Question 1

Why does the screen go black immediately after turning on the VIVITAR XVN-5?

Accepted Answer

If the screen of your VIVITAR XVN-5 goes black immediately after turning it on, here are the steps to follow to resolve this issue:

1. Check and reinsert the batteries

Remove the batteries completely and wait a few seconds
Check that the batteries are not worn out or depleted - replace them with new batteries if necessary
Reinsert them while correctly respecting the polarity (+ and - aligned)
Press the Power button to turn on the device

2. Fully charge the device

Connect the charger provided with the VIVITAR XVN-5
Wait for the device to be fully charged before turning it back on
A weak battery can cause a black or unstable display

3. Perform a forced restart

Remove the batteries completely
Hold the Power button down for 10 seconds (without batteries)
Reinsert the batteries and turn it on again

If the screen remains black after these steps, there may be a hardware issue with the LCD screen or the camcorder's display circuit.

Question 2

What type of charging cable should be used for the ViviCam T327?

Accepted Answer

The ViviCam T327 does not use an internal rechargeable battery, so it does not require a specific charging cable. This digital camera operates with two AA batteries (alkaline batteries recommended).

For powering the device:

Insert two AA batteries into the designated compartment
Preferably use alkaline batteries for better battery life
You can also use rechargeable AA batteries (NiMH) with an external charger

For photo transfer:

The ViviCam T327 comes with a USB 2.0 cable that allows you to transfer your photos to a computer. This cable is intended solely for data transfer, not for charging the device.

In summary: no charging cable is needed for the ViviCam T327 as it operates on batteries.

User manual VIVITAR : user manuals and guides in PDF

Models VIVITAR most viewed

Browse manuals VIVITAR by appliance type

Recent questions about devices VIVITAR