SuperStorage 6029P-E1CR12T - Server Supermicro - Free user manual and instructions
Find the device manual for free SuperStorage 6029P-E1CR12T Supermicro in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Rackmount Server |
| Form Factor | 2U |
| Dimensions (W x H x D) | 17.2 x 3.5 x 26.5 inches (437 x 89 x 673 mm) |
| Weight | Approximately 35 lbs (15.9 kg) |
| Processor Support | Dual Intel Xeon Scalable (2nd/3rd Gen) |
| Memory | Up to 1.5TB DDR4 ECC RDIMM/LRDIMM, 16 slots |
| Storage Bays | 12 x 3.5" hot-swap SATA3/SAS3 drive bays |
| Expansion Slots | 4 x PCIe 3.0 x16, 2 x PCIe 3.0 x8 |
| Power Supply | Dual 1600W redundant Platinum level (94%+ efficiency) |
| Networking | Dual 10GbE RJ45 via Intel X710-AT2 |
| Remote Management | Supermicro IPMI 2.0 with dedicated LAN |
| Operating Temperature | 10°C to 35°C (50°F to 95°F) |
| Cooling | 4 x 8cm hot-swap redundant fans |
| Maintenance | Clean exterior with dry cloth; vacuum internal dust annually |
| Safety | Use anti-static wrist strap; disconnect power before servicing |
| Spare Parts | Hot-swap PSU, fans, drive trays; contact Supermicro for replacements |
| Warranty | Standard 3-year limited warranty |
Frequently Asked Questions - SuperStorage 6029P-E1CR12T Supermicro
How do I install hard drives in the SuperStorage 6029P-E1CR12T?
Open the front bezel, pull out the drive tray, insert the drive (SATA or SAS) into the tray, secure with screws, then slide the tray back into the bay until it clicks. The drive is hot-swappable.
What processors are compatible with this server?
It supports dual Intel Xeon Scalable processors (2nd and 3rd Gen), including Bronze, Silver, Gold, and Platinum series. Check the Supermicro CPU support list for specific models.
How do I access the IPMI remote management interface?
Connect an Ethernet cable to the dedicated IPMI LAN port (labeled IPMI). The default IP is 192.168.1.100, username ADMIN, password ADMIN. You can change these via the web interface or BIOS.
What type of memory does this server use?
It uses DDR4 ECC RDIMM or LRDIMM modules, up to 1.5TB total across 16 slots. Speeds supported: 2133, 2400, 2666, 2933 MHz depending on CPU.
Can I use both SATA and SAS drives together?
Yes, the backplane supports both SATA and SAS drives. However, mixing is not recommended in the same RAID array. Use a SAS HBA or RAID controller for SAS drives.
How do I replace a failed power supply?
The power supplies are hot-swappable. Simply press the latch, pull out the faulty unit, slide in a new one until it locks, and reconnect the power cord. No tools required.
Is a rack mount kit included?
Yes, the server comes with a rack mount kit including rails and screws. Follow the manual for installation in a standard 19-inch rack.
What operating systems are supported?
It supports Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, Ubuntu Server, VMware ESXi, and other major OS. Check Supermicro's compatibility matrix.
How do I reset the IPMI password if forgotten?
Clear the CMOS or use the IPMI reset jumper on the motherboard. Refer to the manual for jumper location. Alternatively, you can reset via BMC from the BIOS.
What is the maximum internal storage capacity?
With 12 x 3.5-inch bays using 20TB HDDs, maximum capacity is 240TB raw. Using SSDs, capacity is lower but performance is higher.
User questions about SuperStorage 6029P-E1CR12T Supermicro
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Server in PDF format for free! Find your manual SuperStorage 6029P-E1CR12T - Supermicro and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. SuperStorage 6029P-E1CR12T by Supermicro.