DS-PS1-I-WE - Detector Hikvision - Free user manual and instructions
Find the device manual for free DS-PS1-I-WE Hikvision in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | PIR Motion Detector |
| Brand | Hikvision |
| Model | DS-PS1-I-WE |
| Detection Technology | Passive Infrared (PIR) |
| Detection Range | Up to 12 meters (110° angle) |
| Power Supply | 3V CR123A Lithium Battery (included) |
| Battery Life | Approximately 3 years (typical usage) |
| Dimensions (H x W x D) | 110 mm x 60 mm x 40 mm |
| Weight | 90 g (without battery) |
| Operating Temperature | -10°C to 55°C (14°F to 131°F) |
| Indoor/Outdoor Use | Indoor only |
| Alarm Output | Wireless signal to compatible control panel |
| Tamper Protection | Anti-tamper switch (cover removal alarm) |
| LED Indicator | Red LED for alarm and low battery |
| Frequency | 868 MHz (EU) or 915 MHz (US/other) |
| Mounting | Wall or corner bracket (included) |
| Security Features | Encrypted wireless communication (AES-128) |
| Maintenance | Clean with soft dry cloth; avoid liquids |
| Spare Parts | CR123A battery, mounting bracket (available) |
| Repairability | Battery replaceable; other parts not user-serviceable |
Frequently Asked Questions - DS-PS1-I-WE Hikvision
How do I install the DS-PS1-I-WE detector?
Mount the detector using the included bracket at a height of 2-2.5 meters. Avoid direct sunlight and heat sources. Insert the CR123A battery and pair with your control panel following the panel's instructions.
How do I pair the detector with a Hikvision alarm system?
Put the control panel into pairing mode. On the detector, press and hold the tamper switch for 3 seconds until the LED blinks. The panel will confirm pairing. Refer to the panel manual for specific steps.
What is the detection range of the DS-PS1-I-WE?
The PIR sensor detects motion up to 12 meters with a 110° horizontal angle. Optimal performance is achieved when the subject moves across the detection pattern.
How long does the battery last?
The CR123A lithium battery lasts approximately 3 years under normal usage. Low battery is indicated by a red LED flash every 30 seconds. Replace immediately when alerted.
What causes false alarms?
Common causes include pets (if not pet-immune), sudden temperature changes near vents or heaters, direct sunlight, and insects inside the sensor. Ensure proper placement and clean the lens regularly.
How do I test the detector?
After installation, wait 2 minutes for the sensor to stabilize. Walk across the detection zone; the red LED should illuminate briefly. Test tamper alarm by removing the cover; the siren should trigger.
Can this detector be used outdoors?
No, the DS-PS1-I-WE is designed for indoor use only. Outdoor exposure to rain, extreme temperatures, or humidity may cause damage and false alarms.
How do I reset the detector to factory defaults?
Remove the battery, press and hold the tamper switch for 10 seconds, then reinsert the battery. The LED will blink rapidly to confirm reset. You will need to re-pair with the panel.
What does the flashing red LED mean?
A single flash every 30 seconds indicates low battery. A flash on motion detection indicates normal alarm. If the LED is solid red continuously, there is a fault; contact support.
How do I clean and maintain the detector?
Use a soft, dry cloth to wipe the housing and lens. Do not use water, solvents, or abrasive cleaners. Check battery annually. Ensure the mounting bracket is secure.
User questions about DS-PS1-I-WE Hikvision
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Detector in PDF format for free! Find your manual DS-PS1-I-WE - Hikvision and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. DS-PS1-I-WE by Hikvision.
USER MANUAL DS-PS1-I-WE Hikvision
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Hikvision
Model : DS-PS1-I-WE
Category : Detector