How to automatically start the Elettrobar Niagara dishwasher cycle after changing the electronic board without pressing Start?

Question

Accepted Answer

After replacing the electronic board of your Elettrobar Niagara dishwasher, it is possible that the cycle does not start automatically and requires pressing the Start button each time. Here’s how to resolve this issue:

1. Check the connections

Ensure that all electrical connections between the new electronic board and the rest of the appliance are properly connected and secure. A poorly established connection may prevent automatic starting.

2. Reset the appliance

Perform a reset by unplugging the dishwasher from the electrical outlet for at least 5 minutes, then plug it back in. This often restores the default settings of the electronic board.

3. Check the start settings

Some electronic boards have a programming mode or specific settings to enable automatic starting. If your board allows it, check the available options (via the control panel or a service mode) to activate this function.

4. Check the control panel

Ensure that the control panel does not have any stuck buttons or malfunctions that could prevent automatic starting.

If the problem persists after these steps, it is possible that the installed electronic board is not configured for automatic starting or requires specific technical intervention.

User manual Elettrobar : user manuals and guides in PDF

Models Elettrobar most viewed

Browse manuals Elettrobar by appliance type

Recent questions about devices Elettrobar