WT80J8BEQU - Washing machine SAMSUNG - Free user manual and instructions

USER MANUAL WT80J8BEQU SAMSUNG

Owner's Instructions

Line drawing of a microwave oven with control panel and side legs (no text or symbols)

Before operating the unit, please read this manual throughly, and retain for future reference.

BEFORE USING THE WASHER .... 1

CAUTIONS 1

PRECAUTIONS WHEN OPERATING 1

DESCRIPTION OF PARTS 2

CONTROL PANEL 2

INSTALLATION 3

ENVIRONMENT 3

HOW TO CLEAN THE FILTER 3

CONNECTING THE DRAIN HOSE 3

CLEANING THE MACHINE .... 3

WASHING PROCEDURE 4

TO WASH 4

SPIN DRY 5

RINSING 5

OVER FLOW RINSE 5

ADDITIONAL RINSE 5

LAUNDRY GUIDE 6

MAINTENANCE 6

TROUBLESHOOTING

SPECIFICATIONS

Register your product at

www.samsung.com/global/register

CODE NO.: DC68-02750C

BEFORE USING THE WASHER

- In case of pump drained washer, Take out personal belongings from pockets. remove the cap-hose from Caution, Check the pockets! the drain hole. Hairpins and coins cause

damages to clothes and

washing machine.

They make noise and

problems to the machine.

Must check the pocket.

CAUTIONS

- Be sure that the washer is grounded.

To avoid electrical shock, use a metal pipe for the ground connection. But, don't ground the washer with gas pipes or telephone lines to avoid to dangers of explosion or lightn

- Do not put your hands into the spin dryer basket when it is spinning.

Your fingers can be caught by spinning laundry and damaged.

- Never allow children to operate or play with the washer.

Children playing with the washer may accidentally fall into the washing tub.

• Disconnect the power cord from the power supply when not in use.
• Ventilation opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
• If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required.
• To avoid overfilling and damages this appliance must be filled with the operator present using a moderate water supply pressure only.
• For washing machines with ventilation openings in the base, that a carpet must not obstruct the openings.

PRECAUTIONS WHEN OPERATING

- Don't use excessively hot water. Be sure to cover with the safety (50°C or more) cover on laundry before spinning.

Plastic parts may be deformed or damaged. This prevents laundry from Also, clothing may be deformed or decolored. being tossed out and damaged.

• Before washing, check all pockets. If nails or pins remain in pockets, they may damage the washer or clothes.
• Close the water tap a little if the water pressure is too high.
  ● To avoid water splashes, close the wash tub lid.
  ● Never splash water on the control panel.

- Be sure lay the drain hose(A) down.

(WITHOUT PUMP)

- Be sure place the drain hose(A) in sink or bath about 70\~80cm above the ground.

(WITH PUMP)

DESCRIPTION OF PARTS

SPIN DRYER LID When you open this lid while the spin basket is spinning, the spinning will be stopped by brake system. POWER CORD The plug's shape may not correspond with this drawing. SPIN DRYER BASKET INNER LID DRAIN HOSE (WITH PUMP) LINT FILTER WASH TUB WASH TUB LID Be sure to keep the lid closed during washing and spinning. WATER DRAIN HOSE (WITHOUT PUMP) PULSATOR DRAIN FILTER (WITH PUMP)

CONTROL PANEL

1. WATER SELECTOR 4. AIR TURBO SPIN TIMER

This is used to select wash action. This is used to set the spin time, 1-10 minutes.

1. WASH TIMER 5. WATER SELECTOR

This is used to set the wash time, 1-15 minutes.

1. CYCLE SELECTOR

This is used to select the Washing/Rinsing or Draining.

During washing, WATER SELECTOR KNOB should be selected to wash. During spin rinsing, WATER SELECTOR KNOB should be selected to spin.

1 2 5 3 4 SAMSUNG Durable Storm Air Turbo Spin Timer WT8018 Air Turbo Spin Timer Normal Normal Wash Selector Wash Times Water Selector Wash Times Wash Water Wash Wash Wash Wash Wash

INSTALLATION

ENVIRONMENT HOW TO CLEAN THE FILTER (In case drain pump)

Leave some space not to wet the floor.

Space at last 15cm between the washer

and the wall. and pull out the filter.

1. Remove dirt and rotate

Place the washer on a sturdy flat surface.

If the washer is placed on an uneven or weak

surface, noise or vibration may be occurred.

(Allowable is 2°) Filter at least 1 time a week.

1. Place a rag under the washer filter

2. Rotate the filter counterclockwise

the filter clockwise until it locks in position.

Remark: Should be cleaned

Never install the washer near water. CONNECTING THE DRAIN HOSE

Do not place the washer in steamy rooms or

where the washer is directly exposed to rain.

Moisture may destroy the electrical insulation

and cause an electrical shock hazard

Avoid direct sunlight or heating devices.

As plastic and electrical components are

affected by direct heat, never place the

washer near heaters, boilers, etc.

Do not place under direct sunlight.

(WITHOUT PUMP)

Install the drain hose(A) about 70\~80cm above the ground for pump model.

Diagram showing two scenarios of a water tank with labeled components and symbols, including a circle and cross symbol.

CLEANING THE MACHINE

CLEANING THE LINT FILTER

If the dregs are filled up in the lint filter after finishing the wash, push down(1) and pull it

out(2) as shown in figure.

Remove the collected lint and rinse the filter net.

Lint Filter

CLEANING THE WASH TUB

Wipe off strains on the cabinet and operation panel with soft cloth.

Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush.

Painted surfaces or plastic parts will be damaged.

OVERFLOW FILTER

Pull the upper side of the overflow filter with two fingers into the hole 'A' in the direction of

arrow as shown in the figure.

CLEANING THE COVER WINDOW SPIN

1. Rotate the cover window spin clockwise and pull out.

2. Cleaning the cover window spin.

3. Insert the cover window spin back and rotate it counterclockwise until locks in positon.

Remark : Should be cleaned the cover window spin at least 1 time a month.

Close Open Cover Window Spin

WASHING PROCEDURE

TO WASH

1. Before starting washing, check the following;

2. Connect the water supply hose and open the water tap.

3. Connect the power cord to the power supply outlet.
4. Lay the drain hose(A) down toward a sinkhole.

(WITHOUT PUMP)

- Place the drain hose(A) in sink or bath about 70\~80cm above the ground.

(WITH PUMP)

1. Set the WASH SELECTOR KNOB to the desired mode.
2. Set the CYCLE SELECTOR KNOB to 'WASHRINSE'. (In case no drain pump.) ('WASH' In case drain pump.)

(WITHOUT PUMP)

(WITH PUMP)

1. Set the WATER SELECTOR KNOB to WASH.

1. Load laundry in the wash tub.

1. Fill water in the wash tub and add the detergent.

1. Set the WASH TIME 1-15 minutes.

1. After washing, set the CYCLE SELECTOR KNOB to 'DRAIN' for drain.

SPIN DRY

1. Transfer the clothes into the spin basket and arrange the clothes evenly.

1. Be sure to attach the safety cover and close the inner lid.

1. Close the spin dryer lid.

1. Set the AIR TURBO SPIN TIMER 1-10 minutes.

1. Incomplete spining.(Severe vibration or unbalance) See "When you load ..." on page 6.

RINSING

1. Set the CYCLE SELECTOR KNOB to 'WASH RINSE'.(In case no drain pump.) ('WASH' In case drain pump.)

الس barrel شفاب Wash-Rinse الس barrel Drain العvetب اوره Cycle Selector (WHOUT PUMP) الس barrel Wash الس barrel Drain العvetب اوره Cycle Slector (WH PUMP)

1. Supply the proper amount of water as not to overflow the top of the washing tub.

1. Set the WASH TIMER 2\~3 minutes.
2. Drain the water. Set the CYCLE SELECTOR KNOB to 'DRAIN'.
3. Repeat this cycle until drain water is clean. (2\~3 cycles)
4. In case no drain pump.
5. Be sure lay the drain hose down. In case drain pump.
6. Be sure place the drain hose in sink or bath.

OVER FLOW RINSE

1. Keep suppling water

Adjust water pressure to ensure that the amount of water supplied does not exceed that water drained. Cycle Selector (WITH PUMP) (Without PUMP) (With PUMP)

1. Set the WASH TIMER 6\~8 minutes.

1. As soon as the WASH TIMER shuts off, turn off the water tap.

1. Set the CYCLE SELECTOR KNOB to 'DRAIN'.

ADDITIONAL RINSE

After rinsing you can select this course for more effective rinse (Don't select only this course for rinse.)

1 Load the laundry evenly. After stopping water into the spin basket, supply, cover the

4

laundry with safety cover and close the inner lid.

2 Set the WATER SELECTOR KNOB to SPIN(a) and CYCLE SELECTOR KNOB to 'DRAIN'.(b)

5

3 Supply water for about 1 minute. Set the AIR TURBO Adjust the water flow to prevent SPIN TIMER 2\~3 overflow from the wash tub.

6

LAUNDRY GUIDE

WASHING TIME

KINDS OF CLOTHING WASHING TIME		WASHING SELECTION
Extremely solid heavy fabric 10 to15minutes		NORMAL
Linen,cotton,etc. 8 to10m minutes
Ordinary clothes (underwear,etc)	7mInutes	SOFT
Slightly solied synthetic fiber 2 to 5minutes
100%wool,mixed wool knitting, thin synthetic fiber with tags indicating hand washing	2 to 5minutes

SPIN DRY TIME

TIME TYPE OF LAUNDRY
1 min. Thin(synthetic fiber)
1~2 mln. wool
3~5 min. cotton
5 min. thick(cotton)
10 min. (Air Turbo) thick(cotton)

DETERGENT

AMOUNT OF DETERGENT	WATER LEVEL
37 g	Low (37 l)
45 g	Mid (45 l)
54 g	High (54 l)

The amount of detergent is average. Follow the instruction detergent printed on the package for amount of detergent. Choose the amount of detergent depending on the fabric type.

MAINTENANCE

WHEN YOU LOAD THE LAUNDRY INTO THE SPIN BASKET.

Press the laundry evenly and put the safety cover into the spin basket drum as shown in the figure.

Bottom of balancer

Diagram showing three stages of a biological or chemical process with labeled arrows and symbols, likely illustrating a procedure or reaction sequence.

Safety cover

TO PICK OUT THE CLOTHING WHICH HAS FALLEN BETWEEN THE BASKET AND TUB.

For safety, pull the power supply plug out of the socket.

1. BDisassemble a screws from the spin dryer hatch.
2. BThe spin dryer hatch is fixed to the brim by the concave and convex parts at two places. Expand the concave and convex parts, and pull up the spin dryer hatch to remove it.
3. BRemove the clothing
4. BClose the spin dryer hatch. Push in hatch firmly until the catch at the front is engaged securely.

Spin dryer hatch Screw

TROUBLE SHOOTING

TROUBLE CHECK POINT TROUBLE CHECK POINT
1. The washer does not work.	Check that the power cord is connected to a power outlet well. Power stoppage?	4. Water dose not drain.	In case no drain pump.- Be sure lay the drain hose down.In case drain pump.- Be sure remove the cap-hose from the drain hole.← See “Before using...” on page 1.
2. Clothes will not move freely.	Is the laundry overloaded?!5. The spin	dryer basket will not run.	Is the spin dryer lid closed completely?Are laundry (socks,etc.) falling out of the spin dryer basket and clinging to the axle?← See “To pick out...” on page 6.
3. Incomplete spinning.(Severe vibration or unbalance.)	Are the laundry arranged evenly?← See “When you load...” on page 6.	6. The water drains out immediately.	In case no drain pump.- Is the Cycle Selector set to drain?- Is the drain hose clogged with scrap?← Hang up drain hose over the drain hose hook. Half fill the wash tub with the water and try for drain again.(Scrab will be removed by water drain pressure.)In case drain pump.- Is the drain hose hung about 70~80 cm above the ground?← See “Connecting the drain...” on page 3.

SPECIFICATION

DIMENSIONS (W x D x H)mm 792 x 465 x 951
WATER PRESSURE		0.05~0.78 MPa0.5 ~ 8.0 kg·f/cm2
WEIGHT	With out pumpS29 kg
	With pumpS31 kg
EXTRACTION EFFICIENCY 50 %
STANDARD QUANTITY OF WATER 54 l
MOTOR INPUT Washing 330 W / Spinning 160 W
MOTOR MAX INPUT 480 W
RATING TIME Washing 1 Hour / Spinning 15 minutes

Contact SAMSUNG WORLD WIDE

If you have any questions or comments relating to Samsung products,

please contact the SAMSUNG customer care center.

U.A.E

Line drawing of a microwave oven with control knobs and front panel (no text or symbols)

Diagram illustrating a mechanical setup with labeled components and a cross symbol indicating failure or failure.

ال bfine

انرك مساحة