ZWM 627 IEB.1 - Dishwasher Hansa - Free user manual and instructions
Find the device manual for free ZWM 627 IEB.1 Hansa in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Built-in Dishwasher |
| Brand | Hansa |
| Model | ZWM 627 IEB.1 |
| Width | 60 cm |
| Height | 85 cm |
| Depth | 55 cm |
| Weight | Approximately 45 kg |
| Energy Efficiency Class | A++ (typical for this class) |
| Water Consumption per Cycle | 9.5 L |
| Annual Energy Consumption | 260 kWh |
| Number of Place Settings | 12 |
| Noise Level | 45 dB (A) |
| Number of Programs | 6 (including Eco, Intensive, Quick, etc.) |
| Drying System | Heat exchanger |
| Water Stop Protection | Full (Aquastop) |
| Adjustable Racks | Height-adjustable upper basket |
| Salt and Rinse Aid Indicator | Yes |
| Delay Start | Up to 24 hours |
| Self-Cleaning Filter | Automatic cleaning cycle |
| Power Supply | 220-240 V, 50 Hz |
| Rated Power | 2100 W |
Frequently Asked Questions - ZWM 627 IEB.1 Hansa
How do I install the Hansa ZWM 627 IEB.1 dishwasher?
Ensure the dishwasher is placed on a level surface. Connect the water supply hose to a cold water tap (3/4" thread) and the drain hose to a suitable outlet. Plug the power cord into a grounded outlet. Refer to the manual for detailed installation instructions.
What does the 'E01' error code mean?
Error code E01 typically indicates a water supply issue. Check that the water tap is fully open and the inlet hose is not kinked or blocked. If the problem persists, the water inlet valve may need replacement.
How do I clean the filters?
Turn off the dishwasher and remove the lower rack. Unscrew the coarse filter and fine filter. Rinse them under running water with a soft brush. Reassemble and ensure they are properly locked in place.
Why is the dishwasher not drying dishes properly?
Make sure rinse aid is filled and the dispenser is set to a higher dosage. Also, check that the selected program includes a drying phase (e.g., Eco or Intensive). For better results, leave the door slightly ajar after the cycle.
How do I use dishwasher salt?
Open the salt dispenser located at the bottom of the dishwasher. Fill it with dishwasher salt until the brine indicator shows full. Run a cycle immediately to prevent corrosion. Only use specific dishwasher salt.
Can I place plastic items on the lower rack?
It is recommended to place plastic items on the upper rack to avoid exposure to the direct heating element. Ensure they are dishwasher-safe and not prone to melting.
What is the power consumption in standby mode?
The standby power consumption is typically less than 0.5 W, compliant with modern energy standards.
How do I reset the dishwasher?
Turn off the dishwasher and unplug it for a few minutes. Plug it back in and turn it on. If error persists, consult the manual or contact service.
What is the maximum temperature for the 'Intensive' program?
The intensive program heats water up to 70°C for heavily soiled pots and pans.
Where can I find spare parts for the Hansa ZWM 627 IEB.1?
Spare parts can be purchased from authorized Hansa service centers or online retailers. Common parts include filters, spray arms, and door gaskets. Use the model number for accurate compatibility.
User questions about ZWM 627 IEB.1 Hansa
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Dishwasher in PDF format for free! Find your manual ZWM 627 IEB.1 - Hansa and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ZWM 627 IEB.1 by Hansa.