HT7815DNVW - Security Camera Speco Technologies - Free user manual and instructions

USER MANUAL HT7815DNVW Speco Technologies

HT7815DNV (Grey Housing)

HT7815DNVW (White Housing)

HT7915DNV (Grey Housing)

HT7915DNVW (White Housing)

560 Line Color Bullet Camera

Weatherproof, Day/Night High Resolution

Wall & Ceiling Mountable

speco technologies®

Please read this manual thoroughly before operation and keep it handy for further reference.

WARNING & CAUTION

CAUTION CAUTION: TO REDUCE THE RISK OF ELLICHE SHOCK DO NOT REMOVE COVER (DR BACK) NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lighting flash with an arrowhead symbol, within an aquilateral triangle is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (serving) instructions in the literature accompanying the appliance.

INFORMATION This equipment has been tested and found to company with limits for a class a digital device Pursuant to part 16 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference. When the equipments operated in a commercial environment, this equipment generates, uses, and Can Radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may Cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which Case the user will be required to correct the interference at his own expense.

WARNING - Change or modification not expressly approved by the manufacturer could void the user's authority to operate the equipment

CAUTION: To prevent electric shock and risk of fire hazards.

DO NOT use power sources other than that specified.

DO NOT expose this appliance to rain or moisture.

This installation should be made by a qualified service person and should conform to all local codes.

CONTENTS

Package Contents 4
Precautions 5
Features 6
Camera Installation 7-12
LED Pattern 13
Specifications 14
Dimensions 15
Warranty 16

PACKAGE CONTENTS

Please make sure that the following items are included in the package:

1 HT7815 (7915) Camera Series
4 Mounting Screws
1 Video test Connector
1 Wrench

Please leave this manual with the end-user for future reference.

PRECAUTIONS

• THIS CAMERA SHOULD BE ONLY INSTALLED BY QUALIFIED PERSONNEL
  • TO PREVENT A FIRE OR ELECTRICAL HAZARD PLEASE USE PROPER POWER CABLE
  • DO NOT CLEAN THE COVER WITH AN ABRAISIVE CLEANING MATERIAL - PLEASE USE A SOFT CLOTH OR TISSUE TO CLEAN THE COVER
• THERE ARE NO USER-SERVICEABLE PARTS INSIDE. PLEASE DO NOT DISASSEMBLE THIS CAMERA OTHER THAN TO MAKE INITIAL ADJUSTMENTS
• PLEASE USE A UL APPROVED REGULATED 24 VOLT AC OR 12 VOLT DC POWER SUPPLY
• PLEASE USE APPROPRIATE LOW VOLTAGE POWER CABLE TO PREVENT FIRE OR ELECTRICAL SHOCK
• PLEASE INSURE THAT YOUR INSTALLATION AREA CAN SUPPORT THE WEIGHT OF THE CAMERA
• PLEASE HANDLE THIS CAMERA CAREFULLY:
• DON'T USE A STRONG OR ABRASIVE DETERGENT WHEN CLEANING THE CAMERA.
• DON'T EXPOSE THE CAMERA TO DIRECT SUN

FEATURES

• 1/3" SONY Super-Had HQ-1* CCD, 560TVL HQ-1 DSP
- External lens control of zoom and focus
- Split Glass Technology eliminates IR reflections
• 48 Mini IR LEDS (150' Range – HT7815DNV/W)
- 24 IR LEDs + 6 Super IR LEDs (330' Range - HT7915DNV/W)
- Mechanical day/night IR cut filter
- Lux level dip switch controls when the camera switches into B/W Mode - CDS Sensor
- UTP function built-in for use with twisted pair wiring in addition to standard coax
• Day/night DC Varifocal auto iris lens (2.8 \~ 12mm)
• Video test connector for easy installation
- Dual voltage operation
-Weatherproof sunshield
• Built-in heater extends operating range and eliminates condensation
- Easy access bottom panel controls (BLC, ELC, F/L, L/L)
• Insulated mount reduces ground loops
• Cable runs through the mount for protection

CONNECT POWER CABLE

1. WHEN USING 12 VOLTS DC (constant voltage 500 mA)

1. WHEN USING 24 VOLTS AC (40 Volt Amps)

1. CONNECT VIDEO CABLE

-Connect BNC Cable To The BNC Jack.

1. UTP OUTPUT

-Allows use of the camera with Cat-5E or UTP cable. A Receiving Balun must be used on the monitor side. Please see our model VID-UTP

Bottom Controller Details

graph TD
    A["1.V-Phase Down"] --> B["PHASE DOWN"]
    C["2.LED Level"] --> D["LED LEVEL"]
    E["3.DC Lens Level"] --> F["FUNCTION"]
    G["5.Function"] --> H["LUX LEVEL"]
    I["1.V-Phase Up"] --> J["VIDEO TEST"]
    K["4.Video Test"] --> L["VIDEO TEST"]
    M["6.LUX Level"] --> N["LUX TEST"]
    B --> O["DC LENS LEVEL"]
    D --> P["F/4"]
    F --> Q["LUX LEVEL"]
    H --> R["LUX LEVEL"]
    L --> S["LUX LEVEL"]

1. V-Phase Level (UP/Down)

When desired, the vertical phase may be adjusted to synchronize the vertical phase of the camera with other cameras in the system. This feature is only available in 24 Volt. AC operation.

2.LED Level

Adjust the LED brightness

3.DC Lens Level

Fine tune the Auto IRIS Lens

4.Video Test Connector

Allows the connection of a Local Monitor to make initial adjustments to the camera

5.Function

* DIP SWITCH

(1)ELC

(2)BLC

(3)F/L

(4)L/L

(1) ELC- Electronic Light Compensation

ON : Camera is in Electronic Shutter Mode

OFF: Electronic Shutter is fixed at 1/60 and Auto Iris mode is active

(2) BLC-Back Light Compensation.

BLC: If there is a strong light behind an object the object may appear as a shadow. Activating the BLC will minimize this effect. The Coverage of the BLC is center plus bottom.

(3) F/L- Flicker-Less

ON: Use when the LUX changes often

OFF: Use under normal circumstances

(4) L/L- Line Lock

Locks the camera to the 60 Hz of the wall outlet. Only operates in the 24 Volt AC mode

6. LUX DIP SWITCH

: Tells the camera when to switch to the B/W night mode.
: Only one switch can be in the "on" position at a time.

1 STEP - The camera will switch at 1/2 lux

2 STEP - The camera will switch at 1 lux

3 STEP - The camera will switch at 3 lux

4 STEP - The camera will switch at 5 lux

Zoom & Focus Adjustment

ZOOM CONTROLLER ① ZOOM CONTROLLER ② FOCUS CONTROLLER

• Loosen the fixed screws in each ring of Focus & Zoom properly and adjust zoom or focus ring to take a right picture and then fix the set screw again.
• Be careful of not putting too much strength when adjustment.

COMPATIBILITY

★Original Mounting

Flange

Should be removed

to use the CVCTPLATE

[CVCTPLATE Hole Description]

Hole 1 : CVCTPEXT

Hole 2: Electrical Box "B" type

Hole 3 : Electrical Box "A" type

COMPATIBILITY
BCP (USING 7246WMT)
CVCTPEXT
CVCTPLATE

WMT)

BCP (Direct connection)

LED PATTERN

HT7815DNV (W)

2.8-12mm VF lens

48 Mini IR LEDs (150' Range)

HT7915DNV (W)

5-50mm VF lens

24 IR LEDs + 6 Super IR LEDs (330' Range)

SPECIFICATIONS

ITEM HT7815DNY & HT7915DNY Series
Image Sensor 1/3" Sony Super-Haz HQ-4" DSP CCD
Resolution 500 TV Line
Minimum illumination 0.63lux (IP On) 0.00	LUX (IR on)
Lens Type	Day / Night DC Auto Iris Virfallal Lens2.8-12mm (HT7815) / 5-50mm (HT7915)
CDS Sensor Photocouductive Cells, Adjustable
Electronic Shutter	1/60 - 1/1300,000 seconds
Video Output 1.0vps into 75 ohms composite
TV System NTSC
Scanning System 2 : 1 Interface
Sync System Line Locked / Adjustable V-Phase, Line Lock/Internal On-Off
5N Ratio More than 60gb
IR Cut Filter Mechanical - Auto Adjusts when required
Power Supply 24 Volts AC, 12 Volts DC - Dual Voltage
Power consumption 550mA (HT7815), 85mA (HT7915)
Operating Temperature	-29° - +50° (-20° - -122°)
Operating Humidity	30%-90%RH
Weight	3 Ibs
Warranty	5Years

DIMENSIONS

HT7815DNV Series

HT7915DNV Series

WARRANTY

LIMITED WARRANTY

THIS WARRANTY IS VALID ONLY ON PRODUCTS PURCHASED AND USED IN THE UNITED STATES OF AMERICA. THIS WARRANTY APPLIES ONLY TO THE ORIGINAL USEIL

SUBJECT TO CONDITIONAL AND EXCLUDING FOUND BELOW THIS PRODUCT IS WARRANTED AGAINST MANUFACTURING DEFECTS IN MATERIAL AND WORKMANSHIP FOR THE FOLLOWING PERIOD FOR PARTS AND LABOR.

SPEED TECHNOLOGIES CAMERAS: 5 YEARS
SPEED TECHNOLOGIES MONITORS: 1 YEAR
BALANCE OF SPEED TECHNOLOGIES LINE: 1 YEAR*
* IR LEDs, Time lapse VCR Drum Assemblies & Heads: 90-DAYS

SPEGA TECHNOLOGIES WILL REPROACH REPLACE (IN YOUR DISCRETION) ANY PARTS FOUND TO BE DEFECTIVE FOR THE WARRANTY PERIOD SPECIFIED. WE WILL PROVIDE A/REPLACEMENT FOR ANY DEFECTIVE PART.

CONDITIONS

1. YOU MUST OBTAIN A RETURN AUTHORIZATION NUMBER FOR ANY MERCHANDISE BEING RETURNED TO SPECO TECHNOLOGIES, WHETHER FOR RETURN/EXCHANGE OR REPAIR, WHETHER IN OR OUT OF WARRANTY

2. THIS WARRANTY WILL BE HONOPED ONLY UPON PRESENTATION OF THE ORIGINAL DATED BILL OF SALE OR SALES SUP.

3. TRANSPORTATION OF THE PRODUCT TO OUR SERVICE DEPARTMENT IS THE RESPONSIBILITY OF THE REFERENCE ON REPLACEMENT. WILL BE RETURNED PREMIXING THE WARRANTY PERIOD.

EXCLUSIONS

1. THIS WARRANTY SHALL NOT COVER ADJUSTMENT OF CUSTOMER OPERATED CONTROLS AS EXPLAINED IN THE APPROPRIATE WRITTLE OF DISCUITATION MANUAL ON PRODUCTS WHICH HAVE BEEN AS CHED ABOUT OR HAVE MISSING OR ALtered NORMAL NUMBERS.

2. THIS WARRANTY SHALL NOT APPLY TO UNCRATING, SETUP, INSTALLATION, OR THE REMOVAL AND RENINSTALLATION OF PROJECTS, CONTRACTORS.

3. THIS WARRANTY SHALL NOT APPLY TO REPAIRS OR REPLACEMENTS NECESSATED BY ANY CAUSE BEYOND THE RESULT OF MANUFACTURE INCLUDING, BUT NOT LIMITED TO ANY MAFUNCTION, EFFECTS OR FAILURE CAUSED BY OR RESULTING FROM UNAUTHORIZED SERVICE OR PARTS, IMPROPER MAINTENANCE, MODIFICATION OR REPAIRS BY THE USER, ABUSE, MISURE, REFLECT ACIDENT, FIRE, FLOOD, OR OTHER ACTS OF NATRIC, INCORRECT LINE VOLTAGE, DAMAGE OR INJAGE BURDS TO TELEVISION, PICTURE TUBES CAUSED BY OR ATTRIBUTABLE TO THE USE OF ANY ACCESSORY ELECTRONICS GAME OR DEVICE, OR DAMAGE CAUSED TO IMAGE PICKUP DEVICES BY ECESSIVE LIGHT.

THE FORSOACH IS IN USE OF ALL OTHER EXPRESSO WARRANTIES AND WE DO NOT AUTHORIZE ANY PART TO ASSUME FOR US ANY OTHER OBLIGATION OR LIABILITY IN NO EVENT SHALL BE BELIABLE FOR INCIDENTAL OR CONSIDENTIAL DAMAGES ARISING FROM THE USE OF THIS PRODUCT, OR FOR ANY DELAY IN THE USE OF THIS PRODUCT DUE TO CAUSES BEYOND OUR CONTROL.

SOME STATES DO NOT ALLOW LIMITATIONS OF HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF CONSEQUENTIAL DAMAGES. THE ABOVE LIMITATIONS ON IMPLIED WARRANTY AND CONSEQUENTIAL DAMAGES MAY NOT APPLY TO YOU.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHER RIGHTS WHICH WAY FROM STATE TO STATE

NOTE: FOR YOUR PROTECTION IN THE EVENT OF THEFT OR LOSS OF THIS PRODUCT. PLEASE FILL IN THE INFORMATION REQUESTED BELOW AND RETAIN WITH YOUR SALES RECEIPT.

MODEL NO (LOCATED ON BACK OF BOTTOM OF UNIT)

SERIAL NO.

DATE OF PURCHASE

WHERE PLACHASED

FURCHASE PRICE

Speco Technologies

206 NEW HIGHW AMITVILLE NY 1701 www.specotech.com

FOR MORE INFORMATION REGARDING

SERVICE OR RETURN CALL US TOLL FREE: 1800-645-5316 IN METRO NY. 831-957-8700

ALWAYS WE DISCRETION WHEN INSTALLING VIDEO AND/OR AUDIO SURVILLANCE EQUIPMENT ESPECIALLY WHEN THIS IS AN EXPECTATION OF PIRACY, INCOME RECOATING FEDERAL, STATE AND/OR LOCAL REGULATIONS APPLICABLE TO THE LAWSA INSTILLATION OF VIDEO AND/OR AUDIO RECORDS OR SURVEILLANCE EQUIPMENT PARTY CONSENT MAY BE REQUIRED.

MEMO

MEMO

MEMO

speco technologies®

200 New Highway

Amityville, NY 11701

631-957-8700

www.specotech.com

Rev. 100120

Speco Technologies is constantly developing product improvements.

We reserve the right to modify product design and specifications without notice and without incoming any obligation.

End without imposing any obligation.