HGB140 - Blender Waring Commercial - Free user manual and instructions
Find the device manual for free HGB140 Waring Commercial in PDF.
| Product Type | Commercial Blender |
| Brand | Waring Commercial |
| Model | HGB140 |
| Motor Type | Heavy-duty series wound motor with lifetime sealed lubrication |
| Speeds | 2 speeds: Off, Low, High |
| RPM (Low) | 20,000 RPM (free running, approximate) |
| RPM (High) | 24,000 RPM (free running, approximate) |
| Voltage (US) | 120 V, 60 Hz, Single Phase, AC only, 7.5 Amps |
| Voltage (International) | 230 V, 50/60 Hz, Single Phase, AC only, 3.75 Amps |
| Container Capacity | 2 quarts (half gallon) mixing capacity |
| Container Material | Stainless steel or polycarbonate |
| Base Material | Black baked enamel on die cast base |
| Blade Material | Stainless steel |
| Lid Type | Vinyl lid with removable insert (two-piece standard) or optional hot blending accessory lid |
| Bearing Type | Bronze oil-impregnated, no lubrication required |
| Cord | 6 ft, 18 gauge, three-conductor grounded with strain relief in base |
| Overall Height | 17 3/4 inches |
| Diameter | 6 1/2 inches |
| Safety Features | Hot blending precautions: remove center lid insert, start on low speed, avoid standing over blender |
| Cleaning | Stainless steel container is sanitizable; refer to enclosed cleaning and sanitizing instructions |
| Service Center | 314 Ellat Grasso Ave, Torrington, CT 06790, 1-800-269-6640 |
Frequently Asked Questions - HGB140 Waring Commercial
User questions about HGB140 Waring Commercial
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
Download the instructions for your Blender in PDF format for free! Find your manual HGB140 - Waring Commercial and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. HGB140 by Waring Commercial.
USER MANUAL HGB140 Waring Commercial
The Waring Commercial Blender motor has lifetime sealed-in lubrication. Further oiling or greasing is not required.
CONTAINER
The stainless steel container requires no special handling and can be sanitized without injury to the bearing. See enclosed cleaning and sanitizing instructions pamphlet.
HOT BLENDING INSTRUCTIONS IMPORTANT!
To minimize possibility of scalding when blending hot materials, the following precautions and procedures must be observed:
1) If you are using the standard two-piece container lid that originally came with your blender, limit the amount of material processed to the quantities listed below for the container size you have.
Container Size Half Gallon
Maximum Hot Load 1 Pint
NOTE: Special accessory lid assemblies are available for stainless steel containers which allow safe processing of larger loads than those shown above.
Order appropriate catalog number for container size you have from the following list:
Special Hot Blending Accessory Lids
Container Size Half Gallon
Accessory Lid Catalog No. CAC15
2) If you are using a standard two-piece container lid, completely remove the center portion of the lid before turning the blender on. This will allow venting of the rapidly heated and expanding air present inside container when blender is running. If you are using one of the special accessory lids, follow the instructions packed with the lid; venting will be accomplished automatically.
3) Always start blending on lowest speed setting, then progress to desired speed.
4) Never stand directly over blender when it is being started or while it is running.
For Service Write to:

SERVICE CENTER 314 ELLAT, GRASSO AVE. TORRINGTON, CT 06790 1-800-269-6640
Replacement parts for your own "Out of Warranty" repairs are obtainable at the above address.

• REVOLUTIONS PER MINUTE (free running - approximate)
• RATING
• RATING
BASE
• UPPER HOUSING
- CONTAINER
BEARING
• CORD
• OVERALL HEIGHT
Two quart mixing capacity
OFF LO HI
20,000 24,000
120 VOLTS - 60 Cycles - Single Phase - AC only - 7.5 Amps 230 VOLTS - 50/60 Cycles - Single Phase - AC only - 3.75 Amps Black Baked Enamel on Die Cast Base
Stainless steel or Polycarbonate
Stainless steel with stainless steel blades and vinyl lid with removable insert
Bronze - oil impregnated - no lubrication necessary
6 foot - 18 gauge - three conductor grounded cord with strain relief in base
173/4 inches x 61/2 inches diameter
OPERATION
This piece of equipment is designed for the high speed blending, pulping, mixing or reducing of animal tissue, vegetables, foodstuffs, plant materials and other substances.
Sharp stainless steel blades whirling as fast as 24,000 rpm almost instantaneously reduce ingredients to a homogeneous mass. Industrial, biological and many other types of laboratories use this device as a time saver for the emulsification and disintegration of materials with which they work. Restaurants, hospital diet kitchens and other mass feeding institutions use Waring Commercial Blenders to prepare special sauces, salad dressings, soups, health drinks, convalescent diets and many other food recipes.
In design, the WARING COMMERCIAL BLENDER meets exacting requirements. The mixing container is made of stainless steel and is a special shape which causes a forceful flow of the contents directly into the revolving blades resulting in perfect blending.
The two speed switch control combined with the heavy-duty series wound motor permits instant change from one speed to another, higher or lower, without stopping the machine.