0160GV - Water heaters and boilers Volcan - Free user manual and instructions

Product Type	Electric Water Heater
Brand	Volcan
Model	0160GV
Capacity	160 liters
Dimensions (Height x Width x Depth)	1200 x 600 x 600 mm
Weight	30 kg
Power Supply	230 V / 50 Hz
Heating Power	2000 W
Maximum Pressure	8 bar
Temperature Range	30°C - 75°C
Heating Time (full tank)	Approximately 3-4 hours
Energy Class	C
Tank Material	Enameled steel
Insulation	Polyurethane foam
Protection Rating	IP24
Functions	Thermostat, safety valve, indicator light
Maintenance	Annual descaling, check anode
Cleaning	Wipe exterior with damp cloth
Safety Features	Overheat protection, pressure relief valve
Spare Parts	Anode, thermostat, heating element
Repairability	Replaceable components
Warranty	2 years
Certifications	CE

Frequently Asked Questions - 0160GV Volcan

How do I set the temperature on the Volcan 0160GV?

The temperature is set using the thermostat dial on the front of the unit. Turn it clockwise to increase temperature, counterclockwise to decrease. The recommended setting is 55-60°C for optimal energy efficiency and to prevent bacterial growth.

How long does it take to heat a full tank?

A full 160-liter tank takes approximately 3-4 hours to heat from cold to 60°C, depending on the incoming water temperature and ambient conditions.

What maintenance does the water heater require?

Annual maintenance is recommended: descale the tank to remove limescale buildup, check the sacrificial anode and replace if worn, and test the safety valve to ensure proper operation.

Why is my water not hot enough?

Possible causes: the thermostat is set too low, the heating element may be faulty, excessive limescale buildup, or the tank may be too small for demand. Check the thermostat setting first; if issue persists, inspect the element.

How do I descale the water heater?

Turn off power and water supply, drain the tank, then fill with a descaling solution (e.g., vinegar or commercial descaler) according to manufacturer instructions. Allow to soak for several hours, then flush thoroughly with fresh water before refilling.

Can I install the water heater myself?

Installation should be performed by a qualified professional to ensure compliance with local plumbing and electrical codes. Improper installation can lead to leaks, electric shock, or poor performance.

What does the safety valve do?

The safety (pressure relief) valve automatically releases water if the internal pressure exceeds a safe level (typically 8 bar). This prevents the tank from bursting.

Why is there water leaking from the pressure relief valve?

Occasional dripping is normal as the valve relieves minor pressure fluctuations. Continuous leaking may indicate excessive water pressure, a faulty valve, or a malfunctioning thermostat. Check your water pressure; if below 5 bar, replace the valve.

How do I replace the sacrificial anode?

Turn off power and water, drain the tank partially, unscrew the old anode (usually located on top), and install a new one with thread sealant. Tighten securely and refill. Check anode annually and replace when heavily corroded.

What should I do if the water heater trips the circuit breaker?

This could indicate a short circuit due to water ingress, a faulty heating element, or a ground fault. Immediately turn off power and call a qualified technician to inspect and repair the unit. Do not reset the breaker until the issue is resolved.

USER MANUAL 0160GV Volcan

Symbolic logo featuring a stylized eye inside a triangle with the word 'VOLCAN' below (no additional text or symbols)