KL28 - Air conditioner Kaden - Free user manual and instructions

Product Type	Portable Air Conditioner
Model	KL28
Brand	Kaden
Cooling Capacity	12000 BTU
Heating Capacity	12000 BTU (Heat Pump)
Energy Efficiency	EER 2.8
Power Supply	115V/60Hz
Power Consumption	1200W
Air Flow	250 CFM
Noise Level	52 dB (Low) / 56 dB (High)
Refrigerant	R-410A
Dimensions (W x D x H)	18.5 x 14.5 x 30 in
Weight	65 lbs
Control	Remote control and digital display
Timer	24-hour timer
Modes	Cool, Fan, Dehumidify, Heat
Maintenance	Clean air filter every 2 weeks
Safety Features	Auto shut-off, overload protection
Spare Parts	Remote control, filters, drain hose
Recommended Room Size	Up to 500 sq ft

Frequently Asked Questions - KL28 Kaden

How do I clean the air filter?

Open the front panel, remove the air filter, wash it with mild soap and water, let it dry completely, then reinstall it.

What does error code E1 mean?

Error code E1 indicates a coil temperature sensor failure. Please contact customer service for repair.

Can I use an extension cord?

No, do not use an extension cord. Plug the unit directly into a grounded outlet to avoid fire or electrical hazard.

How often should I drain the water?

The unit automatically shuts off when the water tank is full. You can drain it manually or attach a drain hose for continuous drainage.

Does the unit have a timer?

Yes, it has a 24-hour timer that allows you to set the unit to turn on or off automatically.

What is the cooling capacity?

The cooling capacity is 12000 BTU, suitable for rooms up to 500 square feet.

How do I use the remote control?

Insert two AAA batteries, point the remote at the unit, and press the power button. Use the mode button to select Cool, Fan, Dehumidify, or Heat.

What is the noise level?

Noise level is 52 dB on low speed and 56 dB on high speed.

Is the unit Energy Star rated?

Yes, the unit meets Energy Star efficiency standards for energy savings.

What type of refrigerant does it use?

It uses R-410A refrigerant, which is environmentally friendly and efficient.

USER MANUAL KL28 Kaden

The Manual Wall Control requires you to manually control Pump (and Pre-Wet cycle) operations, fan operation and the fan speed. On days of high humidity for ventilation the fan may be operated without operating the pump.

To run the Cooler

1. Push the ON/OFF button (1) to turn the controller ON, the Power indicator (2) will illuminate.
2. Slide the COOL switch (3) to the ON position. This will operate the pump.

After sliding the COOL switch (3) ON allow 5–10 minutes to Pre-Wet the filter pads before sliding the FAN switch (4) ON. Doing this will provide for the maximum cooling immediately when the fan is switched ON.

1. Slide the FAN switch (4) to the ON position.
2. Rotate the FAN SPEED dial (5) to set the desired airflow level.

To turn OFF

1. Push the ON/OFF button (1) to turn the controller OFF, the Power indicator (2) will go out.

To run the Fan for ventilation

1. If already cooling, slide the COOL switch (3) to the OFF position, this will turn off the pump and use the fan for ventilation only.

OR

1. When OFF, push the ON/OFF button (1) to turn the controller ON, the Power indicator (2) will illuminate.
2. Slide the Fan switch (4) to the ON position.
3. Rotate the Fan Speed dial (5) to set the desired airflow level.