1T-VGA-414 - Power strip TV One - Free user manual and instructions

USER MANUAL 1T-VGA-414 TV One

1.0 Introduction 2
2.0 Specifications 3
3.0 Package Contents 4
4.0 Connecting the Hardware 4
5.0 Operating The Unit 5
6.0 Troubleshooting 5
7.0 Optional Rack Mounting Accessory 5
8.0 Limited Warranty 6
9.0 Regulatory Compliance 7
10.0 Contact Information 7

1.0 INTRODUCTION

Thanks for purchasing this 1T-VGA-400 series Distribution Amplifier from TV One. Model 1T-VGA-412 provides two outputs from a single input, while model 1T-VGA-414 provides four outputs. Additional outputs can be provided by cascading additional Distribution Amplifiers. Our professional video conversion products have been serving the industry for over twenty years. TV One offers a full line of high quality Seamless Switchers, Video Scalers, Up/Down/Cross Converters, Analog-Digital Converters (SD/HD-SDI, HDMI, DVI), Format Converters, Standards Converters, TBC/Frame Synchronizers, Matrix Routing Switchers, Signal Distribution Amplifiers and Cat.5 Transmission Systems.

1.1 Liability Statement

Every effort has been made to ensure that this product is free of errors. TV One cannot be held liable for the use of this hardware or any direct or indirect consequential damages arising from its use. It is the responsibility of the user of the hardware to check that it is suitable for his/her requirements and that it is installed correctly. All rights reserved. No parts of this manual may be reproduced or transmitted by any form or means electronic or mechanical, including photocopying, recording or by any information storage or retrieval system without the written consent of the publisher.

TV One reserves the right to revise any of its hardware and software following its policy to modify and/or improve its products where necessary or desirable. This statement does not affect the legal rights of the user in any way.

All third party trademarks and copyrights are recognised. The TV One logo, TV One-task and CORIO are the registered Trademarks of TV One. All other trademarks are the property of their respective holders.

1.2 Features

Video Input

Signal Type RGBHV, RGBS, RGsB, YPbPr

Connector 1x HD-15 Female

R-G-B Level Range 0.5-2.0 Vp-p

Maximum Resolution 2560x1600

Video Outputs

1T-VGA-412 2x via HD-15 Female Connectors

1T-VGA-414 4x via HD-15 Female Connectors

General

R-G-B Bandwidth 500+MHz

Maximum Distance Up to 300' from amplifier (Note 1)

1T-VGA-412 Wt (Net) 370 g (0.81 lbs)

1T-VGA-414 Wt (Net) 400 g (0.88 lbs)

Environmental

Operating Temperature 0° to +40°C (+32° to +104°F)

Operating Humidity 10% to 85%, Non-condensing

Storage Temperature -20° to +60° C (-4° to +140° F)

Storage Humidity 10% to 85%, Non-condensing

Warranty

Limited Warranty 3 Years Parts and Labor

Power Requirement

External Power Supply 5VDC@2A - Locking Plug

Regulatory Approvals

Amplifier Units FCC, CE, RoHS

Power Supplies UL, CUL, CE, PSE, GS, RoHS

Accessories Included

1x Power Adapter US, UK or Euro

2.1 Input/Output Signals

Pin #	Signal Pin # Signal
1	Red video 9 NC
2	Green video 10 Ground
3	Blue video 11 NC
4	ID2 12 DDC SDA
5	Ground 13 Horizontal Sync
6	Analog Ground 14 Vertical Sync
7	Analog Ground 15 DDC SCL
8	Analog Ground

3.0 CHECKING PACKAGE CONTENTS

Before attempting to use this unit, please check the packaging and make certain the following items are contained in the shipping carton:

• 1x Distribution Amplifier
• 1x Power Adapter with 5VDC Output
• 1x User Manual

Note: Please retain the original packing material should the need ever arise to return the unit. If you find any items are missing, contact your reseller or TV One immediately. Have the Model Number, Serial Number and Invoice available for reference when you call.

4.0 CONNECTING THE HARDWARE

The front of the device has a single LED that indicates when power is applied and the rear panel has the power connection, input connection and either two or four output

5.1 Connect the Unit as follows:

1. Turn off power to Source Device (such as PC) and to all Destination Devices (such as Monitors)
2. Connect the output of the Source Device to the Amplifier's Input with an HD-15 cable
3. Connect the input of the Destination Devices to the Output Connectors of the Amplifier with high quality HD-15 cables, up to 300 feet in length
4. Plug the DC Connector from the 5VDC Power Adapter provided into the Amplifier
5. Twist the DC Connector after inserting it to lock it in place
6. Plug the Power Adapter into an AC Outlet
7. Turn on power to the Source and Destination Devices

Note: If you connect a DDC Monitor to Output 1 of the Amplifier, all the other Monitors must be able to support the same high resolution as the DDC monitor.

5.2 Cascading

To display the same image on more Monitors than available amplifier outputs permit, you may cascade additional amplifiers. Connect the input of the additional amplifier with an HD-15 cable to an output of the original Amplifier. Caution - Signal degradation may occur if too many Amplifiers are cascaded.

6.0 TROUBLESHOOTING

Problems with the 1T-VGA-400 series of Distribution Amplifiers are rare. Most of the time, the problem is caused by the use of an incorrect cable for the signal type, to long a cable run, bad connectors on the cable and occasionally damaged cables. Bad grounds or use of different AC power sources for the 1T-VGA-400 Series Distribution Amplifier, Signal Source and/or Display Device(s) may also cause problems due to ground loops.

1T-VGA-400 SERIES DA

Filler

1T-VGA-400 SERIES DA

1T-VGA-400 SERIES DA

Filler

To mount two 1T-VGA-400 series units, first fasten a short rack ear attachment to the left side of the first 1T-VGA-400 series unit and fasten another short rack attachment to the right side of the second unit. Attach the "U" shaped filler piece between the two 1T-VGA-400 series units. To mount a single 1T-VGA-400 series product, fasten a short rack ear attachment to the left side of the unit and the long filler attachment to the other side.

8.0 LIMITED WARRANTY

TV One warrants the original purchaser that the equipment it manufactures or sells will be free from defects in materials and workmanship for a fixed term from the date of purchase. The warranty term for specific product lines is defined below.

1. TV One branded products based on TV One's CORIO technology are warranted for a period of five years from the date of purchase. This includes products with the model number prefix of C2, 1T-C2, CX, A2 or S2.
2. TV One-task branded products, other than those based on TV One's CORIO technology mentioned above, are warranted for a period of three years from the date of purchase. This includes products with the model number prefix of 1T, with the exception of 1T-C2.
3. LCD Monitors are warranted for a period of three years from the date of purchase, with the exception of the LCD people interested into the monitors that are supplied

designated by TV One, freight prepaid. After repairs are complete, the product will be returned, freight prepaid.

LIMITATIONS - All products sold are "as is" and the above Limited Warranty is in lieu of all other warranties for this product, expressed or implied, and is strictly limited to two years from the date of purchase. TV One assumes no liability to distributors, resellers or end-users or any third parties for any loss of use, revenue or profit.

TV One makes no other representation of warranty as to fitness for the purpose or merchantability or otherwise in respect of any of the products sold. The liability of TV One with respect to any defective products will be limited to the repair or replacement of such products. In no event shall TV One be responsible or liable for any damage arising from the use of such defective products whether such damages be direct, indirect, consequential or otherwise, and whether such damages are incurred by the reseller, end-user or any third party.

9.0 REGULATORY COMPLIANCE

The 1T-VGA-400 Series Distribution Amplifiers have been tested for compliance with appropriate FCC and CE rules and regulations. The Power Adaptor/Supplies have been tested for compliance with appropriate UL, CUL, CE, PSE, GS Rules, Regulations and/or Guidelines. These Products and Power Adapters are RoHS Compliant.

10.0 CONTACT INFORMATION

Should you have questions or require assistance with this product in areas not covered by this manual, please contact TV One at the appropriate location.

TV One USA

2791 Circleport Drive

Erlanger, KY 41018

USA

Tel [phone]

Fax [phone]

[e-mail]

www.tvone.com

TV One Europe

Continental Approach

Westwood Industrial Estate

Margate, Kent CT9 4JG, UK

Tel [phone]

Fax [phone]

[e-mail]

www.tvone.eu

TV One Latin America

6991 NW 82 Avenue #8

Miami, FL 33166

USA

Tel [phone]

Fax [phone]

[e-mail]

www.tvonela.com

TV One Mercosur

Av. Diaz Velez 3965 #PB

(1200) Capital Federal

Buenos Aires, Argentina

Tel [phone]

Fax [phone]

[e-mail]

www.tvonela.com

TV One Asia

16F-4, NO.75, Sec. 1

Hsin Tai Wu Road, Hsichih

Taipei Hsien 22101

Taiwan R.O.C.

Tel [phone]

Fax [phone]

[e-mail]

www.tvoneasia.com

TV One China

Rm. 1007, Golden Peach Bldg.

No. 1900 Shangcheng Road

Pudong, Shanghai

China 200120

Tel [phone]

Fax [phone]

Email: [e-mail]

www.tvonechina.com