O2B6M - Security Camera Speco Technologies - Free user manual and instructions

USER MANUAL O2B6M Speco Technologies

Exterior view of a black security camera with dual lens (no visible text or symbols)

Noce

Thank you for purchasing this product. This guide is designed to be a reference tool for the product. Please read it carefully before operang the product and retain it for future reference. Should you require any technical assistance, please contact Speco Technologies Technical Support.

CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICES TO QUALIFIED PERSONNEL

The lighting flash with an arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of non-insulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

INFORMATION

This equipment has been tested and found to comply with limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at its own expense.

WARNING

• If any liquid or solid matter gets into the housing, immediately disconnect the camera from power supply and have it checked by your authorized dealer before reusing.
• Avoid installing the camera at extremely hot or cold places.
• If you are not a certified person, never try to dismantle the camera.
  To avoid electric shock, never remove the screws or covers. There are no parts inside that need maintenance by the user. All maintenance should be carried out by qualified personnel.
• Avoid installing the camera at a place of high humidity.
• Avoid installing the camera at the place exposed to gas or oil.
• Keep the top glass of the lens always clean in order to obtain the best picture quality all the time. Be careful not to be stained by fingerprint.
• Don't face the camera directly toward sunlight or sunlight reflecting area.
  IMAGE SENSOR may go defective at this condition.
• Please give a special attention to keep the unit from dangerous drop or external shock during the process of transportation or handling.
• Never try to touch the camera in wet hand. It may cause an electric shock.
• Do not expose the camera to radioactivity. It causes a serious damage on the IMAGE SENSOR.

LIMITATION OF LIABILITY

This publication is provided "AS IS" without warranty of any kind, either express or implied, including but not limited to, the implied warranties of merchantability, fitness for any particular purpose, or non-infringement of the third party's right.

This publication could include technical inaccuracies or typographical errors. Changes are added to the information herein, at any time, for the improvements of this publication and / or the corresponding product(s).

DISCLAIMER OF WARRANTY

In no event shall seller be liable to any party or any person, except for replacement or reasonable maintenance of the product, for the cases, including but not limited to below :

(1) Any damage and loss, including without limitation, direct or indirect, special, consequential or

• Supports CBR (Constant Bit Rate) and VBR (Variable Bit Rate) modes
• Supports Tampering-Alarm in VA (Video Analytics) function
- Controllable frame rate
• Privacy Masking up to 8 areas
• Supports IEEE 802.3af Power over Ethernet injectors, mid- and end-spans
- HTTPS supported (Hyper Text Transfer Protocol Secured)
• DDNS and DHCP client

Specification

CLASSIFICATION		Night Vision Outdoor IR Camera
General	CPU	ARM1176JZF-StM (400 MHz, Instruction cache : 32kbyte, data cache : 16kbyte, MMU)
	Flash	2Gbit Flash Memory
	SDRAM	2Gbit DDR3 Memory
Image Pickup	Image Sensor	2.0 Megapixel 1/2.9" SONY progressive scan CMOS image sensor
	Total Pixels	1952(H) x 1116(V) 2.18 Megapixel
	Effective Pixels	1944(H) x 1104(V) 2.14 Megapixel
	S/N Ratio	More than 50dB
	Min. Illumination	0Lux (IR On)
	IR Distance	40M
	Day & Night	ICR Filter Changer
	Lens Control	Motorized Lens Control
	Lens	3 ~ 12mm Vari-focal Motorized Megapixel Lens
Video	Video Compression	H.264 High profile
	Resolutions	Up to 1920 x 1080
	Frame Rate	H.264 Up to 30fps with 1920 x 1080, H.264 Up to 30fps with VGA
		MJPEG Up to 30fps with VGA resolution
	Video Streaming	Support multi stream with H.264, MJPEG
		Adjustable frame rate
		VBR / CBR in H.264
		Brightness, Contrast, Sharpness
		Day & Night
Environment	Operating Temperature	-10 degree ~ 50 degree Celsius (-14F ~ 122F)
	Storage Temperature	-20 degree ~ 60 degree Celsius (-4F ~140F)
Software	Included Software	IP Scanner (Windows only)
Package	Package Contents	Network Camera, Use Manual, External Power Adaptor(option)

※ Specifications are subject to change without prior notice for improvement.

2. NAME AND FUNCTION OF EACH PART

2.1 Package Contents

APPEARANCE	DESCRIPTION
	IP Camera x 1
	Installation Guide x 1
111	Tapping screw (∅4 x 30) x 3
	Plastic anchor x 3
	L-Wrench (3mm) x 1
	CD x 1
1111	Tapping screw ( 4 × 30 ) x 4
	Plastic anchor x 4
	Screw PH (M4 x 8) x 3
	Screw PH (M4 x 12) x 4

2.2 Name and Function

Technical diagram of a mechanical device with numbered components and an arrow indicating assembly or transformation.

NO.	ITEM	DESCRIPTION
1	Power Connector	DC12V
2	Network and POE Connector	POE (Power over Ethernet) and LAN cable
3	Lens	3 ~ 12mm Vari-focal Motorized Megapixel Lens

Plastic anchor x 3 (A) L-Wrench Tapping screw (∅4 x 30) x 3

• Wall

Technical diagram of a mechanical device with labeled parts and exploded view

Ceiling Tile Plastic anchor x 4 Junction Base Sponge Junction Box Assembly Tapping screw (∅4 x 30) x 4 Top Adapter Plate Top Rubber Finish with Super X Camera Ass'y PH (M4 x 8) x3 PH (M4 x 12) x4

graph LR
    A["Local Access"] --> B["LAN Switch"]
    B <--> C["Router"]
    C <--> D["Internet"]
    D <--> E["Remote Access"]
    E <--> F["Local"]
    E <--> G["E-Mail / FTP"]
    B <--> H["WWW"]
    C <--> H
    D <--> H
    E <--> H

3.3.2 Connecng to the Network

Open up IP Scanner.

IP Scanner can search for the device on the local network.

Please note that only devices that are on the same subnet can be discovered.

The device is set to DHCP mode by default.

In the device list, you can view the IP address, model number, and MAC address of each device. Select the applicable device and double click to open up the web viewer.

Refresh	Open Web Page	Login...	IP	Restart	Factory Default	Information	About
Status	Name	IP Address	MAC Address	Version
Online	03044	192.168.56.128	00:07:18:FF:03:73	1.0.57
Online	0304	192.168.56.123	57:43:02:10:78:04	1.0.53

Enter the IP address here

2) Enter the user name and password when prompted.
3) Default user name is admin and password is 1234.
4) If prompted for installaon of the Acve-X plug-in, allow the installaon. Acve-X is needed to view video from Internet Explorer.