ValueRAM KVR1333D3S8R9S - Memory Card Kingston Technology - Free user manual and instructions

USER MANUAL ValueRAM KVR1333D3S8R9S Kingston Technology

CL9 Registered w/Parity 240-Pin DIMM

DESCRIPTION:

This document describes ValueRAM's 128M x 72-bit 1GB (1024MB) DDR3-1333MHz CL9 SDRAM (Synchronous DRAM) registered w/parity, (Intel® Compatibility Tested), single-rank memory module, based on nine 128M x 8-bit DDR3-1333MHz FBGA components. The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

FEATURES:

JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 6,7,8,9,10
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7(DDR3-1333)
8-bit pre-fetch
☑ Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%)
On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
√ Asynchronous Reset
PCB : Height 1.180" (30.00mm), double sided component

PERFORMANCE:

CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
√ Refresh to Active/Refresh Command Time (tRFCmin) 110ns (min.)
Row Active Time (tRASmin) 36ns (min.)
Power 2.137 W (operating)
UL Rating 94 V - 0
Operating Temperature 0 °C to 85°C
√ Storage Temperature -55 °C to +100°C

MODULE DIMENSIONS:

Green circuit board with five rectangular memory chips, no visible text or symbols

Diagram of a microprocessor with five rectangular slots on a green circuit board (no text or symbols)

(units = millimeters)

0,000 1,20 7,23 22,13 38,08 52,98 80,38 95,28 111,23 126,13 132,15 133,55 R 0,65 MAX. TYPICAL 30,00 29.60x4 24.80x2 21.80x2 18.80x2 15.80x2 11.00x2 8.00x2 3,60 2,30x2 0,000 0,000 22,0 1,50 +/- 0,10 54,70 131,25 131,15 CHAMFER 0,50 X 45 DEG. 4 PLACES