Question 1

How to install the presser foot on the TOYOTA SP20 sewing machine?

Accepted Answer

To install the presser foot on your TOYOTA SP20 sewing machine, follow these simple steps. The presser foot (optional accessory) is changed in the same way as any other presser foot using the machine's standard attachment system.

Before you begin: turn off the machine and unplug it from the wall outlet for safety reasons.

Installation steps:

Lift the presser foot: raise the presser foot lever (located at the back of the machine) to lift the presser foot
Raise the needle: turn the handwheel towards you to raise the needle to its highest position
Remove the old foot: press the presser foot holder lever in the direction of the arrow to release and remove the current foot
Position the presser foot: align the pin of the presser foot directly under the groove of the presser foot holder
Attach the new foot: lower the presser foot lever to securely attach the presser foot in place
Check the installation: ensure that the foot is securely attached and does not move

Important point: the presser foot must be compatible with TOYOTA series SP20 machines and use the same pin attachment system. If the foot does not install easily, check that the pin is properly aligned with the groove of the holder. After installation, turn the handwheel to ensure that the foot moves freely without obstruction.

Question 2

How do I adjust the thread tension on the Toyota SL3335 sewing machine?

Accepted Answer

Adjusting the thread tension on your Toyota SL3335 sewing machine is essential for achieving even stitches and quality sewing. Here’s how to do it:

Understanding Thread Tension

The tension controls the force with which the thread is pulled through the machine. Too high a tension can cause tight stitches, puckering, or thread breakage. Too low a tension can result in loose or uneven stitches.

Locating and Adjusting the Tension Setting

Locate the tension dial or knob on your machine, usually found on the front or side.
Settings are often numbered, with a recommended average value around 4.
Start by setting the tension to this median value.

Testing and Fine-tuning the Tension

Do a sewing test on a piece of fabric similar to what you intend to sew.
If the stitches are too tight or the upper thread breaks, decrease the tension by turning the dial to a lower number.
If the stitches are loose or the lower thread is visible on top, increase the tension by turning the dial to a higher number.
Make small adjustments and test again until you achieve balanced and even stitches.

Adjusting Tension According to Fabric

Note that different types of fabrics require different tension settings:

Light fabrics (sheer, fine cotton): lower tension.
Thick or heavy fabrics (denim, canvas): higher tension.

By correctly adjusting the thread tension, you will improve the quality of your sewing and extend the lifespan of your Toyota SL3335 sewing machine.

User manual TOYOTA : user manuals and guides in PDF

Models TOYOTA most viewed

Browse manuals TOYOTA by appliance type

Recent questions about devices TOYOTA