WGCXR111EG - Switch HAGER - Free user manual and instructions
Find the device manual for free WGCXR111EG HAGER in PDF.
User questions about WGCXR111EG HAGER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Switch in PDF format for free! Find your manual WGCXR111EG - HAGER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. WGCXR111EG by HAGER.
USER MANUAL WGCXR111EG HAGER
16AX switches 1way/2way 10AX intermediate switch Hager Muse / Hager Inspire
Installation manual
Safety instructions
Electrical equipment must only be installed and assembled by a qualified electrician in accordance with the relevant installation standards, regulations, directives and safety and accident prevention directives of the country.
Failure to comply with these installation instructions may result in damage to the device, fire or other hazards.
Function
Mechanical light switches for electrical installations in buildings.
Correct use
- For the flush-mounted installation in standard wall boxes (recommended wall box depth ≥ 35 mm).
- Only suitable for use in indoor areas with no drip and no spray water.
Technical data
Rated voltage: 250 V\~
Frequency: 50/60 Hz
Conductor cross-section of screw terminals: max. 3 x 1.5 mm ^4
Distance of fixing holes: 60.3 mm
Switch compliance: BS EN 60669-1, IEC 60669-1
16AX switches 1way/2way
Rated current: max. 16 AX
10AX intermediate switch
Rated current: max. 10 AX
Information for electricians Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and cover all live parts in the area!
Preparing the device for installation
(for example "16AX 2gang 1way switch")
text_image
1 Frame Rockers NotchesCarefully loosen the frame on the notches with a flat-blade screwdriver. Lift up and remove the frame (1).
■ Remove the rockers also with a flat-blade screwdriver.
Connecting the device
2A
text_image
L C L1 1way NGeneral circuit diagram
text_image
L N C C C1gang 1way switch
1way switch
text_image
L N C1 Analog C2 C62gang 1way switch
2B
text_image
L C L1 L1 C L2 L2 2way 2way N General circuit diagram2way switch
text_image
L N 1gang 2way switch 1gang 2way switch
text_image
L N C L21 L1 L2 C L1 2gang 2way switch2C
Intermediate switch
text_image
L C L111 L2L2 2way Intermediate L1 C 2 2 2way N General circuit diagram
text_image
1gang 2way switch Intermediate switch 1gang 2way switch- Strip connection cables approx. 10 ... 12 mm.
■ Wire the switch according to the appropriate wiring diagram (2A or 2B or 2C).
Installing the device into the wall box
(for example "16AX 2gang 1way switch")
3
natural_image
Technical diagram of a mechanical assembly with internal components and tool tips (no text or symbols)■ After wiring, fix the device with the two screws attached into the wall box (3).
Assembling the rockers and frame
(for example "16AX 2gang 1way switch")
4
text_image
Rockers Frame■ Fix the rockers and frame onto the device (4).
2-5gang frames are available for multiple combinations.