RM/443 - Water dispenser Ramtons - Free user manual and instructions

Product Type	Water Dispenser
Brand	Ramtons
Model	RM/443
Functions	Hot and Normal (Cold) Water Dispensing
Hot Tank Capacity	Standard (exact capacity not specified)
Cold Tank Capacity	Standard (exact capacity not specified)
Noise Level	Below 70 dB
Reservoir Material	Stainless Steel
Sanitizing Method	Bleach solution (1/2 tablespoon per 3/4 full reservoir), followed by clean water flush
Sanitizing Frequency	Every 2 months for mineral water; regularly advised
Taste Solution	1 tablespoon baking soda in water, stand 5 minutes, drain
Transport Rest Period	Allow to stand upright for 4 hours before plugging in if laid on side
Hot Tank Priming	Fill hot tank by depressing hot faucet until water flows without air bubbles
Power Disconnect Wait	5 minutes before reconnecting after any power interruption
Installation Requirements	Level floor, reachable grounded outlet, avoid direct sunlight and heat vents
Safety Warnings	Use grounded outlet; do not clean with water; do not operate without water; keep ventilation clear; do not use mechanical defrosting; fix bracket for stability
Child Safety	Supervise children to avoid scalding; not for use by persons with reduced capabilities without supervision
Disposal	Remove doors before scrapping; follow local regulations for flammable blowing gas
Power Cord Replacement	Must be replaced by manufacturer or qualified person if damaged

Frequently Asked Questions - RM/443 Ramtons

How should I clean and sanitize my Ramtons RM/443 water dispenser?

Unplug the dispenser, shut off water supply, drain remaining water. Fill reservoir 3/4 full with fresh water, add 1/2 tablespoon of liquid bleach. Let stand 5-7 minutes, then drain through faucets and plugs. Flush thoroughly with clean water. If taste persists, use 1 tablespoon baking soda in water, let stand 5 minutes, then drain.

What should I do if the water dispenser was transported on its side?

Allow the unit to stand upright for at least four (4) hours before plugging it in. Failure to do so may cause failure, excessive noise, or void the warranty.

How do I prime the hot water tank before first use?

Before connecting to power, press the hot side (red) faucet to fill the hot tank with water. Keep pressing until water flows without air bubbles. If there is an On/Off switch for the hot tank, ensure it is in the off position initially, then turn on after priming.

What type of electrical outlet should I use?

Use a grounded (earched) wall socket. The cord and plug must be dry. Do not modify the plug or lengthen the power cord, as this can cause overheating or fire.

How often should I clean the water dispenser?

For mineral water, clean every 2 months. Regular cleaning and sanitizing is advised to ensure water quality. Sanitize using the bleach solution method described in the manual.

What should I do if the water dispenser is not level?

If the dispenser does not sit level, use a shim under one of the feet at the base to level it.

Can I place the water dispenser outdoors?

No. The dispenser is not suitable for outdoor use. Keep it indoors, away from rain, direct sunlight, and heating vents.

Is it safe for children to operate the water dispenser?

Children should be supervised to ensure they do not play with the appliance. The hot water can cause sudden scalds. The appliance is not intended for use by persons with reduced physical or mental capabilities without supervision.

What should I do if the power cord is damaged?

The supply cord must be replaced by the manufacturer, its service agent, or a similarly qualified person to avoid a hazard. Do not attempt to repair it yourself.

How should I dispose of the water dispenser?

Before scrapping, remove the doors to prevent child entrapment. Follow local regulations for disposal of appliances with flammable blowing gas. Do not discard with regular household waste.

USER MANUAL RM/443 Ramtons

HOW TO CLEAN AND SANITIZE YOUR WATER DISPENSER

1. Unplug the water dispenser from the electrical outlet.
2. Shut off the water supply and remove the water guard.
3. Drain off any water left in the reservoir and tanks through the faucets and drain plugs.
4. Fill reservoir 3/4 full of fresh clean water and add 1/2 tablespoon of liquid bleach to water. Do not use a stronger sanitizing solution!
5. Allow water to stand for 5 to 7 minutes.
6. Drain sanitizing solution out of the reservoir through the faucets and drain plugs.
7. Flush thoroughly with clean water.
8. If a taste problem develops, place 1 tablespoon of baking soda into tank and add fresh water. Allow this solution to stand for 5 minutes, then drain.

INSTRUCTION & MAINTENANCE MANUAL HOT & NORMAL WATER DISPENSER

Line drawing of a water dispenser with two side gauges and a mesh base (no text or symbols)

Model: RM-443

VERY IMPORTANT! YOU MUST READ BEFORE USE.

Please check the water dispenser and carton for evidence of rough handling and concealed damage. File damage claims with the carrier or return the water dispenser to the place of purchase. If the water dispenser was placed on its side during transport, be sure to allow the unit to stand upright for at least four (4) hours before plugging it in. Failure to observe this procedure could cause the unit to fail or produce excessive noise, and may void your warranty,

NOTES

1) If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

2) Do not clean the dispenser by water, which will cause electric shock. Please clean it by wiping with soft fabric.

3) As to mineral water, you must clean it with every 2 months.

4) Use an earthed wall socket; the cord and plug must be dry.

5) Do not make modification to the power supply plug or lengthen the power supply wire which will both cause overheating or fire.

6) Do not stop the machine by inserting or pulling the power supply while the machine is working for it is very dangerous.

7) The appliance must be positioned so that the plug is accessible.

8) Do not place the machine in the rain or in a stream-full room.

9) Do not put the machine beside stove, boiler or the place where sunshine can directly irradiate.

10) When moving this machine, please do not place it in reverse or excessively declining to avoid knocking or impacting.

11) Please do not disassemble and repair it by yourself. If any failure occurs, please contact with your dealer.

12) While the water dispenser is working, do not let children play with the machine to avoid sudden scald.

13) This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

14) Children should be supervised to ensure that they do not play with the appliance.

15) WARNING Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

16) WARNING Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.

17) WARNING to avoid a hazard due to instability of the appliance, it must be fixed a bracket according to the instructions, please refer to "INSTALLING INSTRUCTION FOR BRACKET" as blow.

18) WARNING Do not use electrical appliances inside the food storage cabinet of the appliance if the unit with the cabinet, unless they are of the type recommended by the manufacturer.

19) Please according to local regulations regarding disposal of the appliance for its flammable blowing gas. Before you scrap the appliance, please take off the doors to prevent children trapped.

UNIT WITH HOT TANK

Note: On hot and normal unit, the hot tank must be filled with water before connecting water dispenser to the electrical source. Air must be bled out of the hot tank by depressing the hot side (red) faucet to fill the hot tank with water before energizing the unit. (The tank is full when water is free of air bubbles and flows from the hot faucet). Some Hot and normal units are equipped with an On/Off switch, which controls the hot tank. These units are shipped with the hot tank control in the off position. The On/off switch is located on the rear of the water dispenser.

BASIC OPERATIONAL GUIDELINES

Always unplug the water dispenser from the wall outlet when out of water.

If the power is disconnected for any reason, wait five minutes before reconnecting. The noise level of the machine is below 70dB.

Locate water dispenser within reach of a suitable grounded electrical outlet.

To help prevent algae growth, do not place water dispenser in direct sunlight or in front of heating vents.

Choose a location where floor is level. If water dispenser does not set level to the floor use a shim under one of the feet at the base of it.

The water dispenser is pre-cleaned at the factory. However, the stainless steel reservoir and water lines must be sanitized and flushed with fresh water before use. Regular cleaning and sanitizing is advised to ensure continued quality of water consumed.

Before plugging in, check the power label on the rear of the unit to ensure the power supply is correct. Serious damage could result if the incorrect supply is used.

Never rest cigarettes on water dispenser top. Do not use it as a shelf for plants or storage of other objects. Keep area around water dispenser free of dust and dirt.

If water accidentally splashes inside the water dispenser, unplug the unit, remove excess water and dry out before putting back into service.

Never place the water dispenser out of doors, it is not suitable. Please do not use it in water-spraying condition; the water dispenser also can not be sanitized by way of water-spraying.