95-8731 - Kit voiture Metra - Free user manual and instructions
Find the device manual for free 95-8731 Metra in PDF.
User questions about 95-8731 Metra
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Kit voiture in PDF format for free! Find your manual 95-8731 - Metra and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 95-8731 by Metra.
USER MANUAL 95-8731 Metra
natural_image
Interior view of a car dashboard with two circular gauges and a digital display (no visible text or symbols)Mercedes Sprinter ^† 2019-Up
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications
* Excluding models with a touchscreen radio
KIT FEATURES
- ISO DDIN radio provision
- Polished gloss black to match the factory finish
KIT COMPONENTS
- A) Radio trim panel • B) Radio brackets • C) #8 x 3/8" Phillips pan-head screws (4)
A
natural_image
Isometric view of a rectangular frame with mounting holes (no text or symbols)
The image is too blurry to recognize any text content.
TABLE OF CONTENTS
Dash Disassembly 2
Kit Assembly 3
WIRING & ANTENNA CONNECTIONS (sold separately)
Wire Harness: See metraonline for harness and interfacing solutions
Antenna Adapter: 40-EU10
TOOLS REQUIRED
- Panel removal tool • Phillips screwdriver
- Torx T-20 screwdriver
Attention! Let the vehicle sit with the key out of the ignition for a few minutes before removing the factory radio. When testing the aftermarket equipment, ensure that all factory equipment is connected before cycling the key to ignition.
DASH DISASSEMBLY
- Unclip and remove the radio trim panel. (Figure A)
- Remove (4) Torx T-20 screws securing the radio and pocket assembly. Slide the assembly out, then unplug and remove. (Figure B)
Continue to Kit Assembly
natural_image
Technical line drawing of a car interior frame with visible fan and gear components (no text or symbols)(Figure A) (Figure B)
natural_image
Top-down line drawing of a car interior showing dashboard, air vent, and steering wheel (no text or symbols)KIT ASSEMBLY
- Secure the radio brackets to the radio trim panel using (4) #8 x 3/8" Phillips pan-head screws provided. (Figure A)
- Slide the radio into the bracket/panel assembly, then secure using screws supplied with the radio. (Figure B)
- Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation.
- Slide the radio assembly into the dash, then secure using the factory screws.
- Attach the factory radio trim panel to complete the installation.
natural_image
Technical line drawing of two mechanical components with dashed alignment lines and an arrow indicating assembly (no text or symbols)(Figure A) (Figure B)
natural_image
Technical line drawing of an electronic device with labeled components and directional arrows (no text or symbols)If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1186 ext. 8300, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.
Metra recommends MECP certified technicians