SMC2A - Car radio Memphis Audio - Free user manual and instructions

Product Type	Car Stereo
Brand	Memphis Audio
Model	SMC2A
Dimensions (W x H x D)	7.08 x 1.97 x 5.08 inches (180 x 50 x 129 mm)
Weight	1.1 lbs (0.5 kg)
Power Source	12V DC (negative ground)
Power Output (RMS)	20W x 4 channels
Peak Power Output	50W x 4 channels
Frequency Response	20 Hz - 20 kHz
Signal-to-Noise Ratio	≥ 65 dB
Tuner Bands	AM/FM
Audio Playback	CD, CD-R/RW, MP3, WMA
Input Connections	AUX (3.5 mm), USB, Front/Rear RCA
Output Connections	4-channel speaker outputs, 1 subwoofer pre-out
Bluetooth	Built-in (hands-free calling, audio streaming)
Display	LCD with white backlight
Detachable Faceplate	Yes
Equalizer	3-band equalizer (Bass, Treble, Mid)
Preset EQ Modes	Classic, Rock, Pop, Jazz, Flat
Clock Function	Yes, 12/24 hour format
Remote Control	Included (wired or IR, depending on model)
Mounting	DIN (Single-DIN) standard
Operating Temperature	-20°C to 60°C (-4°F to 140°F)
Maintenance	Clean faceplate with soft dry cloth; avoid liquids
Safety	Built-in fuse (10A), reverse polarity protection
Spare Parts	Faceplate, mounting sleeve, wiring harness (contact support)

Frequently Asked Questions - SMC2A Memphis Audio

How do I reset the Memphis Audio SMC2A car stereo?

Press the Reset button located on the front panel using a pointed object such as a pen tip. This restores factory settings.

Can I play music from my smartphone via Bluetooth?

Yes, the SMC2A supports Bluetooth audio streaming. Pair your smartphone by enabling Bluetooth and selecting the device from the phone's list.

What is the maximum USB drive capacity supported?

The stereo supports USB drives up to 32 GB formatted in FAT32.

How do I adjust the bass and treble?

Press the EQ button to access the equalizer menu. Use the volume knob or arrow buttons to adjust Bass, Treble, and Mid frequencies.

Does the unit have a detachable faceplate?

Yes, the faceplate is detachable for theft prevention. Press the Release button and pull it off.

The radio reception is poor. What can I do?

Check the antenna connection. Ensure the antenna is fully extended and not obstructed. You may need an external antenna amplifier.

How do I set the clock?

Press and hold the DISP button until the hour flashes. Use the volume knob to set the hour, press again to set minutes, and confirm.

What are the dimensions of the SMC2A?

The unit is a standard Single-DIN size: 7.08 x 1.97 x 5.08 inches (180 x 50 x 129 mm).

Can I connect an external amplifier?

Yes, the stereo has RCA preamp outputs (Front, Rear, and Subwoofer) for connecting external amplifiers.

How do I clean the faceplate?

Use a soft, dry cloth to gently wipe the faceplate. Do not use chemicals or abrasive materials.

USER MANUAL SMC2A Memphis Audio

Circular logo with stylized letter M in yellow and black on blue background (no text or symbols)

MEMPHIS

AUDIO SINCE 1965

Mobile phone displaying a MEMPHIS No. 1 interface alongside a black electronic device with cables and wiring (no visible text or symbols on main components)

SMC2A

APP CONTROLLED HIDEAWAY HEAD UNIT

SHOW US YOUR INSTALL

WWW.MEMPHISCARAUDIO.USA

@MEMPHISCARAUDIO

@MEMPHISCARAUDIOUSA

The Headless Unit

The SMC2A is an extremely innovative solution for creating a complete audio experience in your vehicle without the need to alter your vehicles dash to accommodate an aftermarket head unit. Much more than a simple Bluetooth controller, this is an entire head unit packed into a hideaway box. The SMC2A features a built-in 50x4 amplifier, 5 source options, and front /rear /subwoofer RCA outputs allowing you to build your entire system directly off the unit. The hideaway box is controlled via the Memphis APP allowing you to control your EQ, AM/FM presets, RGB LEDs and more. The attached wired remote fits in standard knock out locations but is not required. This is the ultimate for powersports, marine, hot rod and classic car audio integration where you don't want to alter the appearance of your dash.

Features

• 5 Source options: AUX, BT, AM/FM, Weatherband • RGB color source chart
  • USB Charging
• 50w x 4 built-in amplifier
• RGB LED control output
• Front/Rear/Subwoofer RCA output
  • 2.5-Volt preamp output
  • Conformal coated PCB IP66 rated
• Wired remote fits standard rocker switch cutout
• Wired remote w/ illuminating buttons

Color Source

Red FM

Yellow AM

Purple WB

Blue Bluetooth

Green AUX

App Controls The Following

• RGB Settings
• Custom EQ settings
  • Balance, fade
  • AM/FM Preset Control
• Radio search settings
• Manual/Seek/Presets

Warranty

Electronics limited warranty (including Memphis accessories) When purchased from an Authorized Memphis Dealer, Memphis warrants this product to be free from defects in material and workmanship under normal use for a period of ONE (1) YEAR from date of original purchase (receipt required), THREE (3) YEARS years if installed by an authorized Memphis dealer (receipt required). If this product is identified as "Refurbished" or "B Goods", the warranty is limited to a period of THREE (3) MONTHS from date of original purchase. In all cases you must have the original receipt. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction during the warranty period, Memphis will repair or replace (at its discretion) the defective merchandise with equivalent merchandise. Warranty replacements may have cosmetic scratches and blemishes. Discontinued products may be replaced with more current equivalent products. Warranty is valid only for the original purchaser and is not extended to owners of the product subsequent to the original purchaser. Any applicable implied warranties are limited in duration to a period of the express warranty as provided herein beginning with the date of the original purchase at retail, and no warranties, whether express or implied, shall apply to this product thereafter. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet or a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the part responsible for

Compliance could void the user's authority to operate the equipment.

FCC Radiation Exposure Statement

This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Wiring Overview

1. Front Outputs
2. Rear Outputs
3. Subwoofer Outputs
4. USB For Charging
5. Antenna Input
6. Power/Audio Outputs
7. Line Input
8. RGB LED Output

9. Remote Control 1

10. In-Line 15A Fuse and Fuse Holder

11. Remote Control 2

POWER/AUDIO OUTPUTS

Red// 12V+ Ignition

Black // Ground

Blue // Remote Turn On

Yellow // B+ Battery

White & Black // Left Front Speaker (-)

White // Left Front Speaker (+)

Grey & Black // Right Front Speaker (-)

Grey // Right Front Speaker (+)

Green & Black // Left Rear Speaker [-]

Green // Left Rear Speaker (+)

Purple & Black // Right Rear Speaker (-)

Purple // Right Rear Speaker (+)

Dimensions

*Note: Mounting depth is 90mm but room is required for wires and connections. Check available depth prior to mounting. Measure before cutting and be certain you will not be drilling into any items that will damage your vehicle.

Button Function

Wired remote control is optional and is not required to use the SMC2A. This unit fits into standard rocker switch knockout locations.

CONTROLS

1. Short Press: Change Source // Long Press: Power Down Device
2. Play/Pause
3. Volume knob Down/Up// Short Press:Play/Pause
4. Track Skip

Downloading Memphis App

The Memphis App is available on iOS & Android in the app store. Search for "MEMPHIS RADIO" and locate the MEMPHIS RADIO App. Download and install the app to begin controlling your SMC2A.

Bluetooth Pairing (Audio Streaming Only)

When unit is powered on, search for Bluetooth Devices. Look for SMC2A on your Bluetooth Device. Select this device to pair with the SMC2A unit. When connected via Bluetooth you can stream music to your SMC2A unit.

Bluetooth Pairing The APP

To control you SMC2A units settings and radio stations via the MEMPHIS RADIO App, you must establish a Bluetooth connection using the MEMPHIS RADIO App. Open the BLUETOOTH SETTINGS menu on the MEMPHIS RADIO App and follow the instructions on the next page to pair your MEMPHIS RADIO App with you SMC2A unit.

App Instructions

Main Menu/Source Selection

Settings

1. Adjust volume, fade, balance
2. EQ settings Menu
3. Bluetooth configuration
4. Adjust LED color settings
5. Restore Default settings
6. App version information

Bluetooth Settings Menu

Use this menu to connect your MEMPHIS RADIO App via Bluetooth to your SMC2A unit. This connection allows the MEMPHIS RADIO App to control your SMC2A. You should only have to make this connection once to pair the MEMPHIS RADIO App to the SMC2A.
1. Connect/Disconnect Bluetooth
2. Select SMC2A(BLE) to pair your Bluetooth Device with the SMC2A.

App Instructions Continued

Volume/Fade/Balance Menu

1. Volume slider adjusts volume of system. Volume level is indicated in the box above slider.

2. Fade/Balance Adjuster: Adjust the fade/balance of your system by positioning the center of the slider to the location that best fits your listening needs. You can also top the Front/Rear/Left/Right "+" icons to increase the level by +1 in the desired direction.

3. Reset the screen to the factory default settings.

EQ Settings Menu

1. EQ Preset options. Top arrows to toggle through presets settings.

2. Manually adjust EQ settings. Slide the band you wish to adjust into the desired position. Desired EQ setting will be saved as "Custom Setting"

3. Restore to the factory default settings

LED COLOR SETTINGS MENU

1. Turns the connected RGB LED Lighting on/off
2. Lighting color cycle on/off
   Light button system RGB LED color cycle
3. Use the wheel to select your systems RGB LED color. Touch the wheel and slide the indicator point to the desired color.
4. You can use the RGB sliders to dial in a specific color value. Adjust Red, Green and Blue individually until you've reached your desired color.
5. You can adjust the brightness using the slider.

AM/FM/WB Source Screen

1. Indicates current radio station
2. Select radio preset category (FM1, FM2, FM3, AM1, AM2, AM3 allows you to store 3 stations in each preset category)
3. Presets 1-6. Use Seek/manual tuning to locate desired station. Press and hold desired preset button for several seconds to save station as a preset.
4. Puts unit into SEEK mode. Arrows will now seek for the next station.
5. Puts unit into PRESET mode. Tapping Left or Right arrows skips to the next programmed preset station.
6. Puts unit into MANUAL TUNER mode. The arrows will now manually tune to the next station.
7. Changes to the next available station. Select SEEK or MANUAL above to change the way the system locates the next station.
8. Adjusts volume of the unit

SHOW US YOUR INSTALL

WWW.MEMPHISCARAUDIO.USA

@MEMPHISCARAUDIO

@MEMPHISCARAUDIOUSA

Abstract geometric logo with orange and black letter M inside a circle (no text or symbols)

CONTACT INFO

122 GAYOSO AVE MEMPHIS, TN USA 38101 TECH SUPPORT 800-903-6979