Why doesn't the PICCOLO Rotante oven ignite while I hear clicks?

Q: Why doesn't the PICCOLO Rotante oven ignite while I hear clicks?

A clicking noise without flames generally indicates that the electronic ignition is working, but gas is not reaching the combustion chamber. Here’s how to check: Checkpoints Ignition battery: Check that the 1.5V (AA) battery in the ignition compartment is not worn out or discharged. Replace it if necessary - this is the primary cause of weak ignition. Gas supply: Ensure that the bottle (Butane G30 or Propane G31) is properly connected and open. The pressure should be between 28-37 mbar (50 mbar in AT/CH/DE). Gas leak: Before relighting, apply a soapy solution to all gas connections. Bubbles indicate a leak that prevents gas from reaching the burner. Tighten the fittings if necessary. Control button: Press the on/off button and turn it counterclockwise until you hear a distinct click. Hold the position for 8-10 seconds to allow gas to accumulate, then an additional 10 seconds after ignition before releasing. Injector: The main injector (1.12 mm) may be blocked by residue or impurities. If everything else works, the burner may need to be cleaned or replaced. If after these checks you still hear clicks but no flame, the problem is likely on the gas side (connection, flow, or blockage) rather than the ignition itself.

Question

Accepted Answer

A clicking noise without flames generally indicates that the electronic ignition is working, but gas is not reaching the combustion chamber. Here’s how to check:

Checkpoints

Ignition battery: Check that the 1.5V (AA) battery in the ignition compartment is not worn out or discharged. Replace it if necessary - this is the primary cause of weak ignition.
Gas supply: Ensure that the bottle (Butane G30 or Propane G31) is properly connected and open. The pressure should be between 28-37 mbar (50 mbar in AT/CH/DE).
Gas leak: Before relighting, apply a soapy solution to all gas connections. Bubbles indicate a leak that prevents gas from reaching the burner. Tighten the fittings if necessary.
Control button: Press the on/off button and turn it counterclockwise until you hear a distinct click. Hold the position for 8-10 seconds to allow gas to accumulate, then an additional 10 seconds after ignition before releasing.
Injector: The main injector (1.12 mm) may be blocked by residue or impurities. If everything else works, the burner may need to be cleaned or replaced.

If after these checks you still hear clicks but no flame, the problem is likely on the gas side (connection, flow, or blockage) rather than the ignition itself.

User manual Witt : user manuals and guides in PDF

Models Witt most viewed

Browse manuals Witt by appliance type

Recent questions about devices Witt