GUR200X - Refrigerator Scancool - Free user manual and instructions

Product Type	Freestanding Refrigerator
Brand	Scancool
Model	GUR200X
Net Capacity	200 L
Dimensions (H x W x D)	1450 x 550 x 600 mm
Weight	45 kg
Energy Class	E (EU energy label)
Climate Class	N/ST (16°C to 38°C)
Cooling System	Static with automatic defrost
Temperature Range	0°C to 8°C
Defrost Type	Automatic (frost free)
Number of Shelves	4 adjustable glass shelves
Door Reversibility	Yes (reversible hinge)
Interior Light	LED
Noise Level	42 dB(A)
Refrigerant	R600a
Power Supply	220-240 V ~ 50 Hz
Power Consumption	100 W
Annual Energy Consumption	173 kWh/year
Warranty	2 years

Frequently Asked Questions - GUR200X Scancool

How do I set the temperature on my Scancool GUR200X?

Turn the thermostat knob inside the fridge compartment. The recommended setting is medium (around 4°C). Adjust based on your needs.

How often should I clean the refrigerator?

Clean the interior and exterior every 3 months with a soft cloth and mild detergent. Avoid abrasive cleaners.

Can I reverse the door opening direction?

Yes, the door is reversible. Follow the instructions in the manual to move hinges. You may need a screwdriver.

Why is my refrigerator making unusual noises?

Normal operational sounds include clicking (compressor start/stop), gurgling (refrigerant flow), and humming (fan). If loud or irregular, check leveling and clearance.

What should I do if water collects at the bottom?

Check if the defrost drain is blocked. Clean the drain hole using a pipe cleaner or warm water. Also ensure the door seals properly.

Why is my refrigerator not cooling enough?

Verify the thermostat setting, ensure door closes tightly, and check for condenser coils dust buildup. Clean coils if needed.

What to do during a power failure?

Keep the door closed as much as possible. Food stays safe for about 4 hours. Use a cooler with ice packs if prolonged.

How should I arrange food in the fridge?

Store raw meat on lower shelves, ready-to-eat foods above. Use airtight containers to prevent odors and maintain humidity.

How do I defrost the freezer compartment?

This model features automatic defrost. If ice builds up, manually defrost by unplugging and allowing ice to melt. Remove water with a sponge.

What energy class does the GUR200X have?

The energy class is E on the EU label. It consumes about 173 kWh per year. For better efficiency, keep it away from heat sources.

USER MANUAL GUR200X Scancool

- Position on a flat, stable surface.

- A service agent /qualified technician should carry out installation and any repairs if required. Do not remove, any components or service, panels on this product.

- Consult Local and National Standards to comply with the following:

• Health and safety at work legislation
• BS EN Codes of Practice

- Fire Precautions

• IEE Wiring Regulations
• Building Regulations

• DO NOT use jet/pressure washers to clean the appliance.
- DO NOT use the appliance outside.
- DO NOT use this appliance to store medical supplies.
• DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-cream makers etc.)
• DO NOT stand or support yourself on the base, drawers or doors.
- DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
- DO NOT place more than 30 kg load on each shelf.

WARNING:

Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.

• Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• Do not damage the refrigerant circuit.
• Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
• Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the refrigerator.
• Always carry store and handle the appliance in a vertical position and move by holding the base, of the appliance.
  • Always switch off and disconnect the power supply to the unit before cleaning.
• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities.
• If the power cord is damaged, it must be replaced by an agent or a recommended qualified technician in order to avoid a hazard.
• Do no store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge if they have been

Säkerhetstips

Symbol of a trash bin crossed with no visible text or labels

given supervision or instruction concerning. use of the appliance in a safe way and understand the hazards involved children shall not play with the appliance,

- cleaning and user maintenance shall not be made by children without supervision. The instructions concerning persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge and children playing with the appliance are not required. Sound pressure level al workstation is far below 70dB.

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine with provide the best possible performance from your product.

Pack Contents

The following is included:

• Refrigerator or freezer
- Shelves x 3 (Single)/ x 6 (Double)
- Keys x 2
- Instruction manual
- Shelf guides x 6 single) and 12 double
- Waste water tray

We pride yourself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your dealer immediately.

Installation

Note: if the appliance has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation. IF in doubt allow the appliance to stand.

1 Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.
2 Maintain a distance of 20 cm between the unit and walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.

Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.

3 Set the brakes on the castors to keep the appliance in position or level the appliance by adjusting the screw feet.

Lock/unlock the doors

A. lock is fitted to the doors to ensure food stuffs are kept secure within your appliance.

Use the keys provided to lock/unlock the door

All COMPACT models are equipped with a door lock ensuring that stocks are safe after closing.

Fitting the Shelves

1 Place one set of shelf guides on either side of the cabinet at the desired height

2 Slide the shelf into place.

3 Repeat for the remaining shelves.

4 The number of shelves depend on how many you want.

Note: This is vital for ensuring correct drainage of condensation.

Operation

Storing Food

To get the best results from your appliance, follow these instructions:

- Only store food stuff in the appliance when it has reached the correct operating temperature.

- Do not place uncovered hot food or liquid inside the appliance.

- Wrap to cover food where possible.

- Do not obstruct the fans inside the appliance.

- Avoid opening the doors for prolonged periods of time.

Turn On

1 Close the door(s) of the appliance.

2 Ensure the power switch is set to (O) and turn on at the socket.

3 Switch on the power (P). The current temperature within the appliance is displayed.

Manual Defrost

The appliance will automatically run a defrost cycle every 6 hours.

Note: The cycle starts from the time the, appliance is initially powered up.

To manually defrost the appliance:

1 Press and hold the "DEFROST" button for 5 seconds.

2 The defrost cycle will start immediately and the Defrost LED illuminates. The defrost will last a maximum of 30 minutes.

Note: Starting a manual defrost also resets the automatic defrost timer. The next automatic defrost will start 6 hours after the manual defrost has finished.

3 Waste water is collected in the waste water tray.

Cleaning, Care & Maintenance

- Switch off and disconnect from the power supply before cleaning.

- Clean the interior of the appliance as often as possible.

• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with water only.
  • Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
  • Take care when cleaning the rear of the appliance. Sharp edges can cut
  • An agent or qualified technician must carry out repairs if required.

Cleaning the Condenser

Periodically cleaning the condeenser can extend the life of the appliance.

We recommend that our agent our qualified technician clean the condenser.

Troubleshooting

If your appliance develops a fault, please check the following table before making a call to your retailer.

Fault	Probable cause	Action
The appliance is not working	The unit is not switched on	Check the unit is plugged in correctly switched on
	Plug and lead are damaged	Call your agent or qualified technician
	Fuse in the plug has blown	Replace the fuse
	Power supply	Check power supply
	Internal wiring fault	Call your agent or qualified technician
	Too much ice on the evaporator	Defrost the appliance
	Condenser blocked with dust	Call your agent or qualified technician
The appliance turns on, but the temperature is too high/low	Doors are not shut properly	Check doors are shut and seals are not damaged
	Appliance is located near a heat source or air flow to the condenser is being interrupted	Move the refrigerator to a more suitable location
	Ambient temperature is too high	Increase ventilation or move appliance to a colder position
	Unsuitable foodstuffs are being stored in the appliance	Remove any excessive hot foodstuffs or appliance blockages to the fan
	Appliance is overloaded	Reduce the amount of food stored in the appliance
The appliance is leaking water	The appliance is not properly levelled	Adjust the screw feet to level the appliance (if applicable)
	The discharge outlet is blocked	Clear the discharge outlet
	Movement of water to the drain is obstructed	Clear the floor of the appliance (if applicable)
	The water container is damaged	Call your agent or qualified technician
	The drip tray is overflowing	Empty the drip tray (if applicable)
The appliance is unusually loud	Loose nut/screws	Check and lighten all nuts and screws.
	The appliance has not been installed in a level or stable position	Check installation position and change if necessary

In case the supply cable is damaged, the manufacturer or the after-sales service, or qualified technician shall replace it, in order to prevent any possible risk

The lamp repair and replacement shall he carried out by qualified technician, with power supply disconnected. Replace with identical lamps

Only qualified technicians shall carry out the extraordinary maintenance interventions

Electrical wiring

Appliances are supplied with a 3 pin, moulded BS 1363 plug and lead with a 13 amp fuse as standard. The plug is, to be

connected to a suitable mains socket Appliances are wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
• All appliances must be earthed, using a dedicated earthing circuit
• In doubt consult a qualified electrician.
- Electrical insolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Disposal

EU regulations require refrigeration product to be disposed of by specialist companies who remove or recycle all gasses, metal and plastic components.

Consult your local waste collection authority regarding disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on now to dispose of the equipment locally.

Compliance

Parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.

Products have been approved to carry the following symbol:

Disposal of packaging

Simple line drawing of a trash bin with no text or symbols

All packaging materials should be disposed of in an environmentally friendly way.

The cardboard may be used as scrap paper. The protective foil and the foam cushions are CFC - free.

Do not allow children to play with the packaging and destroy plastic bags safely.

You can break or cut the cardboard into smaller pieces and give to a waste paper disposal service.

Environmental protection

Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively support us in conserving resources and protecting the environment by returning this appliance to the collection centres (if available)

Simple line drawing of a trash bin with no text or symbols

Access to professional repair, such as internet webpages, addresses, contact details. Model no: GUR200X

Aftersales service station list:

Address	Linåvej 20 . 8600 Silkeborg . Denmark	QR code
Contact Number	0045 7242 5571
Website	www.scandomestic.dk
Relevant information for ordering spare parts, directly or through other channels provided by the manufacturer, importer or authorised representative;			www.scandomestic.dk
The minimum period during which spare parts, necessary for the repair of the appliance, are available; (years)			8
defined in Regulation by means of a weblink that links to the model information as stored in the product database or a link to the product database and information on how to find the model identifier on the product.)			www.scandomestic.dk

Note: The address or contact phone number of the service site is subject to change without prior notice. Please confirm whether the service station is a directly affiliated one of our company when requiring services.

SE

EU declaration of conformity

Name and address of the manufacturer or his authorised representative:

Scandomestic A/S

Linåvej 20

8600 Silkeborg

Denmark

This declaration of conformity is issued under the sole responsibility of the manufacturer (or installer):

Scandomestic A/S

Linåvej 20

8600 Silkeborg

Denmark

References to the relevant harmonised standards used or references to the other technical specifications in relation to which conformity is declared:

EN ISO 17050-1: 2004

Additional Information

Object of the declaration

(identification of product allowing traceability. It may include a colour image of sufficient clarity to enable the identification of the product)

Model number(unique identification of the product):	GUR200X
Type	Storage Refrigerator
Brand	Scancool
Outside colour	White

The object of the declaration described above is in conformity with the relevant Union harmonisation legislation:

MD2006/42/EC, EMC2014/30/EU, ErP EU No(EU) 2015/1094, ErP EU No(EU) 2015/1095, RoHS2011/65/EU, EN 60335-1:2012/ AIS:2021, EN 60335-2-89:2010/A2:2017, EN 62233:2008, EN IEC 55014-1:2021, EN IEC 55014-2:2021, EN IEC 61000-3-2:2019/AI:2021, EN 61000-3-3:2013/A2:2021, COMMISSION DELEGATED REGULATION(EU) 2015/1094 of 5 May 2015, COMMISSION REGULATION (EU) 2015/1095 of May 2015, EN16825:2016 + AI:2019 EN ISO 22041:2019+AI:2019, 2011/65/EU

scandomestic

Denmark · CVR. No.: 29774242

Phone: [phone]

[e-mail]