SS361220 - Inverter Tripp Lite - Free user manual and instructions

Product Type	DC-to-AC Power Inverter
Model	SS361220
Brand	Tripp Lite
Input Voltage (DC)	12 V
Output Voltage (AC)	120 V
Continuous Power Output	3600 W
Surge Power Output	7200 W
Output Waveform	Pure Sine Wave
Output Frequency	60 Hz
AC Outlets	2 x NEMA 5-20R
Dimensions (H x W x D)	6.75 x 12.25 x 10.5 inches
Weight	28.5 lbs
Cooling	Thermally controlled fan
Remote Control	Yes (included)
Protection Features	Overload, short circuit, low battery, over temperature
Audible Alarm	Yes (for low battery and fault conditions)
Certifications	cULus, NOM, FCC
Warranty	2 years limited
Included Accessories	Remote control, battery cables, manual

Frequently Asked Questions - SS361220 Tripp Lite

What type of battery should I use with the SS361220?

The inverter requires a 12V deep-cycle battery (e.g., AGM or flooded lead-acid). Ensure the battery can provide sufficient current (≥300A) for full load.

Can I connect the inverter directly to my car's battery?

Yes, but use the included heavy-duty cables. The inverter may draw up to 400A at full load, so ensure your vehicle's alternator and battery can handle it. Do not operate engine while using high loads for extended periods.

What is the difference between modified sine wave and pure sine wave?

The SS361220 outputs pure sine wave, which is cleaner and suitable for sensitive electronics like laptops, medical equipment, and variable speed tools. Modified sine wave can cause interference or damage.

How do I connect the inverter to my AC load?

Plug your devices directly into the NEMA 5-20R outlets. Total continuous load must not exceed 3600W. Surge loads (like motors) should not exceed 7200W for short periods.

What does the remote control do?

The remote allows you to turn the inverter on/off from a distance (up to 20 feet). It also includes a battery voltage display and fault indicator.

Why does the inverter beep continuously?

Continuous beeping indicates low battery voltage (typically below 10.5V) or an overload condition. Check battery charge and reduce load. If it beeps and shuts off, allow battery to recharge.

Can I use the inverter in parallel or series?

No, the SS361220 is designed for standalone operation only. Do not connect multiple inverters in parallel or series unless specifically designed for that.

How do I clean and maintain the inverter?

Keep the unit free of dust. Use a dry cloth or compressed air to clean vents. Do not use liquids. Check cable connections periodically for corrosion.

What safety precautions should I take?

Install the inverter in a well-ventilated area away from moisture and flammable materials. Use proper fusing on battery positive line. Disconnect battery before servicing.

What is the warranty and how do I get support?

Tripp Lite provides a 2-year limited warranty. Visit www.tripplite.com/support for RMA requests or call their support line. Keep proof of purchase.

USER MANUAL SS361220 Tripp Lite

with Surge Suppression

Models: SS240806, SS3612, SS361220, SS480806, SS7415-15 and SS7619-15

SS-Series Power Strips have multiple AC outlets and provide surge suppression to connected equipment. They feature a green LED that lights when surge suppression components are operating.

Register your product for quicker service and ultimate peace of mind.

You could also win an ISOBAR6ULTRA surge protector— a \$50 value!

www.tripplite.com/warranty

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

Copyright © 2014 Tripp Lite. All rights reserved.

Important Safety Instructions

SAVE THESE INSTRUCTIONS

• DO NOT connect the power strip to an ungrounded outlet.
- DO NOT use the power strip with 2-wire extension cords or adapters.
- This power strip is designed for indoor use only. Install the power strip away from heat-emitting appliances such as radiators or heat registers.
- Do not install where excessive moisture is present.
- Do not plug extension cords into the power strip.
- Never install electrical, telephone, network or coaxial wiring during a lightning storm.
- Do not drill into any part of the housing or open the housing for any reason. There are no user-serviceable parts inside.

Equipment Connection

Plug your equipment into the Power Strip's AC receptacles. DO NOT plug in equipment that draws more total amps than your Power Strip's amperage rating (see label on Power Strip for amperage rating), or you will trip the circuit breaker. If the circuit breaker trips, remove overload and depress breaker to reset. Leave enough clearance at the end of the Power Strip to allow the circuit breaker to operate normally.

Note: Select models with a power switch feature a protective switch cover. To access the switch, flip open the attached cover.

Wall Mounting

All Power Strip models feature clips for horizontal or vertical mounting on a variety of surfaces. The user must supply other mounting hardware (screws, etc.) and determine its suitability for use with the chosen mounting surface.

1 Mark a straight horizontal or vertical line where you want to mount the Power Strip. At each end of the line, mark where the edges of the Power Strip will be located. Place a mounting clip on the mounting surface 1" in from these edges and mark where the screws must be driven into the wall. For strips longer than 48" (120 cm), also mark a screw hole for a third mounting clip midway between the other two.

2 Keyhole Mounting: Drive #8 screws directly into the mounting surface. Snap the mounting clips onto the Power Strip 2a, then hang the Power Strip on the screws by the keyhole slots on its mounting clips 2b.

3 Clip Mounting: Drive #10 screws through washers, through the centers of the mounting clips and into the mounting surface 3a. Place the Power Strip inside one edge of the mounting clips, then snap the Power Strip into place 3b.

Specifications

Model	Amperage Rating	Outlet Qty. x Type	AC Suppression Rating	Input Plug	Cord Length	Overall Length Breaker
SS240806	15A 8 x	5-15R 1050 joules	5-15P 6 ft.	24 in. 15A
SS3612	15A 12	x 5-15R 1050 joules	5-15P 15 ft.	36 in. 15A
SS361220	20A 2 x	5-20R, 10 x 5-15R	1650 joules 5	20P 15 ft.	36 in. 20A
SS480806	15A 8 x	5-15R 1650 joules	5-15P 6 ft.	48 in. 15A
SS7415-15	15A 16	x 5-15R 1650 joules	5-15P 15 ft.	48 in. 15A
SS7619-15	15A 24	x 5-15R 1650 joules	5-15P 15 ft.	72 in. 15A

Lifetime Limited Warranty

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects in material and workmanship for its lifetime. If the product should prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole discretion. Service under this Warranty can only be obtained by your delivering or shipping the product (with all shipping or delivery charges prepaid) to: TRIPP LITE; 1111 W. 35th Street, Chicago, IL 60609. Seller will pay return shipping charges. Visit www.tripplite.com/support before sending any equipment back for repair.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE, ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES, INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights, and you may have other rights which vary from jurisdiction to jurisdiction.)

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes no representation or warranty as to the suitability or fitness of these devices for any specific application.

PRODUCT REGISTRATION

Visit www.triplite.com/warranty today to register your new Tripp Lite product. You'll be automatically entered into a drawing for a chance to win a FREE Tripp Lite product!*

* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.

Regulatory Compliance Identification Numbers

For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this product, always refer to the series number. The series number should not be confused with the marketing name or model number of the product.

Tripp Lite follows a policy of continuous improvement. Product specifications are subject to change without notice.

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support