TF 6600 Durallum - Range hood CATA - Free user manual and instructions

Product Type	Range Hood
Brand	CATA
Model	TF 6600 Durallum
Installation Type	Wall-mounted Chimney Hood
Width	600 mm
Height (Adjustable)	800 - 1100 mm
Depth	500 mm
Weight	15 kg
Power Supply	220-240 V, 50 Hz
Motor Power	200 W
Extraction Rate (Max)	650 m³/h
Noise Level	55 dB (A)
Lighting	LED, 2 x 3 W
Number of Speeds	4 (3 speeds + intensive)
Filter Type	Aluminum Grease Filter
Charcoal Filter Option	Yes (sold separately)
Duct Diameter	150 mm
Energy Class	A
Control Type	Push-button
Warranty	2 years

Frequently Asked Questions - TF 6600 Durallum CATA

How do I install the CATA TF 6600 Durallum range hood?

Installation must be performed by a qualified professional. Ensure the hood is securely mounted to a wall at a minimum height of 65 cm above electric hobs or 75 cm above gas hobs. Connect to a 150mm duct or use recirculation with a charcoal filter. Refer to the manual for detailed steps.

How often should I clean the grease filter?

Clean the aluminum grease filter every month or more frequently with heavy usage. It can be washed by hand in warm soapy water or in the dishwasher. Ensure it is completely dry before reinstalling.

How do I replace the charcoal filter?

Charcoal filters should be replaced every 3-6 months, depending on usage. To replace, remove the grease filter, slide out the old charcoal filter, and insert the new one. Use only CATA approved filters.

What should I do if the hood is not extracting properly?

Check that the grease filter is clean and not clogged. Ensure ductwork is not blocked and that the motor is running. If the hood is in recirculation mode, replace the charcoal filter. Also verify that the duct diameter is at least 150mm.

How do I change the LED lights?

The LED lights are integrated and should be replaced only by a qualified technician. If the lights fail, contact CATA service for replacement parts. Do not attempt to replace them yourself.

What is the recommended height for installation above a gas hob?

For gas hobs, the minimum installation height is 75 cm from the hob surface to the bottom of the hood. For electric hobs, it is 65 cm. This ensures safe and efficient operation.

Can the hood be used in recirculation mode?

Yes, the TF 6600 Durallum can be used in recirculation mode with the addition of a charcoal filter (sold separately). This is ideal when ducting to the outside is not possible.

What is the noise level of this hood?

The noise level varies by speed. At the lowest speed, it is around 52 dB, and at maximum speed up to 60 dB. The intensive mode may be slightly louder.

How do I reset the filter alarm?

After cleaning or replacing filters, press and hold the filter reset button (if available) for 3 seconds until the indicator light turns off. Refer to the manual for your specific model.

What is the warranty period for CATA range hoods?

CATA offers a standard 2-year warranty for manufacturing defects. Keep your purchase receipt and contact an authorized service center for claims. Warranty does not cover misuse or normal wear.

USER MANUAL TF 6600 Durallum CATA

Technical line drawing of a mechanical assembly with no visible text or symbols

ES

INSTRUCTIONS FOR INSTALLATION, MAINTENANCE AND USE

IT

Illustration of hands using a tool to adjust a component, showing a circular component being rotated (no text or symbols present)

CAMPANA EXTRACTORA

Estimado cliente:

Thank you for buying our hood. Please read these instructions carefully for its optimum installation, use and maintenance.

Notes: The figures mentioned in this manual are in the first pages.

This hood is designed for fitting in a cabinet or on some other support.

Warning: consult local regulations regarding fumes outlets. Do not connect the hood to a fume, ventilation or hot air duct. Confirm that room ventilation is appropriate with the local authorities.

Make sure

the maximum air extraction flow rate for the appliances in the room does not exceed 4 Pa (0.04 mbar). The room must have adequate ventilation if an extractor hood is used simultaneously with appliances that run on gas or other fuels. The evacuated air must be extracted through ducts that are used for evacuating fumes from appliances that run on gas or other fuels. Regulations regarding air extraction must be complied with.

This product in intended for HOUSEHOLD USE only.

Use a rigid PVC pipe with a min. ∅ |20 mm to evacuate fumes outside.

The above restrictions do not apply to hoods with no fumes outlet to outside (recirculation system with activated charcoal filter).

Install the hood in line with the instructions on the template.

For gas cooking appliances only: the minimum distance to the hood must be at least 65 cm.

Warning: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.

INSTALLATION

The cooker hood is supplied with

3 Spacer (F, H)

4 Screws (C)

2 Bulbs

To fixing the Hood, use the 4 screws (C) ∅6mm supplied with the hood. Close the space that remains between the hood and the wall, adjusting the spacer (F).

Before completing any connection, make sure the house voltage corresponds with the voltage indicate on the data label.

Connecting the hood to the grid

Warning: before connecting the hood: switch off the electricity supply and check that the supplied voltage and frequency coincide with that indicated on the appliance nameplate.

If the extractor hood has a plug, connect it to a power socket in line with applicable regulations, located in an accessible area.

If the hood does not have a plug, connect it directly to the electrical grid, protected by a separator device accessible for disconnection, in line with local regulations.

The connection to the electrical mains must be made as follows:

BLUE....."N" NEUTRAL

BROWN....."L" LIVE

GREEN AND YELLOW.....(simbolo tierra) EARTH

If the terminals of the plug are unmarked or if you are in any doubt consult a qualified electrician.

If it is not supplied fit a plug normalized in the cord for the load showed on the rating plate.

USE OF THE HOOD – SAFETY

Warning: the hood may stop working during an electrostatic discharge (e.g. lightning). This involves no risk of damage. Switch off the electricity supply to the hood and reconnect after one e.

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

To avoid the risk of fire, clean the metal filter regularly, permanently control pans containing hot oil and do not flambé food underneath the hood.

Do not use the hood if it shows signs of damage or imperfection.

Contact an official distributor or authorised dealer.

Accessible parts may heat up when using cooking appliances.

Air Intake Speed (Fig 2)

The front panel has to be pulled its maximum extension so as to optimise the extraction capacity.

The three setting switch (C-2) has the following functions:

0 Stop

1 Low Speed

2 High Speed

Switch on the Lamps (C-1 Fig 2)

Pull out the grill (G) more than 50mm

SUCTION VERSION

If the hood is to be installed as a SUCTION hood, connect the plastic outlet piece (A) supplied with the hood (150mm diameter pipe for better performance and lower noise levels.

FILTERING VERSION (INTERNAL RE-CYCLING)

When there is no exhaust duct for venting out-door, you can use a carbon filter (D). The air is depurate by the filter and put again in the surrounding.

The air is released in the room through a connecting pipe, which goes through the hanging cupboard and us connected to the connecting ring supplied (A) Fig 1.

To use the appliance in this version, proceed as follows:

Open the grids (E)

To proceed to change the charcoal filter (D), the screw (B) has to be removed.

Reinstall the grids.

HOOD MAINTENANCE

Warning: always switch off the electricity supply before carrying out maintenance work on the hood. In the event of a fault, contact an official distributor or authorised dealer.

Exterior cleaning: use non-corrosive, liquid detergent and avoid the use of abrasive cleaning products.

Grease filters: to avoid fires, clean thoroughly once a month. To do so, remove the filters and wash with hot water and detergent. If using a dishwasher, position the filters vertically to prevent solid remains from depositing on them.

Activated charcoal filters: replace the every 2 months.

Important: increase the filter cleaning/replacement frequency if the hood is used for more than 2 hours a day. Always use genuine filters from the manufacturer.

Bulb replacement (look for the symbol in the figures)

Warning: do not handle the bulbs until the electricity supply has been switched off and they have cooled.

Important: use new bulbs according to that indicated on the hood nameplate.

Use bulbs with an aluminium reflector to replace halogen bulbs. Do use dichroic bulbs - risk of overheating.

On cooker hoods equipped with tungsten lamps, the lights should only be used during operation of the motor. They should not be left on permanently and used as a light source.

Legal information

The manufacturer:

- Declares that this product meets all basic requirements regarding low-voltage electrical equipment established in Directive 2006/95/EC of 12 December 2006 and electro-magnetic compatibility established in Directive 2004/108/EC of 15 December 2004.

- Is not responsible for any failure to observe the instructions given in this manual and current safety regulations for the correct use of the equipment.

- Reserves the right to make any modifications to the equipment or this manual without prior notice.

Contact our official distributor should you require technical assistance or additional information on our products.

CAPPADI ESTRAZIONE

Gentile Cliente:

MARRONE....."L" CON CORRENTE

VERDE E GIALLO.....(simbolo tierra) MESSA A TERRA

Coloque de novo as redes.