O2D5M - Security Camera Speco Technologies - Free user manual and instructions

USER MANUAL O2D5M Speco Technologies

Be careful not to cause any physical damage by dropping or throwing the camera. Especially keep the device out of reach from children.

Do not disassemble the camera. No after service is assumed when disassembled.

Use only the power adapter provided with the camera.

Be careful to prevent moisture or water penetration into the unit. Attention is needed when installing the camera. The screw holes for the installation screws and pipe should be maintained water tight during the whole life time of the product.

All of the electrical connection wires running into the unit should be prepared so that water from the outside cannot flow into the unit through the surface of the wires. Penetration of moisture through the wire for an extended period can cause malfunction of the unit or deteriorated image.

Note

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on the year in

Caution

Any changes or modifications in construction of this device which are not explicitly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Revision History

Date Revision Details
Aug 18, 2015 190	+irst manual revision creation9

Contents

Contents....4

1. Introduction......5

1.1.%verview 5

1.2. >pecifications.... 6

1.3. Applications of %2D5M....7

1. Product Description 8

2.1.Contents 8

2.2. Product Preview 8

2.3. Physical description 9

2.4. +functional Description....11

2.5. Accessories for installation ....12

1. %n >ite Installation.... 13

3.1. Installation....13

1. Getting >tarted 14

4.1. PC >ystem Requirements .... 14

4.2. Quick Installation Guide....15

1. Troubleshooting 19

5.1. No power is applied....19

5.2. Cannot connect to the camera....20

5.3. Technical Assistance....21

1. Introduction

1.1. Overview

The %2D5M is a state-of-the-art mega-pixel, dual-codec (H9264, MJPEG) IP/network camera built with embedded software and hardware technology9 It enables real time transmission of synchronized video of up to 1080p and audio data9 Remote clients can connect to %2D5M for real time video/audio data through various client solutions running on PCs and smartphones9 Real time 2-way communication is available through the bidirectional audio communication feature9 Designed to be a stand-alone streaming audio & video transmission device, %2D5M can be applied to various applications such as video security, remote video monitoring, remote education, video conference or internet broadcasting system9 Vandal proof and weather proof housing will extend the application area to harsh environments of wide temperature ranges9 Integrated PoE (Power over Ethernet, IEEE 80293af) will reduce the total cost of ownership by reducing on-site wiring for installation9

1.2. Specifications

LENS
Lens Type 3.3~10mm Motorized Focus Lens
Lens Iris Control DC Auto Iris
CAMERA
Image >ensor 1/2.8" 2 Mega Pixel >ony CMO>
Minimum Illumination IR LED Off : 0.5Lux, IR LED On : 0Lux
>canning Mode Progressive >can
Dynamic Range (D-WDR) 74.7dB or Higher (90dB or higher)
Electronic >hutter Auto
IR LED 24pcs (850nm)
VIDEO
Compression Algorithm H.264, MJPEG
Compression Resolution 352X240, 704X480, 1280X720, 1920X1080
Bitrate Control H.264-CBR/VBR (up to 12Mbps)
Maximum Frame Rate	30fps @ 1920X1080 + 30fps @ 4CIF
Multi >tream	Primary, >secondary, Tertiary
AUDIO
Compression Algorithm G.726 (16KHz), G.711 μ - Law (8KHz)
INPUTS/OUTPUTS
Video Output	1 Composite, 1 Vp-p
Audio Input	1 line in
Audio Output	1 line out

O2D5M User's Manual

Operating Temperature 14"+ to 122"+ (-10°C to 50°C)
Operating Humidity 0% to 90%
Power >supply 12 VDC, PoE (Power over Ethernet) (IEEE 802.3af, Class 3)
Power Consumption Max. 4.8W
Approval +CC, CE, IP66

Specifications are subject to change without notice.

1.3. Applications of O2D5M

• security surveillance (buildings, stores, manufacturing facilities, parking lots, banks, government facilities, military, etc.)

• Remote monitoring (hospitals, kindergartens, traffic, public areas, etc.)
  • Teleconference (BI-directional audio conference). Remote Learning, Internet broadcasting
  • Weather and environmental observation

2. Product Description

2.1. Contents

The product package contains the following:

Contents	Description Image		Remarks
Main Body	%2D5M
Tools and Mounting Screws	>crew M4X25 4EA, >crew MMX8 3EA L Wrench 1FA, Core 1FA
CD	>software & User's Guide
Quick Reference Guide	Quick installation guide	[4CCS]
GPL License	%pen >ource Guide

2.2. Product Preview

O2D5M User's Manual

2.3. Physical description

293919 External View

Technical line drawing of a mechanical or electrical component with spherical elements and central bore (no text or symbols)

Figure 2-1. External view of O2D5M

293929 Dimensions

Circular mechanical component diagram with concentric rings and mounting holes, no text or symbols present

3.94°/da 1.61° 4.49°

293939 Connector information

① ② ③ ④ 1 PINK 2 BLU 3 WHT 4 QRY ⑤ ⑥ 1 BRN 2 GRN 3 LIGHT 4 ORG

1. Network Port 2. BNC Video Out 3. Power In
2. Ground 5. Audio In/Out 6. Alarm In/Out

Figure 2-3. Connector information

2.4. Functional Description

• Power

Power input for supplying 12V 1A DC power

Caution: If O2D5M is powered by PoE, do not plug in DC Jack with active DC power into DC power connector.

• Audio (MIC/LINE) IN

Connect external audio source or microphones

- Audio (Line) In

Connect speakers with built in amplifier9Audio from remote sites is output through Line out in bi-directional audio mode9

• RJ-45 Ethernet (100Base-T) / PoE (IEEE802.3af)

100Mbps Ethernet connector (RJ-45) with standard PoE (80298aft)

- SENSOR IN

Connect external alarm sensor9 Examples of sensing devices are infrared sensor, motion sensor, heat/smoke sensor, magnetic sensor, etc9 Connect the two wires of the sensors to "Sensor In"9 The sensor type (NC/NO) can be set in the admin page9 Multiple sensor devices can be connected in parallel

- Factory Default Switch

A switch provided for returning the IP camera to factory default state9 Unscrew the cover to access the switch9 Press the switch about 5 seconds while power is applied9

Close-up of a mechanical component with a highlighted circular feature and mounting holes (no visible text or symbols)

Factory default switch
Figure 2-5. Factory Default Switch

2.5. Accessories for installation

INTWM CVCJBD DFM INTCM INTPM

3. On Site Installation

Use cables and conduits that are suitable for the installation9. Close attention should be paid to the installation so that no moisture is allowed to penetrate into the unit through the cables or conduits during the lifetime of the product9. Products that have internal parts exposed to moisture due to improper installation are not covered by warranty9

3.1. Installation

BASE ASSEMBLY TAPPING SCREW 4x25, 3EA DOME COVER ASSEMBLY

4. Getting Started

Brief information for the initial operation of %2D5M is provided in this chapter.

4.1. PC System Requirements

Audio/Video streaming data received from %2D5M can be displayed or stored in a PC running client programs. Minimum requirements of the PC are described below:

Minimum Requirements Recommended Specifications
CPU Intel Core i3 Intel Core i5
Main Memory 2GB 4GB
%perating >system Windows XP Windows 7,8 (64bit)
Web Browser	Internet Explorer 8	Internet Explorer 8 or higher
Graphic Card	Video RAM 256MB or moreResolution 1920x1080	Video RAM 1GBResolution 1920x1080
Network	100 Base-T Ethernet	100 Base-T Ethernet

* 0%ardina software connected Windows VD / Vieta 17 / 0

4.2. Quick Installation Guide

1. Connect PC and O2D5M to network.

1) Prepare a PC to run programs for the installation and video connection
2) In the case of using PoE, connect the PC and %2D5M to the network using one of the following ways9
If your LAN >witch does not support standard PoE, connect %2D5M as shown in dotted line In +Figure 4-19 The DC power is applied through DC adapter9

graph LR
    A["Computer"] -->|DC adapter| B["LAN switch"]
    B --> C["LAN switch with standard POE"]
    C --> D["Monitor"]

Figure 4-1. Power and network connection

2. Install IP Scanner

IP >canner is a utility to discover IP cameras on the local network. The camera is set to DHCP mode out of the box?

+ollow the sequence below to access the camera settings

13 Install IP >canner on the PC that will be used on the same local network as the IP camera9 IP >canner can be found on the CD Included in the package or downloaded from specotech9com
ii3 *un IP >canner
iii3 The available cameras on the local network will show automatically
iv3 Highlight and double-click on the applicable model to launch the camera web viewer 6ceafault browser must be set to Internet @xplorer to view video

Status	Name	IP Address	MAC Address	Version
Online	O2D7M	192.168.56.169	00:03:22:1E:97:8A
Online	O2DP8M	192.168.56.163	00:03:22:1E:97:6B	1.0.0
Online	O2MB1	192.168.56.17	00:07:18:FF:01:C9	1.0.59
Online	O2D4	192.168.56.124	5C:F2:07:1C:28:CA	1.0.53
Online	VIP2PT21ZX	192.168.56.52	00:07:D8:17:8A:68	1.3.7-X1_release
Online	OSMDP1	192.168.56.146	5C:F2:07:1C:23:D8	1.0.47
Online	Eddie-O2DP8	192.168.56.129	5C:F2:07:1C:1F:74	1.0.51
Online	SID-O2PT234D5W-...	192.168.123.119	5C:F2:07:1C:15:68	1.0.41
Online	OPTZ36X1	192.168.56.140	5C:F2:07:1C:03:1D
Online	O81	192.168.56.105	5C:F2:07:1C:01:3B
Online	O2D7M	255.255.255.255	00:00:00:00:00:00

3. Remote video connection to O2D5M

1) Connection through Web Viewer

The web viewer offers the simplest way to connect to the 2D5M9+or video connection, enter the IP address of %2D5M in the Internet Explorer address bar as:

[e.g.] Part 80

Port 80 (default) can be omitted

[e.g.] Part 8080

http://172.16.64.133:8080/

Note : When prompted, install and allow the Active X controls as needed

speco technologies® ID PASSWORD [LOGIN]

O2D5M User's Manual

Setup 12:30:25 12:30:25 Memo 1

Sensor Status Pulse On/Off 1 200m Upgrade

v

v

v

5. Troubleshooting

5.1. No power is applied

- In case of >tandard PoE (Power over Ethernet)

Power supply through standard PoE is possible only when the following conditions are met9

19 >tandard PoE is supported on the product9

29 The LAN switch supports standard PoE9

Make sure that both the IP camera and the LAN switch support standard PoE (IEEE 80293af)

• In case of DC adapter

If PoE is not applied, the power and network connection should be made through separate cables9 Use the

DC adapter recommended by the provider9 In case of replacing the DC power supply, make sure that the

power supply meets the power requirement of the IP camera to prevent damage or malfunction9

5.2. Cannot connect to the camera

Check the status of the network connection through PING test.

Try the following on your PC:

• Start > Run > Cmd > Ping IP address (Ex : Ping 172.16.42.51)
• If "Reply from \~" message is returned (① in the figure below), the network connection is in normal state. Try connection to the video again. If the problem persists, or refer to other trouble shooting notes.
• If "Request timed out" message is returned. (② in the figure below), the network connection or network setting is not in normal state. Check the network cable and settings.

C:\WINDOWS\System32\cmd.exe Microsoft Windows XP [Version 5.1.2600] © Copyright 1985-2001 Microsoft Corp. C:\Documents and Settings\Uniperman>ping 172.16.42.51 Pinging 172.16.42.51 with 32 bytes of data; Reply from 172.16.42.51: bytes=32 time(Inn TTL-64) Reply from 172.16.42.51: bytes=32 time(Inn TTL-64) Reply from 172.16.42.51: bytes=32 time(Inn TTL-64) Reply from 172.16.42.51: bytes=32 time(Inn TTL-64) Play statistics for 172.16.42.51: Packets: Gout = 4, Received = 4, Lost = 8 (0% loss), Approximate round trip times in milli+seconds; Minimum = Max, Minimum = Max, Average = Max C:\Documents and Settings\Uniperman>

5.3. Technical Assistance

- if you need any technical assistance, please contact Speco's technical support9 Please provide the following information9

1. Mockthame
2. MAC address
3. Purchase date
4. Description of the problem
5. ERce message