why won't my chainsaw start?
Check that the master control lever is in the correct position, the spark plug is firing, fuel is fresh, and the air filter is clean. Also ensure the chain brake is disengaged.
How do I store the chainsaw for winter?
Drain the fuel tank and run the engine until it stops, then remove the spark plug and add a teaspoon of oil to the cylinder. Pull the starter slowly to distribute oil, store in a dry, clean place.
User questions about MS 192 TC STIHL
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Saw in PDF format for free! Find your manual MS 192 TC - STIHL and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. MS 192 TC by STIHL.
USER MANUAL MS 192 TC STIHL
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : STIHL
Model : MS 192 TC
Category : Saw