Question 1

How to use elastic thread to gather fabric with the SINGER Quantum Stylist 9960 sewing machine?

Accepted Answer

To gather fabric with elastic thread on your SINGER Quantum Stylist 9960, you need to prepare the machine in a specific way. Wind the elastic thread directly onto the bobbin by hand, without pulling the thread too tightly, to avoid it being too tight and losing its elasticity. Then insert the bobbin into the machine as usual. On the upper spool, place a standard sewing thread. This combination of elastic thread in the bobbin and standard thread in the upper spool creates the desired gathering effect.

Select a straight stitch on the LCD screen of your machine and set the stitch length to 3.5 to 4 mm (a longer length than usual). This longer stitch length significantly facilitates the gathering of the fabric. You can check the recommended settings directly on the high-resolution digital display of the machine, which indicates the optimal settings for each selected stitch.

Sew along the area to be gathered in a straight line. Do not make lock stitches at the beginning or end of the sewing, as you will need to be able to pull the threads freely to create the gathers. For a more pronounced and even effect, sew two parallel lines spaced about 0.5 cm apart in the same area.

Once the stitches are made, gently and gradually pull on the elastic thread from the bobbin to gather and ruffle the fabric to the desired height. Distribute the gathers evenly along the entire length of the seam by adjusting regularly. Use only the elastic thread for this, which has the property of being stretchable.

To permanently secure the gathers in place, tie the two ends of the threads together or make a few lock stitches at each end. You can use the Automatic Locking Stitch function of your SINGER Quantum Stylist 9960 to reinforce the final stitches and prevent the gathers from coming undone.

Question 2

How to make the basic settings on the SINGER 1120 sewing machine?

Accepted Answer

To optimize the use of your SINGER 1120 sewing machine, it is important to know the basic settings that influence the quality of sewing. Here are the main settings to master:

1. Adjustment of the upper thread tension

The thread tension is essential for obtaining even stitches:

Locate the tension dial, usually found on the top or front of the machine.
Turn it to increase or decrease the tension. Too much tension can cause the fabric to pucker, while too little tension results in loops under the fabric.

2. Adjustment of stitch length

The stitch length determines the distance between each sewing stitch:

Use the dedicated dial to adjust the stitch length.
For fine fabrics, prefer a short length (close stitches).
For thick fabrics or temporary seams, choose a longer length.

3. Adjustment of stitch width (for zigzag stitches)

If you are using zigzag stitches, you can adjust their width:

Turn the width dial to set the spacing of the stitches.
A larger width is useful for finishes or appliqués, while a reduced width is better for more discreet seams.

4. Adjustment of the presser foot

Make sure the presser foot is suitable for the type of fabric and sewing:

Check that it is securely attached.
Use a special foot for thick fabrics, zippers, or topstitching if necessary.

5. Adjustment of the needle position

The needle position can be adjusted to facilitate certain sewing tasks:

Use the control provided to move the needle left, center, or right as needed.
This adjustment is useful for sewing close to edges or for topstitching.

By mastering these settings, you will improve the quality of your sewing and the versatility of your SINGER 1120 machine.

User manual SINGER Sewing machine : user manuals and guides in PDF

Models SINGER Sewing machine most viewed

Other categories SINGER

Recent questions about Sewing machine SINGER