45 TG - Outboard motor Flover - Free user manual and instructions
Find the device manual for free 45 TG Flover in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Outboard Motor |
| Brand | Flover |
| Model | 45 TG |
| Power Output | 4.5 HP (3.4 kW) |
| Engine Type | 2-Stroke |
| Displacement | 102 cc |
| Fuel Type | Unleaded Gasoline (Mixed with Oil) |
| Oil Ratio | 50:1 (Gasoline:2-Stroke Oil) |
| Starting System | Manual Recoil Start |
| Steering | Tiller Handle |
| Cooling System | Water-Cooled |
| Gear Ratio | 2.08:1 |
| Propeller | 3-Blade, 7.5" Diameter |
| Dimensions (L x W x H) | 24.5 x 12.5 x 42.5 inches |
| Weight | 37 lbs (16.8 kg) |
| Transom Height | 15 inches (Short Shaft) |
| Fuel Tank Capacity | 0.8 gallons (3 liters) |
| Maintenance | Replace spark plug annually, clean fuel filter, lubricate moving parts |
| Safety Features | Emergency stop switch (kill cord), propeller guard |
| Spare Parts | Spark plug, propeller, shear pin, water pump impeller |
| Warranty | 1 Year Limited |
Frequently Asked Questions - 45 TG Flover
What type of fuel should I use for the Flover 45 TG outboard motor?
Use unleaded gasoline with a minimum octane rating of 87. The fuel must be mixed with 2-stroke oil at a ratio of 50:1. Do not use ethanol blends higher than 10%.
How do I start the Flover 45 TG?
Ensure the motor is in neutral, attach the kill cord, open the air vent and fuel valve, set the choke if cold, then pull the recoil starter firmly. Once warm, close the choke.
What maintenance is required after each use?
Flush the motor with fresh water using a garden hose attachment, clean the exterior, check the propeller for damage, and store the motor upright in a dry place.
How do I winterize the Flover 45 TG?
Run the motor with stabilized fuel, drain the carburetor, change the lower unit oil, remove the spark plug and spray fogging oil into the cylinder, and grease all lubrication points.
What is the correct oil-to-fuel ratio?
The recommended ratio is 50:1 (2.6 ounces of 2-stroke oil per gallon of gasoline). Use NMMA-certified TC-W3 oil for best results.
Why is my Flover 45 TG not starting?
Check the fuel supply, ensure the kill cord is attached, inspect the spark plug for fouling, confirm the choke is set correctly, and verify the fuel valve is open.
What safety precautions should I take?
Always attach the emergency stop switch (kill cord) to your life jacket, ensure proper ventilation when running, and never operate in water with obstacles or swimmers nearby.
How do I change the propeller?
Remove the shear pin or cotter pin, slide off the old propeller, ensure the new propeller is the correct rotation, and secure it with a new shear pin as per the manual.
What spare parts should I carry?
Carry an extra spark plug, a spare propeller, shear pins, a fuel filter, and a basic tool kit including pliers and a screwdriver.
How long is the warranty?
The Flover 45 TG comes with a 1-year limited warranty covering manufacturing defects. For full details, refer to the warranty card included in the manual.
User questions about 45 TG Flover
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Outboard motor in PDF format for free! Find your manual 45 TG - Flover and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. 45 TG by Flover.
USER MANUAL 45 TG Flover
Manual assistant
Powered by Anthropic
Waiting for your message
Product information
Brand : Flover
Model : 45 TG
Category : Outboard motor