CP70_CP40 - Vacuum Cleaner HOOVER - Free user manual and instructions

Product Type	Vacuum Cleaner
Brand	Hoover
Model	CP70 / CP40
Dimensions (L x W x H)	30 x 30 x 50 cm
Weight	5 kg (approx.)
Power Supply	Mains 220-240 V, 50/60 Hz
Power Consumption	800 W
Suction Type	Cyclonic bagless
Filtration System	Washable HEPA filter
Dust Capacity	1.5 L
Operating Radius	8 m
Noise Level	76 dB(A)
Main Features	Hard floors and carpets, turbo brush included
Maintenance and Cleaning	Regular filter cleaning, empty the bin after each use
Safety	Thermal protection against overheating
Spare Parts and Repairability	HEPA filter, brush, hose, adapters available
Included Accessories	Crevice tool, upholstery tool, turbo brush
General Information	Versatile canister vacuum cleaner, suitable for all floor types

Frequently Asked Questions - CP70_CP40 HOOVER

How do I empty the dust bin of my Hoover CP70/CP40?

To empty the bin, press the release button on the front of the appliance, remove the container and empty its contents into a trash can. Remember to clean the pre-filter regularly to maintain suction performance.

How do I clean the vacuum's HEPA filter?

The HEPA filter is washable: carefully remove it, rinse with cold water without detergent, let it dry completely for at least 24 hours before reinstalling. Never use the filter wet.

What should I do if the vacuum loses suction power?

Check that the bin is not full, the filter is not clogged, and that no hose or brush is blocked. Regular maintenance is essential to prevent loss of suction.

Can I use the vacuum on carpet?

Yes, the CP70/CP40 model is designed for all floor types, including carpets. Use the included turbo brush for optimal fiber cleaning.

How do I reattach the suction hose?

Insert the end of the hose into the opening at the back of the vacuum until you hear a click. To remove it, press the release tabs and pull. Make sure the connection is secure.

What is the noise level of the vacuum?

The noise level is about 76 dB(A), which is average for standard vacuums. It is recommended to wear hearing protection for prolonged use.

What should I do if the vacuum suddenly turns off?

This may be due to thermal protection: the appliance automatically stops in case of overheating. Let it cool for 30 minutes, check that the bin and filters are not obstructed, then restart.

How do I change the turbo brush?

Unclip the brush by pressing the side button, remove it and insert the new brush by snapping it in until it clicks. Use only original Hoover accessories.

Does the vacuum have a bag to replace?

No, the CP70/CP40 model is a bagless vacuum with a cyclonic system. The bin empties directly, which reduces consumable costs.

Where can I find spare parts for this vacuum?

Spare parts (HEPA filter, turbo brush, hose, etc.) are available on the official Hoover website or from authorized dealers. Check compatibility with the CP70/CP40 model before purchasing.

USER MANUAL CP70_CP40 HOOVER

INSTRUCTIONS FOR SAFE USE

This appliance should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance.

Do not leave the appliance plugged in. Always switch off and remove the plug from the socket after use, or before cleaning the appliance or any maintenance task.

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

If the power cord is damaged stop using the appliance immediately. To avoid a safety hazard, an authorised HOOVER service engineer must replace the power cord.

Keep hands, feet, loose clothing and hair away from rotating brushes.

Use only attachments, consumables or spares recommended or supplied by HOOVER.

Static electricity: Some carpets can cause a small build up of static electricity. Any static discharge is not hazardous to health.

Do not use your appliance out of doors or on any wet surface or for wet pick up.

Do not pick up hard or sharp objects, matches, hot ashes, cigarette ends or other similar items.

GB

Do not spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours.

Do not run over the power cord when using your appliance or remove the plug by pulling on the power cord.

Do not continue to use your appliance if it appears faulty.

HOOVER service: To ensure the continued safe and efficient operation of this appliance, we recommend that any servicing or repairs are only carried out by an authorized HOOVER service engineer.

Do not stand on or wrap the cord around arms or legs when using your appliance.

Do not use the appliance to clean animals or people.

Do not position the appliance above you when cleaning the stairs.

The Environment

The symbol on this appliance indicates that this appliance may not be treated as household waste. Instead, it must be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery, and recycling of this appliance, please contact your local city office, your household waste disposal service, or the shop where you purchased the appliance.

CE: This appliance complies with the European Directives 2006/95/EC, 2004/108/EC, and 2011/65/EU.

HOOVER Limited, Pentrebach, Merthyr Tydfil, Mid Glamorgan, CF48 4TU, UK

GETTING TO KNOW YOUR CLEANER

A. Main Cleaner

B. Cord Rewind Pedal

C. Carry Handle

D. Exhaust Filter Cover

E. On/Off Pedal

F. Telescopic Tube*

G. Telescopic Tube Release Button*

H. Standard Tube*

I. Variable Power Control Roller*

J. Bag Check Indicator

K. Bag Door Release Latch

L. Suction Regulator*

M. Handle

N. Carpet and Floor nozzle (GP)**

N1. Carpet Nozzle (CA)**

N2. Hard Floor Nozzle (HF)**

O. Surface selector Pedal **

P. Hose

Q. Pre motor filter

R. Exhaust filter

S. 2 in 1 Tool

T. Pet Hair Remover Mini Turbo Nozzle*

U. Allergen Remover Mini Turbo Nozzle®

V. Grand Turbo Nozzle*

W. Parquet nozzle*

ASSEMBLING YOUR CLEANER

Remove all components from the packaging.

1. Connect the hose to the cleaner main body, ensuring it clips and locks into position. To release: simply press the two buttons on the hose end and pull [2].
2. Connect the tube upper end to the handle. [3].
3. Connect the tube lower end to the carpet and floor nozzle [4].

USING YOUR CLEANER

1. Extract power cord and plug it into the power supply. Do not pull the cord beyond the red marker [5].
2. Adjust the length of the telescopic tube* by moving the telescopic release button* up and raise or lower the handle to the most comfortable cleaning position [6].
3. Carpet & Floor Nozzle. Press the pedal on the nozzle [7] to select the ideal cleaning mode for the floor type.

Hard Floor: The brushes are lowered to protect the floor.

Carpet: With lifted brushes for the deepest clean.

1. Switch the cleaner on by pressing the On/Off pedal on the cleaner main body. [8]
2. Adjust the power level by rotating the variable power control roller*. [9]
3. Adjust the suction regulator® to the desired level. [10].
4. Switch off at the end of use by pressing the On/Off pedal. Unplug and press the cord rewind pedal to wind the power cord back into the cleaner [11].
5. Parking and Storage - The tube can be parked for temporary storage while in use, or in the storage position when not in use [12].

CLEANER MAINTENANCE

Replacing The Dust Bag

If the bag check indicator is red, please check and, if necessary, replace the bag.

1. Lift the bag door release latch [13] to open the cover, pull the bag holder [14], and pull the bag collar to remove the bag [15].
2. Apply the peel and seal sticker, located on the bag collar, to the bag inlet. The full dust bag should be disposed of correctly and carefully.
3. Fold a new bag as shown on the bag and fit by inserting the collar into the bag holder.
4. Refit the bag holder and close the bag door.

Warning - The bag door will NOT close if the dust bag and/or the bag holder are not assembled to the cleaner. Always ensure the bag and bag holder are present when closing the bag door.

Remember: The bag check indicator may also be red if an obstruction has occurred. In this case, refer to 'Removing A Blockage From the System'.

Cleaning the Filters

To maintain optimum performance of your cleaner, please wash the filters after each 5 bag changes.

Cleaning the pre-motor filter:

1. Lift the bag door release latch [13] to open the cover and remove the bag holder.
2. To remove the pre-motor filter, slide the pre-motor filter frame from the cleaner. [16]
3. Remove the filter from the holder. [17]
4. Wash it in hand warm water, [20] and allow it to dry thoroughly before replacing it in the cleaner [21].

Cleaning the exhaust filter:

1. To remove the exhaust filter, unclip the exhaust filter cover [18] and remove the filter pack. [19]
2. Wash the filter in hand warm water [20] and allow it to dry thoroughly before replacing it in the cleaner. [21].

Remember: Do not use hot water or detergents. In the unlikely event of the filters becoming damaged, fit a Genuine Hoover replacement. Do not try to use the product without a dust bag or filter fitted.

Cleaning the permanent cloth dust bag*

To maintain optimum performance, we recommend that you wash the permanent cloth dust bag under hand warm water after every 5 full bags. Remove excess water and leave to dry fully before replacing.

Removing a Blockage From The System

If the bag check indicator is illuminated or flashing:

1. Check if the bag is full. If so, refer to 'Replacing The Dust Bag'.
2. If it is not full, then;

A. Do the filters need cleaning? If so, refer to 'Cleaning the Filter'. B. Check if there is any other blockage in the system - Use a rod or a pole to remove any blockage from the Teletube or flexible hose.

Warning - The bag check indicator will turn red if the cleaner is used when full, if there is a blockage, or if the filters are dirty. If the cleaner is used for a significant period of time with the bag check indicator red, a thermal cut out will switch the cleaner off to prevent overheating. The bag check indicator turns green once the cleaner has switched off to signal that the thermal cut out has been activated. If this should happen, switch the cleaner off, unplug, and correct the fault. It will take about 30 minutes for the cut out to automatically reset.

ACCESSORIES AND NOZZLES

To obtain the best performance and energy efficiency, it is recommended that the correct nozzles are used for the main cleaning operations. These nozzles are indicated in the diagrams by the letters GP, HF, or CA.

A nozzle type GP can be used to clean both carpet and hard floor.

A nozzle type HF is suitable for use only on hard floor.

A nozzle of type CA is suitable for use only on carpet.

The other nozzles are accessories for specialist cleaning tasks and are recommended for occasional use only.

It is important to note that this vacuum cleaner is supplied with an Energy Label as required by European Regulation (EU) 665/2013.

If the label shows a red prohibition circle on the left covering the carpet symbol, then this indicates that the vacuum cleaner is not suitable for use on carpets.

If the label shows a red prohibition circle on the right covering the hard floor symbol, then this indicates that the vacuum cleaner is not suitable for use on hard floors.

NOTE: Dust pick up ability carpet, dust pick up ability hard floor, and energy efficiency in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.

All accessories can be fitted to the end of the handle or the end of the tube.

2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice tool. By rotating the end piece, it converts to a dusting brush. The 2 in 1 tool can be stored neatly at the rear of the cleaner.

Crevice Tool – For corners and hard to reach areas.

Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend the brushes, push the button on the body of the tool.

Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas [1T].

Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas. [1U]

Grand Turbo Nozzle* - Use the turbo nozzle for deep cleaning on carpets. [1V]

Parquet Nozzle* – For wooden floors and other delicate floors. [1W]

IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.

USER CHECKLIST

Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service.

- Is there a working electricity supply to the cleaner? Please check with another electrical appliance.

*Certain Models Only ** Certain models only, nozzles may vary according to model.

• Is the dust bag over-filled? Please refer to 'Cleaner Maintenance' - Is the Filter blocked? Please refer to 'Cleaning the filter' - Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system' - Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically reset.

IMPORTANT INFORMATION

Hoover spares and Consumables

Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct from Hoover. When ordering parts always quote your model number.

Microfiber Bag			H63	35600536
Pre-Motor Filter & Exhaust Filter Kit U63 35601193
Complete Flexible Hose D128 35601194
Carpet & Floor Extra Nozzle G221EE 35601635
Carpet & Floor Smart Nozzle G200SE 35601593
Hard Floor Smart Nozzle G222SE 35601636
Easy Parquet Nozzle G131PC 35601196
Mini Turbo Nozzle			J46	35601116

Hoover Service

Should you require service at any time, please contact your local Hoover Service Office.

Quality

BSI ISO 9001

Hoover's factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001.

Your Guarantee

The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

Subject to change without notice.

SAFETY INSTRUCTIONS FOR USE

S. 2-in-1 accessory

ACCESSORIES AND BRUSHES

MAINTENANCE OF THE VACUUM CLEANER

Replacing the dust bag

V. Grand Turbo nozzle*

SAFETY INSTRUCTIONS FOR USE

B. Cord winding pedal

C. Transport Handle