AXDI-GM3 - Car stereo AXESS - Free user manual and instructions

USER MANUAL AXDI-GM3 AXESS

Electronic device housing with a black plastic enclosure and blue connector (no visible text or symbols)

INTERFACE COMPONENTS

• AXDI-GM3 interface
  • LD-LCGM-03 harness

APPLICATIONS

Cadillac

Catera....1997-2001

Deville 1996-1999

Deville* 2000-2005

Eldorado 1996-2002

Seville 1996-1997

Seville* 1998-2004

*Note: You must bypass the factory amp in these vehicles to use this interface

TABLE OF CONTENTS

Connections

LD-LCGM-03 DIAGRAM....2

Installation 3

Programming......3

TOOLS & INSTALLATION ACCESSORIES REQUIRED

• Cutting tool • Tape • Crimping tool
- Connectors (i.e. butt-connectors, bell caps, etc.)

Visit AxxessInterfaces.com

for more detailed information about the product and up-to-date vehicle specific applications

ATTENTION: With the key out of the ignition, disconnect the negative battery terminal before installing this product. Ensure that all installation connections, especially the air bag indicator lights, are plugged in before reconnecting the battery or cycling the ignition to test this product. NOTE: Refer also to the instructions included with the aftermarket accessory before installing this device.

CONNECTIONS: LD-LCGM-03 DIAGRAM

graph TD
    A["AXXESS"] -->|12-Pin| B["LD-LCGM-03"]
    B --> C["Vehicle Connector"]
    B --> D["Aftermarket Radio (Your radio's features may vary)"]
    D --> E["Sub"]
    D --> F["AUX-IN"]
    D --> G["Rear View"]
    D --> H["Front"]
    D --> I["Rear"]
    D --> J["SWC"]
    J --> K["Radio Connections"]
    K --> L["Green - Rear left speaker + output"]
    K --> M["Green/Black - Rear left - speaker output"]
    K --> N["Green/Purple - Reverse backup camera"]
    K --> O["Light Green - Parking brake"]
    K --> P["Purple - Rear right + speaker output"]
    K --> Q["Purple/Black - Rear right - output"]
    K --> R["Blue - Antenna on"]
    K --> S["Blue/Pink - VSS/Speed-Sense"]
    K --> T["Orange - No Connection"]
    K --> U["Orange/White - Illumination"]
    K --> V["Gray - Front right + speaker"]
    K --> W["Gray/Black - Front right - speaker"]
    K --> X["White - Front left + speaker"]
    K --> Y["White/Black - Front left - speaker"]
    K --> Z["Red - Accessory power"]
    K --> AA["Yellow - Battery wire"]
    K --> AB["Black - Ground wire"]

INSTALLATION

With the key in the off position:

- Connect the LD-LCGM-03 harness into the interface, and then to the wiring harness in the vehicle.

PROGRAMMING

Attention! If the interface loses power for any reason, the following steps will need to be performed again. Also, if installing an AXSWC connect it after you initialize and test the interface/radio, with the key in the off position.

• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
  Note: If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the installation for proper operation, before reassembling the dash.

Having difficulties? We're here to help.

Contact our Tech Support line at:

386-257-1187

Or via email at: techs

Tech Support Hours (Eastern Standard Time)

Monday - Friday: 9:00 AM - 7:00 PM

Saturday: 10:00 AM - 5:00 PM

Sunday: 10:00 AM - 4:00 PM

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.edu or call 386-672-5771 for more information and take steps toward a better tomorrow.

Metra recommends MECP certified technicians