Serie | 2 DHU30SFSK - Range hood BOSCH - Free user manual and instructions

Product Type	Cooker Hood
Model	Series 2 DHU30SFSK
Brand	Bosch
Width	60 cm
Installation Type	Built-in / Under-cabinet
Control Type	Mechanical push buttons
Number of Speeds	3
Lighting	2 x 20W halogen (optional)
Filter Type	Aluminum grease filter (washable)
Airflow Rate	Up to 360 m³/h
Noise Level	50-62 dB (depending on speed)
Energy Rating	Class D
Power Supply	220-240 V, 50-60 Hz
Dimensions (HxWxD)	140 x 600 x 500 mm
Weight	Approx. 11 kg
Duct Outlet Diameter	150 mm
Recirculation Mode	Possible with optional charcoal filter
Maintenance	Clean grease filter monthly; replace charcoal filter every 4-6 months
Safety Features	Motor thermal protection
Spare Parts Availability	Filters, bulbs, motor available via Bosch service

Frequently Asked Questions - Serie | 2 DHU30SFSK BOSCH

What is the installation height above a gas hob?

The minimum distance between the hob and the cooker hood should be 65 cm for gas hobs, and 55 cm for electric hobs. Always check local regulations.

How do I clean the grease filter?

Remove the aluminum grease filter and wash it by hand in warm soapy water or in a dishwasher (at low temperature). Allow it to dry completely before reinserting.

Can the hood be used in recirculation mode?

Yes, you can use the hood in recirculation mode by installing an optional charcoal filter (not included). This is recommended when ducting to the outside is not possible.

How often should I replace the charcoal filter?

The charcoal filter should be replaced every 4 to 6 months, or more frequently if the hood is used heavily. A saturated filter reduces efficiency.

What type of lighting does the hood use?

The DHU30SFSK is equipped with 2 x 20W halogen bulbs. They can be replaced by the user. Always use bulbs of the same type and rating.

Is the hood noisy?

Noise level varies by speed: approximately 50 dB at low speed and up to 62 dB at maximum speed. These are normal levels for a cooker hood of this class.

What are the dimensions of the hood?

The dimensions are approximately 140 mm in height, 600 mm in width, and 500 mm in depth. Ensure your cabinet space matches these measurements.

How do I reset the filter saturation indicator?

After cleaning or replacing the filters, press and hold the filter reset button (if available) for 3 seconds until the indicator light goes off. Refer to the manual for your specific model.

Can I install the hood myself?

Installation should be performed by a qualified technician to ensure proper electrical connection and secure mounting. The hood must be installed according to manufacturer instructions.

Why is the hood not extracting properly?

Check if the grease filter is clogged, the charcoal filter (if used) needs replacement, or the duct is blocked. Also ensure the hood is installed at the correct height and the room is adequately ventilated.

USER MANUAL Serie | 2 DHU30SFSK BOSCH

GB User instructions

Safety Instructions 3

Installation 4

Instructions for use 6

Service and warranty 8

EE User instructions

Safety rules 9

Installation 10

Use 12

Carefully read these instructions for use and the installation guide, in particular the safety instructions, before you install and begin using the product.

Save these instructions for later use or for the party who may take over the product after you.

Make sure you unplug the product prior to any form of cleaning or care.

§ Diversion of exhaust air shall be carried out in accordance with instructions issued by the appropriate authority. § Exhaust air may not be directed into flues that are used for fumes from, for example, gas, wood or oil-burning stoves, fireplaces, etc. § The distance between the cooker and the product must be at least 40 cm. For gas cookers, the distance should be increased to 65 cm. If a higher mounting height is recommended by the gas cooker manufacturer, this should be taken into account. § In order to avoid a potential hazard, installation, replacement of cables or other types of connection should be carried out by a qualified professional.

§ Flambéing underneath the product is not allowed. § There must be sufficient air in the room when the hood is to be used at the same time as products that use energy sources other than electricity, i.e., gas hobs, gas, wood or oil-burning stoves or fireplaces, etc. § The product may be used by children from 8 years of age and persons with mental, sensory or physical impairment, or a lack of experience and knowledge, if they are informed on how the product is to be used. § Children should not be allowed to play with the product. Cleaning and maintenance of the product must not be performed by children without supervision. § Accessible parts of the product may become hot in conjunction with cooking. § The risk of a fire spreading increases if cleaning is not carried out as often as is recommended.

The cooker hood is intended for installation under, between or built into cupboards. The cooker hood is equipped with a fluorescent tube and metal mesh filter. Installation, use, care, maintenance etc., are described in these instructions.

TECHNICAL INFORMATION

Fig. 1

Width 50, 60 and 70 cm

Other measu- see Fig. 1 rements

Electrical con- 230 V ~ earthed nection

Power Motor 70 W

Lighting Fluorescent tube, socket 2G7 11 W width 60 and 70 cm 9 W width 50 cm

OPTIONS

Drum attachment for connection to kitchen flue.

Over-fan cupboard (cupboard height 110 cm).

Bracket set.

INSTALLATION

Fixing parts, screws for mounting, etc. are supplied with the cooker fan.

Electrical installation

The socket should be accessible after installation is complete.

Assembly of connecting sleeve coupling

Fig. 2

Remove the filter.

Fig. 2 Fig. 2

Assembly

Fig. 3

The cooker hood can be positioned under or built into a row of cupboards, Fig. 3.

Fig. 4

The cooker hood can also be installed using brackets that can be purchased as an additional option, Fig. 4. Instructions for the installation of optional items are enclosed with the items.

Connection to exhaust flue

Connect the cooker fan with a pipe or tubing ∅ 125 mm.

Fig. 5

Attention!

When using a connecting tubing, the tubing must be stretched and assembled to fit directly next to the connection, Fig. 5.

FUNCTION SWITCH

Combined press-and-turn switch for regulating the speed and lighting.

A. Knob for regulating the speed of the fan motor. B. Push button function for lighting.

It is a good idea to turn on the fan before starting to cook, as this prevents odours from spreading into the room. Adjust the speed of the fan depending on the type of food you are preparing. Preferably allow the fan to run on low speed for a while after cooking. If needed, also use the fan's low speed when the oven is in use, or after using the dishwasher.

CARE AND MAINTENANCE

Cleaning

The cooker fan should be cleaned with a damp cloth and washing-up liquid. The filter must be cleaned approximately twice a month, with normal usage. Both the filter and the impeller can be removed when cleaning.

Remove the filter cassette by pressing on the clips on the front edge. Dismantle the filter cartridge and remove the filter cloth by loosening the retainer, Fig. 6. Squeeze the filter cloth in warm water mixed with washing-up liquid. The filter cassette (with filter) can also be washed in the dishwasher.

The interior of the cooker hood should be cleaned at least twice a year. Remove the suction ring and then pull the impeller from the motor, Fig. 7. Wipe the interior with a damp cloth and washing-up liquid. The impeller and suction ring can be washed in a dishwasher or soaked in washing-up liquid. The impeller and suction ring can be pressed back in place after cleaning. Replace the filter cassette and press it upwards so that it clicks into place.

Changing the fluorescent tube

The lamp lens can be removed by pressing the snap retainers in the direction shown by the arrow; see Fig. 8. The fluorescent tube is now accessible for replacing.

Check that the fuse is intact. Go through all the functions to check what does not work.

Contact EHA service

Iceland tel. [phone]

The product is covered by applicable industry regulations.

PACKAGING AND PRODUCT RECYCLING

The packaging should be deposited at your nearest recycling collection point

The symbol means that the product may not be treated as household waste. It should instead be submitted to a collection point for the recycling of electrical and electronic components. By ensuring that the product is handled in the correct manner, you help to prevent the possible negative environmental and health effects that could occur if the product was disposed of as regular waste. For further information on recycling, contact your local authority or refuse disposal service, or the store where you purchased your product.

The product meets and is tested in accordance with the eco-design directive 66/2014.

Fig. 3

Fig. 4

Fig. 5

Note!

Fig. 6

Fig. 7

Fig. 8

Fig. 3

Fig. 4

Fig. 5

Note!

Fig. 6

Fig. 7

Fig. 8

[e-mail]

Fig. 3

Fig. 4

Fig. 5

Note!

Fig. 6

Fig. 7

Fig. 8

[e-mail]