MFS6D - Outboard motor Tohatsu - Free user manual and instructions
Find the device manual for free MFS6D Tohatsu in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Outboard Motor |
| Brand | Tohatsu |
| Model | MFS6D |
| Power (HP) | 6 HP |
| Engine Type | 4-Stroke |
| Displacement | 123 cc |
| Starting System | Manual Recoil Start |
| Fuel System | Carburetor |
| Fuel Type | Unleaded Gasoline |
| Fuel Tank Capacity | 12 L (Integrated) |
| Oil System | Integrated Oil Pan, 1.1 L |
| Shaft Length | Short (15") or Long (20") |
| Weight (Approx.) | 26 kg |
| Transom Height | 381 mm (Short) / 508 mm (Long) |
| Gear Ratio | 2.15:1 |
| Propeller | 3-Blade Aluminum |
| Steering | Tiller Handle |
| Trim System | Manual Tilt |
| Cooling System | Water-Cooled |
| Ignition System | CDI |
| Warranty | 3 Years (Limited) |
Frequently Asked Questions - MFS6D Tohatsu
What type of oil should I use for my Tohatsu MFS6D?
Use high-quality 4-stroke outboard oil with API SL or higher, SAE 10W-30 or 10W-40. Change oil every 100 hours or annually.
What fuel should I use in my MFS6D outboard?
Use unleaded gasoline with a minimum octane rating of 87 (AKI). Avoid ethanol blends above 10%.
How do I start a cold Tohatsu MFS6D?
Open the fuel vent, squeeze primer bulb until firm, set choke to 'closed' position, pull starter rope gently until resistance, then pull briskly. Once started, gradually open choke.
What is the break-in procedure for a new MFS6D?
For the first 10 hours: vary speeds, avoid full throttle for more than 5 minutes, and use rich oil mixture if specified. After break-in, change oil.
How often should I change the gear oil?
Change gear oil every 100 hours or once per season. Use SAE 90 marine gear oil.
What is the correct propeller for my MFS6D?
Use a 3-blade aluminum propeller, typically 8-9 inch pitch for standard loads. Consult manual for exact specifications.
How do I flush the engine after use in saltwater?
Attach a garden hose to the flushing port, start engine at idle, run for 5-10 minutes to clear salt. Tilt engine to drain.
What is the spark plug gap for the MFS6D?
The recommended spark plug gap is 0.9 mm (0.035 in). Use NGK BPR6ES or equivalent.
Why won't my outboard motor start?
Check fuel (primer bulb firm), spark plug (clean/gapped), kill switch (lanyard attached), and battery if electric start. Also ensure choke is used properly.
How do I store my MFS6D for winter?
Stabilize fuel, run engine to circulate, change oil, flush cooling system, fog cylinders, and store upright in a dry place.
User questions about MFS6D Tohatsu
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Outboard motor in PDF format for free! Find your manual MFS6D - Tohatsu and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. MFS6D by Tohatsu.
USER MANUAL MFS6D Tohatsu
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Tohatsu
Model : MFS6D
Category : Outboard motor