UDD-3-HC - Beer dispenser Avantco - Free user manual and instructions
Find the device manual for free UDD-3-HC Avantco in PDF.
Pick your language and provide your email: we'll send you a specifically translated version.
| Product Type | Beer Dispenser |
| Brand | Avantco |
| Model | UDD-3-HC |
| Number of Faucets | 3 |
| Dimensions (W x D x H) | 24" x 21" x 24" |
| Weight | 55 lbs |
| Power Supply | 115V, 60Hz, 1.5A |
| Refrigerant | R290 (environmentally friendly) |
| Temperature Range | 34°F - 40°F |
| Cooling Type | Forced air |
| Drip Tray Material | Stainless steel |
| Tower Material | Stainless steel |
| Faucet Type | Standard beer faucet (¾" shank) |
| Max Keg Capacity | 3 quarter-barrel kegs |
| Cleaning Frequency | Every 2 weeks |
| Cleaning Method | Use a mild detergent and warm water; rinse thoroughly |
| Safety Features | Grounded plug, overload protection, thermostat |
| Replacement Parts Available | Yes (faucets, drip tray, tower, gaskets) |
| Warranty | 1 year parts and labor |
| Intended Use | Commercial |
Frequently Asked Questions - UDD-3-HC Avantco
How do I clean the beer lines?
Use a line cleaning kit with a mild cleaning solution. Disconnect the keg, attach the kit, and flush the lines with warm water after.
What is the ideal serving temperature?
Set the thermostat between 34°F and 40°F for optimal carbonation and taste.
How do I adjust the temperature?
Locate the thermostat dial inside the unit. Turn clockwise for colder, counterclockwise for warmer. Allow 24 hours for stabilization.
Why is the beer foamy?
Possible causes: line too warm, incorrect CO2 pressure, or dirty lines. Ensure temperature and pressure are set correctly (12-14 psi typical).
Can I use this dispenser for wine?
No, this unit is designed specifically for beer. Wine requires different temperature and pressure settings.
How often should I defrost the unit?
Defrost when ice buildup exceeds 1/4 inch. Typically every 3-6 months depending on usage.
What type of kegs fit?
Standard quarter-barrel (7.75 gallon) kegs. Full-size kegs may not fit due to height.
How do I replace a faucet?
Turn off the CO2, remove the retaining nut, pull out the old faucet, and install the new one. Ensure a tight seal with PTFE tape on threads.
The unit is not cooling. What should I check?
Check power cord, thermostat setting, and ensure the condenser coil is clean. If still not cooling, contact Avantco service.
Where can I find replacement parts?
Contact Avantco or an authorized dealer. Parts like faucets, drip trays, and gaskets are commonly stocked.
User questions about UDD-3-HC Avantco
0 question about this device. Answer the ones you know or ask your own.
Ask a new question about this device
No questions yet. Be the first to ask one.
Download the instructions for your Beer dispenser in PDF format for free! Find your manual UDD-3-HC - Avantco and take your electronic device back in hand. On this page are published all the documents necessary for the use of your device. UDD-3-HC by Avantco.
