PAV1205 - Vacuum Cleaner BLACK & DECKER - Free user manual and instructions

USER MANUAL PAV1205 BLACK & DECKER

Line drawing of a mechanical device with coiled cable and handle, labeled E and 6 (no text or symbols on the diagram itself)

0 1 4 F BLACK& DECKER

⑤ G

Technical diagram of a hair dryer with labeled parts and directional arrows indicating motion or movement.

Technical diagram showing mechanical assembly with labeled components and directional arrows indicating motion or movement.

Technical line drawing of a mechanical device with a numbered component (16) and directional arrow, no readable text or symbols present.

Technical diagram showing two steps of a mechanical device with labeled parts 15 and 16, likely illustrating a procedure or assembly.

Intended use

Your Black & Decker Dustbuster® auto car vacuum cleaner has been designed for light dry vacuum cleaning purposes. The appliance is powered from a car electrical system and connected by the cigarette lighter socket. This appliance is intended for domestic use only.

Safety instructions

Warning! When using electrical appliances, basic safety precautions, including the following, should always be followed to reduce the risk of fi re, leaking batteries, personal injury and material damage.

• Read all of this manual carefully before using the appliance.
• The intended use is described in this manual. The use of any accessory or attachment or the performance of any operation with this appliance other than those recommended in this instruction manual may present a risk of personal injury.
• Retain this manual for future reference.

Using your appliance

• Do not use the appliance to pick up liquids or any materials that could catch fi re.
• Do not use the appliance near fl ammable fumes.
• Do not use the appliance near water.
• Do not immerse the appliance in water.
• Never pull the power lead to disconnect the plug from the cigarette lighter socket. Keep the lead away from heat, oil and sharp edges.
• Be careful not to pinch the lead in the vehicle's doors, windows or levers.
• This product is not suitable for picking up cigarette or cigar ash.
• Keep the motor draught away from your eyes and face.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Children must be supervised to ensure that they do not play with the appliance.

After use

- When not in use, the appliance should be stored in a dry place.

• Children should not have access to stored appliances.

Inspection and repairs

• Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation.
• Do not use the appliance if any part is damaged or defective.
• Have any damaged or defective parts repaired or replaced by an authorised repair agent.
• Regularly check the power lead and connector for damage. If the supply cord or connector is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.
• Never attempt to remove or replace any parts other than those specified in this manual.

Electrical safety

The appliance is designed for use with 12 V negative ground vehicle battery systems.

Warning! The cigarette lighter connector is fitted with a nonserviceable safety fuse. The fuse may operate in the event of a fault. If this occurs the fuse must be replaced together with the connector and cable by the manufacturer or an authorised Black and Decker Service Centre in order to avoid a hazard.

Warning! Do not operate the appliance with systems which have positive ground or a different voltage.

Features

1. Release button
2. Container door
3. Collector lock button
4. On/off switch
5. Filter cleaning wheel
6. Cigarette lighter connector
7. Dust collector extension
8. Dust bowl

Fig. C & D

1. Storage bag
2. Brush tool
3. Right-angled brush tool
4. Hose
5. Hose connector

Assembly

Adjusting the dust collector (fi g. B)

- The dust collector (8) is stored under the appliance. To adjust for use, press the collector

ENGLISH

lock button (3) and rotate the dust collector to the required position.

• Release the collector lock button (3) to lock the dust collector (8) in position.
• The dust collector (8) can be extended by pulling the dust collector extension (7) until it locks into position.
• The extension can be retracted by pressing the button (14) and pushing the extension (7) back into the dust collector.
• The dust collector (8) should be returned to the storage position under the appliance after use.

Fitting the accessories (fi g. C & D)

The appliance is supplied with the following accessories:

• Two brush tools (10 & 11) for upholstery
  • An extension hose (12)
  • A hose connector (13)

Note: The brush tool (10) can be fitted into the front of the appliance, the right-angled brush tool (11) can be fitted to the end of the extension hose (12).

To fit an accessory, proceed as follows:

• Insert the brush (10) into the front of the appliance.
• Alternatively, fi t the hose connector (13) onto the nose of the appliance and attach one end of the hose (12) to the connector.
• Attach the right-angled brush tool (11) to the other end of the hose.
• When not in use, the accessories can be stored in the storage bag (9).

Use

Connecting to the vehicle's power supply (fi g. E)

• Make sure that the appliance is switched off.
- Remove the cigarette lighter from it's socket.
- Plug the connector (6) into the cigarette lighter socket.

Switching on and off (fi g. F)

• To switch on, slide the on/off switch (4) forward.
  • To switch off, slide the on/off switch back. The appliance can be used for periods of up to 30 minutes without noticeably affecting the power of a normally charged car battery in good condition.

Warning! Extended use will drain the battery power. Do not run the vehicle's engine while cleaning as this can shorten the life of the appliance.

Optimising the suction force (fi g. G)

In order to keep the suction force optimised, the fil ters must be cleared regularly during use.

- Rotate the fi lter cleaning wheel (5) a few turns to shake out dust clogging the fi lters (15 & 16).

Cleaning and maintenance

Warning! Regularly clean the filters (15 & 16).

Cleaning the dust bowl and fi Iters (fi g. H - I)

The filters are re-usable and should be cleaned regularly.

• Press the release latch (1) and open the container door (2) (fi g. H).
  • Empty the dust container.
• Remove the fi Iters (15 & 16) by twisting them counterclockwise (fi g. I).
• Brush any loose dust off the filter.
• Wash the filters in warm, soapy water (fi g. J).
  • Make sure that the fi Iters are dry.
• Refi t the fi Iters (15 & 16) on to the appliance, twisting them clockwise until they lock into place.
• Close the container door (2). Make sure that the release latch (1) clicks into place.

Warning! Never use the appliance without the fi Iters. Optimum dust collection will only be achieved with clean fi Iters.

Replacing the fi Iters

The fi Iters should be replaced every 6 to 9 months and whenever worn or damaged. Replacement fi Iters are available from your Black & Decker dealer (cat. no. VF50):

• Remove the old fi Iters as described above.
• Fit the new filters as described above.

Protecting the environment

Separate collection. This product must not be disposed of with normal household waste.

Should you find one day that your appliance needs replacement, or if it is of no further use to you, think of the protection of the environment.

Black & Decker repair agents will accept old Black & Decker tools and ensure that they are disposed of in an environmentally safe way.

Separate collection of used products and packaging allows materials to be recycled and used again. Re-use of recycled materials helps prevent environmental pollution and reduces the demand for raw materials.

Local regulations may provide for separate collection of electrical products from the household, at municipal waste sites or by the retailer when you purchase a new product.

Black & Decker provides a facility for the collection and recycling of Black & Decker products once they have reached the end of their working life. To take advantage of this service please return your product to any authorised repair agent who will collect them on our behalf.

You can check the location of your nearest authorised repair agent by contacting your local Black & Decker offi ce at the address indicated in this manual. Alternatively, a list of authorised Black & Decker repair agents and full details of our after-sales service and contacts are available on the Internet at: www.2helpU.com.

Technical data

PAV1205
Voltage	Vdc	12
Weight	kg

EC declaration of conformity

PAV1205

Black & Decker declares that these products conform to: 2006/95/EC, EN 55014, EN60335, EN 61000

Level of sound pressure, measured according to EN 60704-1: = 74,5 dB(A)

Kevin Hewitt

Director of Consumer

Engineering

Spennymoor, County Durham

DL16 6JG, United Kingdom

04-09-2007

Guarantee

Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.

If a Black & Decker product becomes defective due to faulty materials, workmanship or lack of conformity, within 24 months from the date of purchase, Black & Decker guarantees to replace defective parts, repair products subjected to fair wear and tear or replace such products to

make sure of the minimum inconvenience to the customer unless:

• The product has been used for trade, professional or hire purposes.
• The product has been subjected to misuse or neglect.
• The product has sustained damage through foreign objects, substances or accidents.
  • Repairs have been attempted by persons other than authorised repair agents or Black & Decker service staff.

To claim on the guarantee, you will need to submit proof of purchase to the seller or an authorised repair agent. You can check the location of your nearest authorised repair agent by contacting your local Black & Decker offi ce at the address indicated in this manual. Alternatively, a list of authorised Black & Decker repair agents and full details of our aftersales service and contacts are available on the Internet at: www.2helpU.com

Please visit our website

1,3 www.blackanddecker.co.uk to register your new Black & Decker product and to be kept up to date on new products and special offers. Further information on the Black & Decker brand and our range of products is available at www.blackanddecker.co.uk.

Director of Consumer

Engineering

Spennymoor, County Durham

Spennymoor, County Durham

Director of Consumer

Engineering

Spennymoor, County Durham

DL16 6JG, United Kingdom

04-09-2007

Garancia határozat

Spennymoor, County Durham

Spennymoor, County Durham

DL16 6JG, Vel'ká Británia

04-09-2007

Spennymoor, County Durham

DL16 6JG, United Kingdom

04-09-2007

БЛЭК ЭНД ДЕККЕР

гарантийные условия

Spennymoor, County Durham

DL16 6JG, İngiltere

04-09-2007

Garanti