How to disable the second channel of the NICE FLOX2R?

Question

Accepted Answer

The FLOX2R is a 2-channel receiver with relay output, configured via jumpers according to your manual.

According to the manual: The association of the relays to the channels is done through the position of the jumpers. The PDF of this manual does not explicitly specify the procedure to completely disable the second channel.

In general, for a receiver like the FLOX2R, the second channel can be disabled in two ways:

Via the jumpers: Do not place the jumper corresponding to the second relay/channel. Refer to the jumper position diagram in your manual (configuration section or board diagram).
Via programming: Do not program any radio code on the second channel. Without an associated code, the channel remains inactive.

If you have access to the FLOX2R motherboard, check the jumper diagram to identify exactly which position corresponds to the second relay/channel, then do not insert a jumper there if you do not wish to use it.

User manual NICE : user manuals and guides in PDF

Models NICE most viewed

Browse manuals NICE by appliance type

Recent questions about devices NICE