BRH60CX - Range hood BEKO - Free user manual and instructions
Find the device manual for free BRH60CX BEKO in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Range Hood |
| Brand | Beko |
| Model | BRH60CX |
| Width | 60 cm |
| Depth | 50 cm |
| Height (min-max) | 20 - 30 cm |
| Weight | 15 kg |
| Power Supply | 220-240 V ~ 50 Hz |
| Motor Power | 200 W |
| Maximum Extraction Rate | 600 m³/h |
| Noise Level (max) | 65 dB |
| Number of Speeds | 3 |
| Lighting | 2 x 1.5 W LED |
| Filter Type | Aluminum grease filter (washable) + optional carbon filter |
| Control Type | Push buttons |
| Extraction Type | Ducted or recirculation (with carbon filter) |
| Energy Class | A |
| Installation | Wall-mounted chimney hood |
| Duct Diameter | 150 mm |
| Warranty | 2 years |
Frequently Asked Questions - BRH60CX BEKO
How to clean the grease filters?
The aluminum grease filters can be cleaned by hand or in the dishwasher. For hand washing, use warm water and a mild detergent, then rinse thoroughly and dry. In the dishwasher, place them upright and use a low-temperature cycle. Allow to dry completely before reinstalling.
How often should I replace the carbon filter?
If the hood is used in recirculation mode, the carbon filter should be replaced every 3 to 6 months depending on usage. A saturated filter reduces efficiency and can cause odors.
Can I install the hood for recirculation?
Yes, the BRH60CX can be used in recirculation mode. You will need to install an activated carbon filter (sold separately) and ensure the air outlet is directed back into the kitchen.
How to replace the light bulb?
First, disconnect the hood from the power supply. The LED lights are integrated and may require replacing the entire light module. Consult the manual for specific instructions. In some models, the bulb can be unscrewed directly.
Why is my hood noisy?
Excessive noise can be caused by loose parts, blocked filters, or improper installation. Check that the hood is firmly mounted, clean the filters, and ensure the ductwork is not obstructed. If noise persists, contact service.
What is the duct diameter required?
The recommended duct diameter for the BRH60CX is 150 mm. Using a smaller diameter may reduce performance and increase noise.
How to reset the filter timer?
After cleaning or replacing the filters, press and hold the reset button (usually marked with a clock icon) for about 3 seconds until the indicator light turns off. Refer to the manual for exact button location.
Is the hood suitable for induction hobs?
Yes, the BRH60CX is suitable for use above induction hobs. Ensure the installation height (min 65 cm for electric hobs) is respected to avoid damage from heat.
What is the correct installation height above the hob?
For optimal performance, install the hood at a height of 65-75 cm above electric hobs and 75-85 cm above gas hobs.
How to control the hood?
The BRH60CX is equipped with push buttons. The first button turns the light on/off. The remaining buttons control the motor speeds (usually 3 speeds and an off button). Some models have a timer function.
User questions about BRH60CX BEKO
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Range hood in PDF format for free! Find your manual BRH60CX - BEKO and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. BRH60CX by BEKO.