Melford - Table Heart of House - Free user manual and instructions

USER MANUAL Melford Heart of House

Assembly Instructions - Please keep for future reference

241/8762

Line drawing of a simple rectangular table with four legs and a flat top (no text or symbols)

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Check you have all the components and tools listed on pages 2 and 3.
• Remove all fittings from the plastic bags and separate them into their groups.

• Keep children and animals away from the work area, small parts could choke if swallowed.
  • Make sure you have enough space to layout the parts before starting.

• Do not stand or put weight on this product during assembly, this could cause damage.

• Assemble the item as close to its final position (in the same room) as possible.
• Assemble on a soft level surface to avoid damaging the unit or your floor.
• Parts of the assembly will be easier with 2 people.

• To reduce the likelihood of damaging your product please ensure that your

power drill is set on a low torque setting.

Care and maintenance

- Only clean using a damp cloth and mild detergent, do not use bleach or abrasive cleaners.

- From time to time check that there are no loose screws on this unit.

• This product should not be discarded with household waste. Take to your local authority waste disposal centre.

Components - Panels

If you have damaged or missing components, call the Customer Helpline: 0845 6400800

Please check you have all the panels listed below

underside

Top x 1 (142 x 89.5 cm)

Side x 2 (90 x 75.5 cm)

Components - Fittings

Please check you have all the fittings listed below

Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required.

A M8x60mm Bolt x 10	B Washer x 20	C Nut x 10
D 13 mm Spanner x 2

Tools required

Ruler/tape measure

Assembly Instructions

Step 1

Attaching side

a: Position sides 2 to the sides of top 1 so that the bolt holes are aligned.

a:

Isometric line drawing of a structural frame with two vertical posts and numbered components (no text or symbols)

Step 2

Fitting

b: Fix sides 2 to top 1

b:

Technical diagram showing a wrench and tool with labeled points D and C, likely illustrating a mechanical or electrical assembly.