My CADAC 2 Cook 3 Turbo FFD won't turn on - what should I do?

Question

Accepted Answer

Here is the correct procedure to turn on your CADAC 2 Cook 3 Turbo FFD:

Before you begin: If your appliance has been stored for a long time, inspect it for insects or spider webs that may obstruct the gas flow. It is also recommended to remove the cooking surface during the initial lighting, which will allow you to better see the burner ignite.

Ignition with the built-in piezo:

Press firmly on the rotary control knob and turn it 90° counterclockwise.
While keeping the button pressed, push the piezo button to generate a spark and ignite the gas.
The flame should normally ignite within the first 2 seconds.
Do not hold the button down for more than 15 seconds.

If ignition fails: If the gas does not ignite on the first spark, immediately release and return the button to the OFF position. Wait at least 1 full minute to allow the accumulated gas to escape, then try again. If the burner is still not lit after 15 seconds, stop and wait 1 minute before trying again.

Alternative: ignition with a barbecue lighter: You can also use a barbecue lighter. Insert it into one of the small ventilation holes under the burner (not in the large central hole). Light the barbecue lighter, then while it is lit, press and turn the control knob counterclockwise.

Persistent problems after storage: If your appliance is malfunctioning after a long period of inactivity, the jet nozzle may be clogged with debris. This is indicated by a weak yellowish flame or no flame at all. It is recommended to clean or replace the jet nozzle every 6 months to ensure optimal operation. To replace the nozzle: remove the cooking surfaces, turn the appliance upside down, unscrew the bottom panel, then loosen the hex nut to access the nozzle. Use an appropriate wrench (not pliers) to remove and replace it.

Additional checks: Ensure that the gas bottle is properly connected and that its valve is open. Check that the regulator used matches the pressure for your region (28-30, 37, or 50 mbar depending on the country). Also, verify that the gas used (butane, propane, or mixture) is compatible with the appliance. The appliance should always be placed on a firm and level surface.

User manual CADAC Cooking stove : user manuals and guides in PDF

Models CADAC Cooking stove most viewed

Other categories CADAC

Recent questions about Cooking stove CADAC