PD6-PWDF-2 - Dishwasher Parmco - Free user manual and instructions
Find the device manual for free PD6-PWDF-2 Parmco in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Freestanding Dishwasher |
| Brand | Parmco |
| Model | PD6-PWDF-2 |
| Capacity | 14 Place Settings |
| Dimensions (H x W x D) | 845 x 598 x 600 mm |
| Weight | 45 kg |
| Power Supply | 220-240 V, 50 Hz, 10 A |
| Energy Rating | A++ |
| Annual Energy Consumption | 260 kWh |
| Water Consumption per Cycle | 9.5 L |
| Noise Level | 44 dB(A) |
| Number of Programs | 6 |
| Programs | Eco, Intensive, Normal, Quick, Glass, Rinse |
| Delay Start | 1-24 hours |
| Child Lock | Yes |
| Salt and Rinse Aid Indicator | Yes |
| Adjustable Upper Basket | Yes |
| Cutlery Basket | Removable, 3-piece |
| Interior Material | Stainless Steel |
| Control Panel | Electronic, LED display |
| Installation | Under counter or freestanding |
| Spare Parts Availability | 7 years minimum |
Frequently Asked Questions - PD6-PWDF-2 Parmco
How do I install the Parmco PD6-PWDF-2 dishwasher?
Ensure the dishwasher is placed on a level floor. Connect the water inlet hose to a cold water supply (max 60°C) with a 3/4 inch threaded fitting. Connect the drain hose to the sink drain or a standpipe. Plug the power cord into a grounded outlet. Refer to the installation manual for detailed steps.
Which detergent should I use?
Use only dishwasher-specific detergent in tablet, powder, or gel form. Avoid using hand dishwashing soap, as it causes excessive foam. Follow the detergent manufacturer's dosage recommendations based on water hardness.
How do I clean the dishwasher filter?
Turn off the dishwasher and remove the bottom rack. Locate the filter assembly at the bottom. Twist and lift the coarse filter and fine filter. Rinse them under running water with a soft brush. Reassemble and lock into place. Clean filters monthly.
Why is my dishwasher not draining?
Check if the drain hose is kinked or clogged. Clean the filter and ensure the sink drain is not blocked. If the problem persists, inspect the drain pump for obstructions. A humming noise may indicate a stuck impeller.
What do the error codes mean?
Common error codes: E1 (water intake issue), E4 (overflow), E9 (heating fault). Refer to the user manual for a full list. Reset the dishwasher by unplugging for 1 minute. If errors repeat, contact customer service.
Can I wash delicate glassware?
Yes, use the Glass program which operates at lower temperatures and gentler water pressure. Place stemware securely on the upper rack. Avoid overcrowding to prevent breakage.
How do I adjust the rinse aid dosage?
Open the rinse aid compartment lid. Turn the dial to adjust the dosage level (1-6). Higher setting for hard water to prevent spots. Start with setting 3 and adjust as needed. Close the lid until it clicks.
What is the energy consumption of the Eco program?
The Eco program uses approximately 0.93 kWh per cycle and 9.5 liters of water. It runs longer (up to 3.5 hours) but is optimized for energy and water efficiency.
How do I enable the child lock?
Press and hold the 'Start' button for 3 seconds until the child lock indicator lights up. The control panel will be locked. To disable, repeat the same step. This prevents accidental program changes.
Where can I purchase spare parts?
Genuine Parmco spare parts are available from authorized dealers and online spare parts stores. Always quote the model number PD6-PWDF-2. Filters, racks, and spray arms are commonly replaced parts.
User questions about PD6-PWDF-2 Parmco
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Dishwasher in PDF format for free! Find your manual PD6-PWDF-2 - Parmco and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. PD6-PWDF-2 by Parmco.