SRCOOL60KRTH - Luftfuktare Tripp Lite - Gratis bruksanvisning och manual
Hitta enhetens manual gratis SRCOOL60KRTH Tripp Lite i PDF-format.
Användarfrågor om SRCOOL60KRTH Tripp Lite
0 fråga om denna apparat. Svara på dem du kan eller ställ din egen.
Ställ en ny fråga om denna apparat
Ladda ner instruktionerna för din Luftfuktare i PDF-format gratis! Hitta din manual SRCOOL60KRTH - Tripp Lite och ta tillbaka ditt elektroniska enhet i hand. På denna sida publiceras alla dokument som behövs för att använda din enhet. SRCOOL60KRTH av märket Tripp Lite.
BRUKSANVISNING SRCOOL60KRTH Tripp Lite
SRCOOL60KCW Accessory Reference
For detailed installation and operation of any accessory, refer to the Quick Start Guide, Owner's Manual, or Installation & Operation Guide included in the package of the relevant optional accessory.
Leak Detection Kit
Model: SRCOOL60KWDR
When this kit is installed, the cooling unit's water leakage detector will trigger a system alarm when it comes in contact with water or other liquid, and sound an alert to take proper measures. The detector must be manually set on-site for leakage detection and installed at a low level. If the lower piping configuration is used, the leak detection kit should be placed close to the pipeline below the raised floor.
To install, pass one end of the water leakage detector through the small hole located on the lower part of the cabinet and connect it to the white connector labeled "LD". No other configuration is required. The cooling unit will detect the presence of the leak detector and begin monitoring for leaks. For more information on installation, see section 4.5 in the SRCOOL60KCW Owner's Manual.
Remote Temp Sensor / Remote Temp and Humidity Sensor
Models: SRCOOL60KRT / SRCOOL60KRTH
For optimal total area cooling, the SRCOOL60KCW features environmental monitoring capability with compatible sensors. The sensors should be located in different areas throughout the installation to monitor temperature and/or humidity. Remote sensors should be placed in or near:
- Hot spots (areas of increased temp within the room)
• Critical servers or other electronic equipment
• High-load servers - The farthest rack being serviced by the SRCOOL60KCW
To install, connect the SRCOOL60KRT or SRCOOL60KRTH to REMOTE SENSOR ports one (1) through four (4) on the SRCOOL60KCW. For more information, see section 3.8.3 in the SRCOOL60KCW Owner's Manual.
Caution – Do not install the sensor in a dead air zone. Air movement is required for the proper monitoring of the temperature or humidity.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2016 Tripp Lite. All rights reserved.