ALL6400pro - Server Allnet - Free user manual and instructions
Find the device manual for free ALL6400pro Allnet in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Rackmount Server |
| Form Factor | 2U Rackmount |
| Processor | Intel Xeon Scalable (up to 2nd Gen) |
| Memory | DDR4 ECC RDIMM, up to 512GB |
| Storage | Hot-swap SATA/SAS HDD/SSD, up to 8 bays |
| Network | Dual 10GbE RJ45 ports |
| Expansion Slots | 2x PCIe 3.0 x16, 1x PCIe 3.0 x8 |
| Power Supply | Dual redundant 800W PSU |
| Dimensions | 88.9 x 482.6 x 660 mm (HxWxD) |
| Weight | Approximately 15 kg (without drives) |
| Cooling | 4x hot-swap fans |
| Management | IPMI 2.0, remote KVM |
| Operating System | Supports Windows Server, Linux, VMware |
| Security | TPM 2.0 module, secure boot |
| Maintenance | Tool-less access, hot-swap components |
| Cleaning | Compressed air for dust; avoid liquids |
| Spare Parts | Available via Allnet service |
| Repairability | Modular design, easy swap |
| Compliance | CE, FCC, RoHS |
| Warranty | 3 years limited warranty |
Frequently Asked Questions - ALL6400pro Allnet
What is the default IP address for IPMI?
The default IPMI IP is 192.168.1.1, but it can be changed during initial setup. Check the network configuration section in the manual.
How do I reset the IPMI password?
You can reset the IPMI password by connecting a monitor and keyboard to the server, booting into the IPMI configuration utility, and selecting the password reset option. Alternatively, use the IPMI reset jumper on the motherboard.
What type of RAM is compatible?
The server supports DDR4 ECC RDIMM memory modules with speeds up to 2666 MHz. Mixing non-ECC or unbuffered DIMMs is not supported.
Can I install a GPU?
Yes, the server has two PCIe 3.0 x16 slots suitable for low-profile GPUs. Ensure the total power draw does not exceed the PSU capacity and that the GPU fits within the chassis dimensions.
How to configure RAID?
RAID can be configured via the onboard SATA controller or an optional hardware RAID card. During boot, press Ctrl+I (for Intel RST) or Ctrl+R (for LSI) to enter the RAID utility.
What is the maximum storage capacity?
With 8 hot-swap bays and support for 12TB drives, the maximum raw capacity is 96TB using 3.5-inch SATA/SAS HDDs. SSDs can also be used.
Is the server compatible with VMware ESXi?
Yes, the ALL6400pro is certified for VMware ESXi 6.7 and later. Ensure you download the correct image from the VMware compatibility list.
How to replace a failed fan?
The fans are hot-swappable. Remove the top cover, press the fan release lever, and pull out the failed fan module. Insert a new one until it clicks into place. No tools required.
What should I do if the server overheats?
Check the fan status via IPMI or front panel LEDs. Ensure vents are not blocked and ambient temperature is below 35°C. Clean dust with compressed air and verify all fans are spinning.
Where can I download the latest firmware?
Firmware updates are available on the Allnet support website. You need the server serial number to access downloads. Update via IPMI or bootable USB.
User questions about ALL6400pro Allnet
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Server in PDF format for free! Find your manual ALL6400pro - Allnet and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. ALL6400pro by Allnet.