WGCXL2D12NEG - Switch HAGER - Free user manual and instructions
Find the device manual for free WGCXL2D12NEG HAGER in PDF.
User questions about WGCXL2D12NEG HAGER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Switch in PDF format for free! Find your manual WGCXL2D12NEG - HAGER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. WGCXL2D12NEG by HAGER.
USER MANUAL WGCXL2D12NEG HAGER
20AX DP control switches
Hager Muse / Hager Inspire
Installation manual
Safety instructions
Electrical equipment must only be installed and assembled by a qualified electrician in accordance with the relevant installation standards, regulations, directives and safety and accident prevention directives of the country.
Failure to comply with these installation instructions may result in damage to the device, fire or other hazards.
Function/Correct use
- Mechanical double pole switches/control switches for electrical installations in buildings.
- For switching hard-wired electrical appliances.
- With earthing contact for bonding connected loads to protective earth.
- Control switches equipped with LED indicator per each rocker.
- For the flush-mounted installation in standard wall boxes (recommended wall box depth ≥ 35 mm). Attention: When installed in metal wall box, the box must be connected with earth directly.
- Only suitable for use in indoor areas with no drip and no spray water.
Technical data
Rated voltage: 250 V\~
Frequency: 50/60 Hz
Rated current: max. 20 AX
Conductor cross-section of screw terminals: max. 3 x 2,5 mm ^4
Distance of fixing holes: 60.3 mm
Switch compliance: BS EN 60669-1, IEC 60669-1
Information for electricians Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and cover all live parts in the area!
Preparing the device for installation
(for example "20AX 2gang DP switch w/LED")
1
text_image
Frame Rockers NotchesCarefully loosen the frame on the notches with a flat-blade screwdriver. Lift up and remove the frame (1).
■ Remove the rockers also with a flat-blade screwdriver.
Connecting the device
2A
text_image
L N E L N LOAD1gang DP switch
Double pole switch
text_image
L N E L N L N L N LOAD 2 LOAD 12gang DP switch
2B
text_image
L N E G L N shaper L N N CE L N LOAD1gang DP switch w/LED
Double pole control switch
text_image
L N E LOAD 2 LOAD 12gang DP switch w/LED
2C
2way double pole control switch
text_image
L N E LED L N LOAD1gang 2way
DP switch w/LED
1gang 2way
DP switch w/LED
- Strip connection cables approx. 10 mm.
■ Wire the switch according to the appropriate wiring diagram (2A or 2B or 2C).
When installed in metal wall box, the box must be connected with earth directly!
Installing the device into the wall box
(for example "20AX 2gang DP switch w/LED")
3
natural_image
Diagram of a cable connector with internal components and screwdriver, showing no text or symbols■ After wiring, fix the device with the two screws attached into the wall box (3).
Assembling the rockers and frame
(for example "20AX 2gang DP switch w/LED")
4
text_image
Rockers Frame■ Fix the rockers and frame onto the device (4).
2-5gang frames are available for multiple combinations.