A240MICRO - Batterie pour caméra Bebob - Free user manual and instructions
Find the device manual for free A240MICRO Bebob in PDF.
User questions about A240MICRO Bebob
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Batterie pour caméra in PDF format for free! Find your manual A240MICRO - Bebob and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. A240MICRO by Bebob.
USER MANUAL A240MICRO Bebob
text_image
A240 micro made in Germany bebob 238Wh/16.5Ah/14.4V LI-ION BATTERY ■ Before use, refer to the instruction manual on www.bebob.tv ■ Use recommended charger only ■ Keep dry, away from fire ■ Do not short the battery terminals ■ Never open the battery ■ Do not expose to temperature over 60°C/140°F ■ Maximum load 1GAD-TAP 5AUSB 1A 240A240micro
Rechargeable Li-Ion Battery
USER MANUAL
WE STRONGLY RECOMMEND READING THIS INSTRUCTION CAREFULLY BEFORE USING!
■ FOR YOUR PERSONAL SAFETY, PLEASE OBSERVE THE SAFETY INSTRUCTIONS AND WARNINGS
- OBSERVE ALL COMMON AND LOCAL SAFETY REGULATIONS
- PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE
Features
A high capacity micro A-Mount Li-Ion battery 14,4V / 16,5Ah // 238Wh
- Direct fitting to a camera or plate via micro A- or A-Mount.
■ Five-step LED Fuel Gauge (100% - 80% - 60% - 40% - 20%; SoC – State of Charge)
■ Full-charge capacity status LED
(green over 70%; yellow between 50% and 70%; red under 50% of new battery)
■ Twist D-Tap (14,4V unreg.; max. 5A)
■ USB-A (5,0V; max. 1,0A)
■ 200W continuous power drain
■ 16A max. discharge current
■ Data communication (ARRI, RED, Sony, Blackmagic Design)
Safety instructions
■ For professional use only!
■ Operate only with recommended batteries!
- Charge only with recommended chargers!
■ Risk of explosion when exposed to fire or heat!
■ Do not expose the battery to water!
- Do not cause short circuits between the battery's terminals!
■ Do not open or try to repair the device!
■ Handle with care! Do not throw or drop the device!
■ Do not operate in overhead or hanging applications!
■ Do not expose to temperatures above 60^ C ( 140^ F) or below -20^ C ( -4^ F)
■ Do not overload the device (see Specifications)!
■ Do not supply more charging voltage than specified (see Specifications)!
Storage
- The battery shall be stored within the specified temperature, humidity and state of charge ranges (see specifications).
■ Storage ambient temperature range is (see specifications)
For long-term storage (longer than 4 weeks), the battery should have a charge between 50% and 75%. The battery should be recharged every 4 weeks.
In storage, some self-discharge will occur. It is advised to fully recharge the battery before reusing it.
Warranty
- The battery is covered by a 2-year unconditional warranty on all parts, except for the cells.
■ The cells are covered by a 1-year warranty at 70% of the original capacity. - If you have any additional questions or warranty issues, please contact the appropriate bebob distributor listed at www.bebob.tv.
Disposal
■ Users are legally obliged to appropriate disposal of used batteries.
- Batteries must not be disposed of in household waste - see crossed-out dustbin symbol on the battery label.
- You can return any batteries of our battery range (old and current models) to our warehouse for free-of-charge disposal.
- If the battery is not completely discharged, precautions against a potential short-circuit must be taken.
Operation
Camera Data Communication
• Blue leds: Arri/Sony Data Protocol
• Red leds: Red Data Protocol
- To switch between both status, press the Check button for 5s

Status led
- Status led lighting Green: Full Capacity over 70% of New
- Status led lighting Yellow: Full Capacity between 50% and 70% of New
- Status led lighting Red: Full Capacity under 50% of New

natural_image
Three identical gray rectangular slots with colored vertical bars (green, yellow, red) and white gaps, no text or symbols present.Flash Light
• To switch On/Off press the Check Button Twice

Charging
■ Do not charge batteries unattended!
■ Do not charge near flammable object
■ Disconnect all external loads before the charging process
■ Wait 30 minutes since the last discharge before charging
■ The battery can be charged via any bebob B-Mount charger (or equivalent charger using the CC-CV method)
■ Do not supply more charging voltage than specified (see specifications)!
- Charge time will depend on charging power and ambient temperature
■ The optimal charging ambient temperature is (see specifications).
- bebob batteries can be recharged with any amount of remaining charge.
■ The gauge LEDs will indicate the state of charge during the charging process.
Discharging
■ The maximum discharge current shall not be exceeded (see Specifications)
- When using the battery with video or lighting equipment, the total power consumption of the equipment must be below specifications. For the protection of the battery, a load over or equal to the max discharge current may activate the internal protection circuit and stops supply of power.
In this case the fuse will self-rest after a couple of minutes.
- The device features separate self-resetting overload protections for each of its supply sockets
- Do not discharge near flammable materials and avoid high thermal loads
■ Discharge the battery only within the specified temperature range (see specifications)
- Do not stack more than one battery onto a hot swap battery
Specifications
| Model | A240micro |
| Mount Battery | micro A-Mount |
| Mount Camera | micro A-Mount; A-Mount |
| Cells | Lithium-Ion (Panasonic) |
| Energy | 238Wh |
| Capacity | 16,5Ah |
| Voltage (nominal voltage) DC | |
| 12V Mode | 14,4V/4s |
| Max. Charge/Output Voltage DC | |
| 12V Mode | 16,8V |
| End Voltage (discharge cut-off) DC | |
| 12V Mode | 10,0V |
| Continuous Discharge Current | 16,0A |
| Continuous Power Drain | |
| 12V Mode | 200W |
| External Outputs | |
| Twist D-Tap | 1x 14,4V unreg. / 5,0A |
| USB Port | 1x 5,0V / 1,0A Type-A |
| External Inputs | |
| Twist D-Tap | 14,4V unreg. / 5,0A |
| Indicators | |
| LED Gauge | |
| Status LED(compared to a new battery) | 5-Step LEDGreen: Full Capacity over 70%Orange: Full Capacity between 50 and 70%Red: Full Capacity under 50% |
| Chargers | |
| bebob V-Mount or Equivalent(CC-CV method) | 16,8V / 5A (84W) |
| D-Tap Charger (e.g.: bebob S1) | 16,8V unreg. / 5A |
| Charging time(e.g.: bebob AS2/AS4) | Approx. 2,6 hours / 80% 5A/16,8V5,3 hours / 100% 5A/16,8V |
| Ambient temperature operation range: | |
| Charge | 0°C to +45°C (32°F to 113°F) |
| Discharge | -20°C to +60°C (-4°F to 140°F) |
| Storage | -20°C to +40°C (-4°F to 104°F) (less than 70%RH) |
| Weight | 1,18 kg |
| Dimensions (WxHxD) | 75x101x97mm |