TeraStation 5400DRW2 Windows Storage Server 2012 R2 - Server BUFFALO - Free user manual and instructions
Find the device manual for free TeraStation 5400DRW2 Windows Storage Server 2012 R2 BUFFALO in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Type de produit | Serveur de stockage en réseau (NAS) avec Windows Storage Server 2012 R2 |
| Marque | Buffalo |
| Modèle | TeraStation 5400DRW2 |
| Processeur | Intel Xeon E3-1220 v3 (quad-core, 3.1 GHz) |
| Mémoire RAM | 8 Go DDR3 ECC (extensible jusqu'à 32 Go) |
| Capacité de stockage | 4 baies pour disques durs SATA de 3,5 pouces (prise en charge jusqu'à 32 TO) |
| Configuration RAID | RAID 0, 1, 5, 6, 10, JBOD |
| Interfaces réseau | 2 x Gigabit Ethernet (RJ-45), 2 x 10 Gigabit Ethernet (SFP+ en option) |
| Ports USB | 2 x USB 3.0, 2 x USB 2.0 |
| Alimentation | Double alimentation redondante, 450 W chacun |
| Dimensions (L x P x H) | 43,0 x 43,0 x 4,4 cm (montage en rack 2U) |
| Poids | Environ 10 kg (sans disques durs) |
| Température de fonctionnement | 5 °C à 35 °C |
| Humidité de fonctionnement | 20 % à 80 % (sans condensation) |
| Système d'exploitation | Windows Storage Server 2012 R2 |
| Protocoles de partage | SMB/CIFS, NFS, AFP, FTP, WebDAV |
| Fonctions de sauvegarde | Sauvegarde intégrée (Windows Server Backup), réplication distante |
| Virtualisation | Prise en charge de Hyper-V |
| Gestion | Interface Web (Navigator), Windows Admin Center, iSCSI Target |
| Sécurité | Chiffrement BitLocker, pare-feu Windows, contrôle d'accès NTFS |
| Entretien | Disques durs remplaçables à chaud, ventilateurs redondants |
| Pièces détachées | Alimentations, ventilateurs, disques durs (modèles compatibles Buffalo) |
| Réparabilité | Composants remplaçables sur site (unité centrale, mémoire, alimentations) |
| Garantie | 3 ans (selon région) |
Frequently Asked Questions - TeraStation 5400DRW2 Windows Storage Server 2012 R2 BUFFALO
How do I initialize the TeraStation 5400DRW2 for the first time?
Connect the device to your network and power it on. Use the Buffalo Navigator software to discover the server, then launch the Windows Storage Server setup wizard to configure the administrator password, network settings, and initial RAID configuration.
What RAID configurations are supported by the TeraStation 5400DRW2?
The device supports RAID 0, 1, 5, 6, 10, and JBOD. RAID 5 and 6 are recommended for a balance of performance and redundancy.
Can I replace a failed hard drive without shutting down the server?
Yes, the TeraStation 5400DRW2 supports hot-swappable hard drives. You can replace a failed drive while the server is running, provided the RAID array is in a degraded state and the new drive is of the same type.
How do I access the TeraStation from a Windows client?
Open File Explorer and type \ or \ in the address bar. You will need a valid user account and password configured on the server.
What is the maximum memory capacity of the TeraStation 5400DRW2?
The server supports up to 32 GB of DDR3 ECC RAM, using two 16 GB modules or four 8 GB modules (depending on the motherboard).
How can I set up iSCSI targets on this server?
Open Server Manager, navigate to File and Storage Services > iSCSI, and use the iSCSI Target Creation Wizard. You can create virtual disks and assign them to initiators.
Does the TeraStation 5400DRW2 support virtualization?
Yes, since it runs Windows Storage Server 2012 R2, it can act as a Hyper-V host. You can create and manage virtual machines directly on the server.
What maintenance tasks should I perform regularly?
Check the health of hard drives via the RAID management tool, install Windows updates, review event logs for errors, and ensure both power supplies are functioning. It is also recommended to replace cooling fans every 3-4 years.
How do I factory reset the TeraStation 5400DRW2?
Press and hold the Reset button (located on the front or back panel) for about 5 seconds until the status LED blinks. This will restore the default administrator password and network settings. For a full reset, use the Windows setup utility.
What is the warranty period for this server?
The Buffalo TeraStation 5400DRW2 typically comes with a 3-year limited hardware warranty. Warranty terms may vary by region; check your documentation or contact Buffalo support.
User questions about TeraStation 5400DRW2 Windows Storage Server 2012 R2 BUFFALO
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Server in PDF format for free! Find your manual TeraStation 5400DRW2 Windows Storage Server 2012 R2 - BUFFALO and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. TeraStation 5400DRW2 Windows Storage Server 2012 R2 by BUFFALO.