M16CR - Csap SMEG - Ingyenes használati útmutató
Találja meg az eszköz kézikönyvét ingyenesen M16CR SMEG PDF formátumban.
Felhasználói kérdések a következőről M16CR SMEG
0 kérdés erről a készülékről. Válaszolj azokra, amiket ismersz, vagy tedd fel a sajátod.
Tegyél fel egy új kérdést erről a készülékről
Töltse le az útmutatót a következőhöz Csap PDF formátumban ingyenesen! Találja meg kézikönyvét M16CR - SMEG és vegye vissza elektronikus eszközét a kezébe. Ezen az oldalon közzé van téve az eszköze használatához szükséges összes dokumentum. M16CR márka SMEG.
HASZNÁLATI ÚTMUTATÓ M16CR SMEG
| Mixer type Possible causes Solution | Problem | |||
| Revolving / Pull-out | Drip from the closed control aerator |  | Cartridge damaged (by micro debris and impurities in the water) | • Replacement of the mixing cartridge Tips for preserving the cartridge: - Installation of filter valves under the sink (if they are not present) - Periodic filter cleaning |
| Revolving / Pull-out | Visible leakage under the control knob |  | Cartridge damaged (by micro debris and impurities in the water) | • Replacement of the mixing cartridge Tips for preserving the cartridge: - Installation of filter valves under the sink (if they are not present) - Periodic filter cleaning |
| Revolving | Visible leakage in the spout rotation area |  | Wear and tear of the seals due to wear and tear (from daily use), impurities in the water, limescale and incorrect maintenance | Seal replacement using sealing kit |
| Revolving / Pull-out Reduced flow rate |  | Thick dirt on the filters and/or in the aeratorIncorrect installation of the supply hoses | 1 - Inspection and cleaning of the filter/aerator2 - Check that the hoses are not bent/twisted3 - Clean the filters under the sink | |
| Pull-out Reduced flow rate Spray head and check valve | In addition to the checks in the previous point, please also check the check valve in the spray head, if any | |||
| Pull-out | Spraying from both spray head nozzles |  | Internal components and seals damaged by impurities | Spray head replacement |
| Pull-out | The spray head is barely pulled out of its seatThe hand shower hardly gets back into position |  | Wrong installation of the counterweight | Check the correct position of the counterweight along the hose of the pull-out spray head (and lubricate the seal on the spray head shank if necessary) |
| Revolving / Pull-out | The mixer is not stable on the sink surface |  | Wrong installation | Check the correct tightening of the fixing kit and evaluate the possible use of the triangular support |
The notes indicated in the table are intended to supplement the Product Warranty, which should be read in order to ensure correct installation, use and maintenance of the product itself