UltraLight T-005X - Stativ Sirui - Kostenlose Bedienungsanleitung

BEDIENUNGSANLEITUNG UltraLight T-005X Sirui

INSTRUCTIONS

T-0X Series Tripod

T-0X Series Tripod Data Chart

T-058X T-058R T-058X T-058Y T-058X T-058Y T-058X T-058Y T-058X T-058Y T-058X T-058Y T-058X T-058Y T-058X T-058Y T-058X T-058Y S 227.01 227.02 227.03 227.04 227.05 227.06 227.07 227.08 227.09 227.10 227.11 227.12 227.13 227.14 227.15 227.16 227.17 227.18 227.19 227.20 227.21 227.22 227.23 227.24 227.25 227.26 227.27 227.28 227.29 227.30 227.31 227.32 227.33 227.34 227.35 227.36 227.37 227.38 227.39 227.40 227.41 227.42 227.43 227.44 227.45 227.46 227.47 227.48 227.49 227.50 227.51 227.52 227.53 227.54 227.55 227.56 227.57 227.58 227.59 227.60 S 6131

Mounting Screw Mounting Plate Locking Collar Center Column Tripod Base Leg Angle Lock Hook Foam Grip Rubber Leg Locks

Press a b

④ a < b b c

Diagram showing three different types of tripod mount tips labeled a, b, and c with Chinese annotations.

⑦ α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1111 α1099 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 α0999 β a b

1.Know your tripod

2.Leg Extension and Closing

As shown in Figure 2, twist the rubber leg locks about 90 degrees in a clockwise direction ("a"), adjust the legs to the desired length ("b") and tighten the rubber leg locks by turning them in a counter-clockwise direction ("c").

3.Leg Angle Adjustment

To meet requirements to shoot on uneven terrain, each leg can be adjusted to three different positions. While holding the Center Column, place your thumb on the Leg Angle Lock and push the leg slightly towards the Center Column. While pressing the lower part of the Leg Angle Lock ("a"), you can adjust the leg to the second or third position. There is no need to press the Leg Angle Lock when moving from the wider to narrower angle.

4. Center Column height adjustment

Place the tripod on the floor, loosen the Locking Collar by turning in a counterclockwise direction ("a") and adjust the Center Column to the desired height ("b"). Relighten the locking collar by turning in a clockwise direction ("c").

5.Low-angle and Macro Shooting

Unscrew and remove the center column in direction "a". Unscrew and remove the mounting plate and mounting screw. Screw the mounting plate and mounting screw onto the Tripod Base and tighten. Open the tripod legs to the desired position for low-angle or macro photos (see figure C).

6.Hook

At the bottom of the Center Column is a Hook that allows you to hang additional weight (sand bag, camera bag, etc.) under the tripod for added stability.

7. Inverting the tripod legs for storage

Close and lock all of the legs. Press and hold the Leg Angle Lock ("a") and fold the legs up 180 degrees ("b").

Attention:

Do not exceed the recommended load limit of the head and/or tripod (Please refer to product specifications.)
⚠️ Please make sure that the locks are securely tightened when in use.
This product should not be used in environments that exposed the following conditions (-40 - +100°C/-40 - +212°F). And, when used in damp, dirty or dusty environments, please clean and dry thoroughly after use, to assure proper functioning in the future. It is not recommended to expose this product to saltwater. If exposed, please clean with mild soap and warm water and towel dry.
Please keep from high temperatures and direct exposure to bright sunlight for extended periods of time.
Please do not leave the equipment alone in a public place, which can be an inconvenience or hazard to others.
To protect your camera gear, please remove it from the tripod/ball head when transporting from place to place.
Please use a soft towel with warm water and mild soap to clean the locking system and gliding parts when necessary. Towel dry before storing the tripod.
Under most situations, there is no need to lubricate any parts of this product. The addition of most lubricants will gum up the mechanisms and reduce their normal gliding characteristics. Please call or email us if you have any questions or special needs.
Please keep this product away from all electrical power sources.

CAUTION Please remove the camera from the tripod when changing the position of the tripod. Do not place the tripod, with camera attachment, over your attraction or carry the tripod horizontally by the legs. Strong shaking may cause damage of the nose in the mounting plate and inside the camera. Please extend the leg from the biggest tube to smallest tube, close the leg from the smallest tube to biggest tube, to avoid leg joint shooting damage.

Specifications are subject to change without notice.

WARRANTY CARD INFORMATION

540

Dear SURUI Customer

Thank you for your purchase of SIRU Professional Product SIRU warrants that your purchases is free from defects in material and workmanship under normal use during the Limited Warranty Period. The Warranty begins on the original date of purchase on your sales receipt and is not transferrable. If service is required, a copy of the sales receipt must be included with an arrangement of the problem.

Product	Warranty Length
Tripods / Monopods / Accessories	6 years
Humidity Control Cabinet (Cabinet)
Humidity Control Cabinet (Electronics)	3 years

Note

Date

Serial Number: ____

Warranty coverage can differ from region to region.

Please see the contact information below for product registration, information and service for the region the product was purchased.

information and service for the region the product was purchased in.

SIRUI S (next Year Limited Warranty (3 Year Warranty for Electronic Parts). This warranty shall be limited to repair, adjustment and/or replacement at SIRUI or its authorized distributors option, of defective parts, free of charge (except the cost of transportation to the distributor-service center).

Responsibility is limited to the actual cost of the item. Call or Email with questions and service before sending any product to the center in your region. Below is a listing of contact information for Product Registration, Service Information and Documents (EUI) listed by reasonable information as

Injuries and Questions, until we not be responsible for expenses or inconveniences, or consequential damages to equipment, or by breach of any

expressed

Limitations:
Warranty is not transferable. This warranty covers all defects encountered in normal use of the equipment.
and does not apply in the following cases:
1. If the equipment has been serviced by other than an authorized SIRU, Service Customer
2. Damans to the
The removal of ballhead clamps), overloading, mishandling, abuse, accident
sand ^a , corrosives, water damage ^b or not following operating instructions.
3. No valid proof of purchases is provided.
4. Damage caused by a lot of nature (including, debris; limited to fires, floods or earthquakes).
*W Series Waterproof Dustproof models – Warranty coverage can differ from
region to region. Please see contact information below for product information and service for the region the product was purchased in

Warranty Address and Contact Information:

Please contact the seller of the local distributor where the product was purchased for warranty issues or questions and before any product is sent.)
perceived as
1. Guangdong SIRUI Optical Co., Ltd.
The third industrial DRC 10, Wugeshan Town, Zhongshan City, Guangdong. China
Tel:[phone] Fax:[phone]
Http://www.sinu.com E-mail: [e-mail]

SINOCHE

2.SIRUI USA, LLC
№ 29 Сомното Санп Усана, № 07544
www.stal.com: Sandra: Toli Fire
FOR PRODUCTS PURCHASED IN THE USA PLEASE SEE
For full details on USA Warranty Terms and Limitations
www.sirui.com/warranty.html To register products: www.sir

2.2.1 陈志华

1. Focus Nordic AB
   For technical support, service of repairs, please contact Sweden: [e-mail] www.focuangerdic.ac
   Norway: [e-mail] www.locusnordio.no
   Denmark: [e-mail] www.locuamordic.de
   Iceland: [e-mail] www.focyanordic.in
   Latvia: nls@focusnordiciv www.focusnordiciv
   Estom: [e-mail] www.locusnordio.ac L'chuaris: info@locusanordio-II www.focursordio-II
   Poland: [e-mail] www.focusrordie.pl

2. BURLEY

3. SIROT Europe GmbH (European Service Center) Add: Forderware 2, 14959 Radio, Germany

Phone: [phone] E-mail: info@

(Please contact the seller or your local distributor for warranty issues.)

1. TSE Imaging BV

Add: Argonweg 135,1362AD Almere, The Netherlands

Telephone: [phone] E-mail: [e-mail]

(Exclusive Distribui www.sina-photo-ai

4.12.2017年1月1日

4.대상엔티프라이자

한국 충한, 기술지원 및 보증서비스 제공

서울특별시동구 Nam대문로 10,1층

Tel: [phone] Fax: [phone] www.niwi.co.jp Japan@kui@gmail

www.essence.com