WGCXHSRNB - Switch HAGER - Free user manual and instructions
Find the device manual for free WGCXHSRNB HAGER in PDF.
User questions about WGCXHSRNB HAGER
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Switch in PDF format for free! Find your manual WGCXHSRNB - HAGER and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. WGCXHSRNB by HAGER.
USER MANUAL WGCXHSRNB HAGER
Electrical equipment must only be installed and assembled by a qualified electrician in accordance with the relevant installation standards, regulations, directives and safety and accident prevention directives of the country.
Failure to comply with these installation instructions may result in damage to the device, fire or other hazards.
Function
The shaver socket is installed in a bathroom of a hotel in order to provide safety power to an electric razor.
Correct use
- According to IEC 60670 installation of the safety shaver socket outlet is only permitted in plastic wall box or metal wall box (metal wall box must be connected with earth directly).
Observe depth of wall box (depth ≥ 51 mm).
- Only suitable for use in indoor areas with no drip and no spray water.
Technical data
Rated voltage: 250 V\~
Frequency: 50/60 Hz
Output voltage: 115 V\~/230 V\~
Power: max. 20 VA
Conductor cross-section of screw terminals: min. 1 x 1.5 mm ^2 ... max. 2 x 4 mm ^2
Distance of fixing holes: 120.6 mm
Compliance: BS EN 61558
Information for electricians Installation and electrical connection
DANGER!
Touching live parts can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and cover all live parts in the area!
Preparing the device for installation
1
text_image
Frame NotchesCarefully loosen the frame on the notches with a flat-blade screwdriver. Lift up and remove the frame (1).
Connecting the device
2A
with plastic wall box
text_image
L N 50/60 2V/4 F21 0V- L N2B
with metal wall box
text_image
L N 60V 20V P21 EN- N Warning !- Strip connection cables approx. 10 ... 15 mm.
■ Wire the shaver socket according to the connection diagram (2A or 2B). When installing in metal wall box (2B), the box must be connected with earth directly.
Installing the device into the wall box
3
text_image
SHAOVERD ONLY■ After wiring, fix the device with the two screws attached into the wall box (3).
Assembling the frame
4
text_image
SHAVERS ONLY Frame■ Snap the frame onto the device (4).