99-8265HG - Kit voiture Metra - Free user manual and instructions

USER MANUAL 99-8265HG Metra

Close-up of a car's front dashboard and air intake grilles (no visible text or symbols)

*Visit NetraOnline.com for up-to-date vehicle specific applications.

KIT FEATURES

• ISO DIN radio provision with pocket
- Painted high gloss black

KIT COMPONENTS

• A) Radio housing trim panel • B) Radio brackets • C) Pocket • D) (4) #6 x 3/8" Phillips screws • D) (2) #8 x 3/8" Phillips screws

Isometric line drawing of a rectangular frame with no text or symbols

Two isometric diagrams of rectangular panels with internal cutouts and mounting brackets, no text or symbols present.

Isometric line drawing of a rectangular electronic enclosure or housing (no text or symbols)

TABLE OF CONTENTS

Dash Disassembly 2

Kit Assembly

- ISO DIN radio provision with pocket ....3

WIRING & ANTENNA CONNECTIONS (sold separately)

Wiring Harness: 70-1761

Antenna Adapter: 40-LX10

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver
• 10mm socket wrench

CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running.

DASH DISASSEMBLY

1. Unclip and remove the trim panel from around the factory radio, including the clock. (Figure A)
2. Remove (4) 10mm bolts securing the radio, then remove it. (Figure B)

Continue to Kit Assembly

Interior view of a car dashboard with a mounted touchscreen display and control panel (no text or symbols visible)

(Figure A)

Diagram of a device with labeled ports and buttons, showing no readable text or symbols.

(Figure B)

KIT ASSEMBLY

ISO DIN radio provision with pocket

1. Attach the radio brackets to the radio housing trim panel using the (4) #6 x 3/8" screws supplied. (Figure A)
2. Mount the pocket to the radio brackets with the (2) #8 x 3/8" Phillips screws supplied. (Figure B)
3. Remove the metal DIN sleeve and trim ring from the aftermarket radio.
4. Slide the radio into the assembly and secure with the screws supplied with the radio. (Figure C)

Technical line drawing of two rectangular electronic components with mounting holes and mounting brackets (no text or symbols)

Technical line drawing of a mechanical housing or enclosure with mounting flanges and internal components (no text or symbols)

(Figure B)

1. Locate the factory wiring harness and antenna plug in the dash and make all necessary wire connections to the radio. Metra recommends using the proper mating adapters from Metra and/or AXXESS. Test the radio for proper operation.
2. Mount the new radio assembly into the dash.
3. Reassemble the dash in the reverse order of disassembly.

Technical line drawing of a car air conditioner unit with mounting holes and ventilation slots (no text or labels)

(Figure C)(Figure A)

IMPORTANT

If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by supplying in the most recognized and supported

mobile electronics school in our industry.

Log onto www.installennstitute.com or call

800-354-6782 for more information and take steps toward a better tomorrow.

Metra recommends MECP certified technicians