KA-F2 - Uncategorized KIDDE - Free user manual and instructions

Product Type	Smoke Alarm
Brand	Kidde
Model	KA-F2
Power Source	9V Alkaline Battery (included)
Sensor Type	Ionization
Dimensions (H x W x D)	4.5 x 4.5 x 1.5 inches
Weight	0.5 lbs (with battery)
Alarm Loudness	85 dB at 10 feet
Temperature Range	40°F to 100°F (4°C to 38°C)
Humidity Range	10% to 95% non-condensing
Installation	Ceiling or wall mount with included hardware
Test Button	Yes, silences nuisance alarms
Battery Life	Approximately 1 year under normal conditions
Low Battery Indicator	Chirps every 30-60 seconds
End-of-Life Signal	Chirps 3 times every 30 seconds after 10 years
Safety Certification	UL Listed
Warranty	10-year limited
Cleaning	Vacuum dust off vents monthly
Replaceable Parts	Battery only (9V alkaline)
Manual Languages	English, French, Spanish (depending on region)

Frequently Asked Questions - KA-F2 KIDDE

How do I install the Kidde KA-F2 smoke alarm?

Mount the alarm on a ceiling or wall using the included screws and anchors. Remove the battery tab to activate. Press the test button to ensure proper operation.

Why is my Kidde KA-F2 chirping?

A chirp every 30-60 seconds indicates a low battery. Replace with a fresh 9V alkaline battery. If chirping continues, it may be end-of-life (after 10 years) and should be replaced.

How do I silence a false alarm on the KA-F2?

Press the test/hush button to silence the alarm for approximately 10 minutes. If the alarm persists, ensure there is no smoke or steam nearby.

What battery does the Kidde KA-F2 use?

It uses a standard 9V alkaline battery. Do not use rechargeable batteries as they may not provide adequate power.

How often should I test the smoke alarm?

Test the alarm weekly by pressing and holding the test button until the alarm sounds. Clean the unit monthly by vacuuming dust from the vents.

Where should I place the Kidde KA-F2?

Install on the ceiling or high on a wall, at least 4 inches from corners. Avoid areas near kitchens, bathrooms, or garages to prevent nuisance alarms.

Can I paint my smoke alarm?

No, painting the alarm can block the vents and sensors, causing malfunction. Keep it unpainted.

How long does the Kidde KA-F2 last?

The alarm has a lifespan of 10 years from the date of manufacture. Replace the entire unit after 10 years.

What does a continuous alarm mean?

A continuous loud alarm indicates smoke detection. Evacuate immediately and call emergency services.

Is the Kidde KA-F2 interconnected?

No, the KA-F2 is a standalone unit and cannot be interconnected with other alarms.

USER MANUAL KA-F2 KIDDE

IMPORTANT! READ ALL INSTRUCTIONS BEFORE INSTALLATION AND KEEP THIS GUIDE FOR FUTURE REFERENCE.

Read and become familiar with the user guide and all other literature supplied with each alarm in your home.

⚠ WARNING! If the power harness currently wired into the structure does not match the photo in FIGURE 1, this is not the correct wiring adapter for your application. This Connector Must Have An Orange Interconnect Wire.

THIS ADAPTER CAN ONLY BE USED WHEN REPLACING FIRST ALERT® AND BRK® MODELS; SA4121B, 4120, 4919, 5919, AND 86RAC WITH PLUG-IN CONNECTOR, MANUFACTURED BEFORE JUNE 1, 2003. THESE MODELS HAVE BEEN TESTED FOR INTERCONNECT COMPATIBILITY WITH THE KIDDE ALARM MODELS: 1235, 1275, 1276, 1285, i12020, i12020A, i12040, i12040A, i12060, i12060A, i12080, i12080A, i4618, i4618A, i4618AC, KN-SMFM-I, RF-SM-ACDC, PE120, P12040, PI2000, PI2010, KN-COSM-I, KN-COSM-IB, KN-COSM-IBA, KN-COPE-I, KN-COPE-IC, i12010S, i12010SCO, P4010ACSCO, P4010ACSCO-W, P4010LACS-W, P4010ACS, P4010ACS-W.

Close-up of a white electrical connector with black and white wires (no text or symbols visible)

FIGURE 1 FIGURE 2

Close-up of a white mechanical component with attached wires, possibly a valve or connector (no visible text or symbols)

This smoke alarm adapter allows the installation of new Kidde alarm to existing First Alert® and BRK® wiring harnesses. When using this adapter, the power harness supplied with your new Kidde alarm is not used. You will need to remove the existing First Alert® or BRK® mounting plate and install the mounting plate supplied with your new Kidde alarm. Connect the KA-B2 adapter to the First Alert® or BRK® wiring harness. To install the adapter, pinch the tabs on the side and insert into the opening of your Kidde unit (FIGURE 2). Secure the Kidde alarm to the mounting plate.

After installation, be sure that the AC power indicator is operating and test all your alarms following the instructions supplied by the alarm manufacturer for your specific alarm model. If the alarms are interconnected push the test button on each alarm and verify that all the interconnected alarms sound when any alarm is activated. The interconnect system should not exceed the NFPA interconnect limit of 12 smoke alarms.

FIVE YEAR LIMITED WARRANTY

KIDDE Safety warrants the original purchaser that the enclosed smoke alarm adapter will be free of defects in material and workmanship or design under normal use and service for a period of five years from the date of purchase. The obligation of KIDDE Safety under this warranty is limited to repairing or replacing the smoke alarm adapter which we find to be defective in material, workmanship or design, free of charge to the customer, upon sending the smoke alarm adapter with proof of date of purchase, postage and return postage prepaid to: Warranty Service Department, Kidde Safety, 1394 South Third St, Mebane, NC 27302.

THE LIABILITY OF KIDDE SAFETY OR ANY OF ITS PARENT OR SUBSIDIARY CORPORATIONS ARISING FROM THE SALE OF THIS SMOKE ALARM ADAPTER OR UNDER THE TERMS OF THIS LIMITED WARRANTY SHALL NOT IN ANY CASE EXCEED THE COST OF REPLACEMENT OF THE SMOKE ALARM ADAPTER AND IN NO CASE SHALL KIDDE SAFETY OR ANY OF ITS PARENT OR SUBSIDIARY CORPORATIONS BE LIABLE FOR CONSENSEQUENTIAL LOSS OR DAMAGE RESULTING FROM THE FAILURE OF THE SMOKE ALARM ADAPTER OR THE BREACH OR THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, EVEN IF THE LOSS IS CAUSED BY THE COMPANIES NEGLIGENCE OR FAULT.

Since some states do now allow limitations on the duration of an implied warranty or do not allow the exclusion of limitations or incidental or consequential damages, the above limitation or exclusions may not apply to you. While this warranty gives you specific legal rights, you may also have other rights, which vary, from state to state. The above warranty may not be altered except in writing signed by both parties hereto.

Since some states do now allow limitations on the duration of an implied warranty or do not allow the exclusion of limitations or incidental or consequential damages, the above limitation or exclusions may not apply to you. While this warranty gives you specific legal rights, you may also have other rights, which vary, from state to state.

The above warranty may not be altered except in writing signed by both parties hereto.

QUESTIONS OR FOR MORE INFORMATION

Call our Consumer Hotline at

1-800-660-6788

Or contact us at our web site www.kidde.com

Made in China

FIRST ALERT ^® is a registered trademark of First Alert Trust. BRK ^® is a registered trademark BRK Brands Inc.

1275-7246-00

Kidde Unified Technologies

WIRING ADAPTER FOR USE WITH FIREX® WIRING HARNESS

User Guide

The Kidde and Firex alarm models listed in this user guide have been tested to be interconnect compatible. That compatibility exists with or without the use of the wiring harness adapters.

IMPORTANT! READ ALL INSTRUCTIONS BEFORE INSTALLATION AND KEEP THIS USER GUIDE FOR FUTURE REFERENCE.

Read and become familiar with the user guide and all other literature supplied with each alarm in your home.

▲ Warning! If the power harness currently wired into the structure does not match the photo in FIGURE 1, this is not the correct wiring adapter for your application.

THIS ADAPTER CAN ONLY BE USED WHEN REPLACING FIREX® MODELS: FADC, ADC, AND AD. THESE MODELS HAVE BEEN TESTED FOR INTERCONNECT COMPATIBILITY WITH THE KIDDE ALARM MODELS: 1235, 1275, 1276, 1285, i12020, i12020A, i12040, i12060, i12060A, i12080, i4618, i4618A, i4618AC, KN-SMFM-I, PE120, PI2000, KN-COSM-I, KN-COSM-I B, KN-COSM-IBA, KN-COPE-I, i12010S, i12010SCO, P4010ACSCO, P4010ACSCO-W, P4010LACS-W, P4010ACS, P4010ACS-W.

Close-up of a white plastic electrical plug or connector (no visible text or symbols)

Close-up of a white electrical plug socket with wires, no visible text or symbols

FIGURE 1 FIGURE 2

This smoke alarm adapter allows the installation of new Kidde alarm to existing Firex® wiring harnesses. When using this adapter, the power harness supplied with your new Kidde alarm is not used. You will need to remove the existing Firex® mounting plate and install the mounting plate supplied with your new Kidde alarm. Connect the KA-F2 adapter to the Firex® wiring harness then attach your Kidde alarm to the adapter (FIGURE 2). Secure the Kidde alarm to the mounting plate.

After installation, be sure that the AC power indicator is operating and test all your alarms following the instructions supplied by the alarm manufacturer for your specific alarm model. If the alarms are interconnected push the test button on each alarm and verify that all the interconnected alarms sound when any alarm is activated. The interconnect system should not exceed the NFPA interconnect limit of 12 smoke alarms.

Each alarm shall be installed and tested in accordance with its user guide.

FIVE YEAR LIMITED WARRANTY

KIDDE Safety warrants the original purchaser that the enclosed smoke alarm adapter will be free of defects in material and workmanship or design under normal use and service for a period of five years from the date of purchase. The obligation of KIDDE Safety under this warranty is limited to repairing or replacing the smoke alarm adapter which we find to be defective in material, workmanship or design, free of charge to the customer, upon sending the smoke alarm adapter with proof of date of purchase, postage and return postage prepaid to: Warranty Service Department, Kidde Safety, 1394 South Third St, Mebane, NC 27302.

THE LIABILITY OF KIDDE SAFETY OR ANY OF ITS PARENT OR SUBSIDIARY CORPORATIONS ARISING FROM THE SALE OF THIS SMOKE ALARM ADAPTER OR UNDER THE TERMS OF THIS LIMITED WARRANTY SHALL NOT IN ANY CASE EXCEED THE COST OF REPLACEMENT OF THE SMOKE ALARM ADAPTER AND IN NO CASE SHALL KIDDE SAFETY OR ANY OF ITS PARENT OR SUBSIDIARY CORPORATIONS BE LIABLE FOR CONSENSEQUENTIAL LOSS OR DAMAGE RESULTING FROM THE FAILURE OF THE SMOKE ALARM ADAPTER OR THE BREACH OR THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, EVEN IF THE LOSS IS CAUSED BY THE COMPANIES NEGLIGENCE OR FAULT.

Since some states do now allow limitations on the duration of an implied warranty or do not allow the exclusion of limitations or incidental or consequential damages, the above limitation or exclusions may not apply to you. While this warranty gives you specific legal rights, you may also have other rights, which vary, from state to state. The above warranty may not be altered except in writing signed by both parties hereto.

Since some states do now allow limitations on the duration of an implied warranty or do not allow the exclusion of limitations or incidental or consequential damages, the above limitation or exclusions may not apply to you. While this warranty gives you specific legal rights, you may also have other rights, which vary, from state to state.

The above warranty may not be altered except in writing signed by both parties hereto.

QUESTIONS OR FOR MORE INFORMATION

Call our Consumer Hotline at

1-800-660-6788

Or contact us at our web site www.kidde.com

FIREX® is a registered trademark of United Technologies Corporation

Made in China